Question about Cars & Trucks

Open Question

2014 wolf rx50 ignation switch recived a 4 wire switch can it be re wired to a 5 wire plug in

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

redbeard00
  • 957 Answers

SOURCE: Misfire on 4, 5 & 6

Take your time, if its been awhile do a complete tune-up. and preliminary check a misfire can come from a defective cap and rotor, fuel and air filter. a leak in the fuel system or defective regulator.

Posted on Apr 28, 2009

lasvegasrich
  • 65 Answers

SOURCE: need wiring diagram for ford ranger ignation

94294ce.jpgcdd4395.jpg59fd4fd.jpg864b8c8.jpg9fbec96.jpgecd8648.jpg00be6e4.jpghere this help?

Posted on Aug 28, 2009

sscullys
  • 984 Answers

SOURCE: I have a ford factory wiring plug with 5 wires, I

If you are talking about the trailer brake pigtail under the dash, the brown wire is for the illumination on the brake controller, if applicable.

0fa42f2.jpg

My reese hand held controller did not use this, so I just blind end tapped it into the harness.
If your brake controller does not have background illumination, then you don't need the brown wire.
Sounds like the controller is similar.

Posted on Nov 16, 2009

Testimonial: "I have to tell you, I was having a brain fart when I posted that problem and I did excactly what you did after I thought about it. Thanks"

  • 507 Answers

SOURCE: factory 5 wire trailer wiring to a 4 wire flat plug

there are premade kits that will automaticaly go from 5 round to four flat connection.

Posted on Jan 24, 2010

  • 121 Answers

SOURCE: Have 4 prong trailer plug with 5 wires how to hook

all colors will hook up the same, however that last wire probably blue, will not go to anything, that is for trailer brakes, if your vehicle isn't equiped with a controller then dont' worry about it, other wise you can always buy adapters from just about anywhere even home depot or walmart

Posted on Jun 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2014 dodge advenger radio wiring harness diagram


2014 Dodge Avenger Car Audio Wiring Diagram
Car Radio Battery Constant 12V+ Wire: Red/Brown
Car Radio Accessory Switched 12V+ Wire: N/A
Car Radio Ground Wire: Black
C

Car Radio Antenna Trigger Wire: Gray/Orange
Car Audio Front Tweeter Size: 2-1/2? Tweeters
Car Audio Front Tweeter Depth: 5?

Car Audio Front Speakers Size: 6? x 9? Speakers
Car Audio Front Speakers Depth: 4?
Left Rear Speaker Positive Wire (+): Dark Green/Tan
Left Rear Speaker Negative Wire (-): Dark Green/Gray
Right Rear Speaker Positive Wire (+): Dark Green/Brown
Right Rear Speaker Negative Wire (-): Yellow/Gray
Car Audio Rear Speakers Size: 6? x 9? Speakers
Car Audio Rear Speakers Depth: 4?

May 18, 2016 | Dodge Cars & Trucks

1 Answer

Where are the speaker wire tie-in in the trunk for after market subs on a 2014 Lancer Evolution MR?


the car company do not put aftermarket wires in anything , they are called aftermarket because someone put them in there after the car was bought, most likely they are not in there , if the 4 wires are green or blue and 2 black ones they may be speaker wires but my guess is theta they are for a option from the factory add on light a set of extra lights or for a tow package , good luck

May 07, 2014 | Cars & Trucks

1 Answer

Cylinder 4 misefire


That leaves the valves and the injector.
If you have normal compression, I would aim for the injector being bad.

Feb 17, 2014 | Mercury Villager Cars & Trucks

1 Answer

No ignation on plug wire . have no Ignition


Assuming this is on a ram 50 with a 2.4l mitsubiishi engine? No spark on only one cylinder or all cylinders?

Oct 09, 2013 | 1988 Dodge Ram 50

1 Answer

98 s-10 won't reliabliy start new gas tank 2 fuel pumps , fuel filter,relay,ignation module, ignation coil ,5 crank sensors .yesterday I started out 5 am. weather cool60 started & stopped 4 times no...


I experienced a similar problem on a customers 98 S-10. After much research and probing of electrical wiring, it was a faulty ignition switch. This may not be your problem but it might also? Read on it and test it by hooking a test light to the output side after the switch and if the light dies out when it dies, there is your problem. Here is a tip. Put a fuel pressure gage on the vehicle, route it up under the windshield wiper so you can see it, next hook up a timing light to any ignition wire, run the cords so you can have the light in the vehicle (so you can see it flashing not to set timing) drive the truck and as it dies what quits? Fuel pressure or ignition? At least you know what direction to look further into.

Sep 05, 2013 | Cars & Trucks

1 Answer

Ford windstar p0320 code


this code indacates that (2) successive erracit profile ignation pulses have occurred.possable causes are:

short circuit to ground in the secondery ignation circuit ( spark plug wires )

Aug 03, 2011 | 1995 Ford Windstar

1 Answer

P0320


this code indacates that (2) successive erracit profile ignation pulses have occurred.possable causes are:

short circuit to ground in the secondery ignation circuit ( spark plug wires )....god luck

Aug 03, 2011 | 1995 Ford Windstar

2 Answers

Volvo 960 missing ciylinder


I would be doing a compression test as well.

Jun 28, 2009 | 1996 Volvo 960

1 Answer

How to bypass ignation on a saturan ls200 year is 2000


Get another switch for the saturn "they should come with the wires already attached" and unplug the old one at the wiring loom under the dash and then plug in the new one and start it with the new switch without having to disamble the steering column just to move the car. Then you can get the broken key out or replace the switch at your leisure. 

May 04, 2009 | 2000 Saturn Ls 4dr Sedan

1 Answer

Bmw e30 325i convertiable d reg 1987


If you can not find the problem is, maybe you can wire directly from your fuse box 12v to your radio hot wire, and use your radio switch turn on and off, omit the ignation switch.

May 26, 2008 | 2001 BMW 325

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...