Question about Cars & Trucks

Open Question

What is the next question for Eng 1501 for may 5 2017?

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How many eng. Sensors on a 2000 GMC safari 4.3L Replaced mass air flow crankshaft sensor and ck eng. Lite still on. What's next O2 sensor? Thanks

Have it scanned so we can try to pinpoint the issue before you spend money on a nonissue. Codes can direct you to the circuit or sensor problem.

Nov 15, 2015 | GMC Cars & Trucks

1 Answer

How to purge air from the radiator

normally the radiator will purge itself as long as the overflow jug remains at the recommended level. warm eng to normal operating temp if you have no leaks it should draw water as needed from the overflow jug when you shut the eng off .. it may take a few times of starting and stopping eng but this method does work.. careful as the radiator fluid is very HOT !!! if no overflow jug is in your system go to highest rad. hose and open the system there.only do this when eng is cool. slowly fill radiator at the cap holding the hose you remove higher than the cap. a helper is needed for this procedure. starting at btm rad hose gently squeeze entire length of hose working your way to the next lowest hose do the same procedure for each hose. heater hoses also need be done reattach hose start eng let idle till normal operatin temp is reached turn heater to full heat . let eng cool then chk level of rad. repeat as needed. good luck .TIP : be patient .

Jul 12, 2014 | 2002 Pontiac Aztek

1 Answer

My lower rad hose blew off and eng.heated.I let veh cool down nd restarted it and eng. sounded fine so i put hose back on and replaced t-stat and filledf with coolant. I then went to start the eng. to let...

How to check if its a head gasket failure: Fill all holes in rad and pipes so the coolant stays in. When it has cooled, take of the coolant filler cap and watch the coolant when you start the car. If bubbles are coming up and can be seen when you look in the coolant filler, the head gasket has gone.

Dec 20, 2013 | 1996 Honda Accord

1 Answer

2003 Galant service eng light comes on, show random misfire. replaces plugs, wires, dist cap. did not solve issue. ck eng light keeps coming on. what is the next step?

Usually, a randon cylinder misfire is caused by the igntion coil. I did not see in your question where you replaced this.

Jan 07, 2011 | 2003 Mitsubishi Galant

1 Answer

Chk eng, abs and tract /control light remain on

A blown fuse in the Maxi Fuse Relay section labeled ABS Motor or one next to it ABS Cntrl. I thnk that names. But ABS for sure. Thats what mine was. one or other. Big fuse 40 amp. Check all vacuum hoses and wire conections for check eng. Or go autozone they tell u for free

Feb 02, 2010 | 1997 Oldsmobile Regency

1 Answer

I have a 1997 Ford Explorer, AWD, 5.0 eng. Acts

There is a TSB reference number 96-26-12 for torque converter replacement

Oct 08, 2009 | 1997 Ford Explorer AWD

1 Answer

The eng. Run Great ,no problems until the Eng. warms a bit sometimes this only takes a fesw min.then it runs rough for a few min. then it dies and wont start back. till the next day. the problem began...

ign. module needs replacement.Very common problem.Be sure that you use the dielectric grease on thenew part,also do not wipe off the old grease completly just smooth it out.

Jul 26, 2009 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides