Question about 2003 Dodge Neon

1 Answer

CHECK ENGINE LIGHT ON

MY CAR'S CHECK ENGINE LIGHT COMES ON AND OFF. I KNOW ITS AN INSTRUMENT CLUSTER FAILURE BUT HOW DO I FIX IT? WHAT DO I DO FIRST.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 87 Answers

First go to the bank. Usually the instrument cluster is controlled by a circuit board that is replaced by removing the dash, steering column and air bags which are dangerous to fool with. Any yellow wiring is air bag related so watch out.

Posted on Jul 24, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

When I start my 2004 Mercury Mountaineer the check engine light flashes the battery light comes on and won't turn off the oil gauge seems to be rising in the battery gauge seems to be going lower.


Probably,factory installed alternator has failed and vehivle is only using battery power.Suggestion:Start engine and check available voltage at battery with DVOM.SHOULD be 13.9 volts minimum and about 14.5 max.if not in range listed.please have alternator checked for failure.

Apr 21, 2016 | Mercury Cars & Trucks

1 Answer

I have a 2001 mustang bullitt that is showing service engine light on. Took it to mechanic and he put 2 different machines on it to show code for problem. No codes coming up and he can't turn off the...


There is a diagnostic procedure in the factory service repair manual for engine light lit ,no codes . Did you take it to ford dealer ? MIL - is referring to check engine , service engine soon etc...
  • MIL always on when engine is running (no DTCs):
  • MIL circuits
  • For Focus, Mustang, Town Car, Continental, LS6/LS8, Escape, Windstar, F-150, Expedition and Navigator/Blackwood:
  • Instrument Cluster, Section 413-01 of the Workshop Manual.
  • All Others:
  • GO to NB1

SERVICE ENGINE SOON indicator After the engine is started, the SERVICE ENGINE SOON indicator will prove out for a duration of three seconds. If the instrument cluster does not receive a message from the PCM within five seconds, the instrument cluster will illuminate the SERVICE ENGINE SOON indicator and log a diagnostic trouble code (DTC).

  • An indicator is inoperative/always on - SERVICE ENGINE SOON
  • Circuitry.
  • Bulb.
  • Instrument cluster.
  • PCM.
  • GO to Pinpoint Test P .

PINPOINT TEST P: AN INDICATOR IS INOPERATIVE/ALWAYS ON - SERVICE ENGINE SOON CONDITIONS DETAILS/RESULTS/ACTIONS P1 CARRY OUT THE INSTRUMENT CLUSTER SERVICE ENGINE SOON INDICATOR ACTIVE COMMAND Trigger the HEC active command MIL.
  • Did the SERVICE ENGINE SOON indicator illuminate?
Yes REFER to Powertrain Control/Emissions Diagnosis (PC/ED) manual.

No INSTALL a new instrument cluster; REFER to Instrument Cluster . CLEAR the DTCs. REPEAT the self-test.

Jul 18, 2017 | 2001 Ford Mustang

1 Answer

Gem module


The GEM has nothing to do with it !
Odometer/Trip Odometer
The odometer and trip odometer are displayed in the integrated circuit LCD display. The instrument cluster records the total mileage of the vehicle using information received from the PCM, and electronically displays this information in the LCD. If this information is not received, the LCD displays all dashes. How did you prove that instrument cluster isn't bad ?
Did you have a factory scan tool hooked up , check for DTC'S - diagnostic trouble code's ? View data to the instrument cluster etc...
Instrument Cluster Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1202 Fuel Sender Circuit Open Instrument cluster Go To Pinpoint Test B . B1204 Fuel Sender Circuit Short to Ground Instrument cluster Go To Pinpoint Test B . B1205 EIC Switch-1 Assembly Circuit Failure Instrument cluster INSTALL a new instrument cluster. REFER to Instrument Cluster in this section. TEST the system for normal operation. B1342 Instrument Cluster Is Defective Instrument cluster CLEAR the DTCs. REPEAT the self-test. If DTC B1342 is present, INSTALL a new instrument cluster. REFER to Instrument Cluster in this section. TEST the system for normal operation. B1359 Ignition Run/ACC Circuit Failure Instrument cluster Go To Pinpoint Test A . B1317 Battery Voltage High Instrument cluster Go To Pinpoint Test N . B1318 Battery Voltage Low Instrument cluster Go To Pinpoint Test N . U2199 Invalid Data for Engine Coolant Instrument cluster Go To Pinpoint Test D .
Your best bet ,take it to a qualified repair shop.
  • The speedometer/odometer is inoperative
  • Powertrain control module (PCM).
  • Instrument cluster.
  • Go To Pinpoint Test F .

Dec 04, 2017 | 2005 Ford Focus

1 Answer

Tranmission and instrument cluster


The speed sensor on your trans sends a signal to the electronics telling it when to shift, this will be where you fault is.

Mar 05, 2012 | 2001 GMC Yukon XL

1 Answer

Have code 0463 fuel levelcircut input high what do I look for


There is no module under the dash on your vehicle .
P0463 - Fuel Level Sensor A Circuit High Description: The powertrain control module (PCM) monitors the fuel level input (FLI) circuit for electrical failure. The test fails when the signal moves above the maximum allowable calibrated parameter for a specified fuel fill percentage in the fuel tank. Possible Causes:
  • Fuel pump (FP) module concern
  • Incorrectly installed fuel gauge
  • Damaged instrument cluster
  • FLI shorted to VPWR
  • CASE GND circuit open
  • Overfilled fuel tank
  • Damaged fuel gauge
Diagnostic Aids: See the diagnostic aids for DTC P0460. Application Key On Engine Off Key On Engine Running Continuous Memory Ranger GO to Pinpoint Test HX . All others Refer to the Workshop Manual Section 413-01, Instrument Cluster for fuel level indicator diagnosis.
You start by taking to Dealer or someother qualified repair shop .
Instrument Cluster Diagnostic Trouble Code (DTC) Index DTC Description Source Action B1202 Fuel Sender Circuit Open Instrument Cluster Go To Pinpoint Test B . B1204 Fuel Sender Circuit Short to Ground Instrument Cluster Go To Pinpoint Test B .

Aug 02, 2017 | 2006 Ford Taurus

1 Answer

I have a 1999 pontiac sun fire when I am driving sometimes my speedometer works and then it drops off do you know a fix.


does the check engine light come when this happens some vehicles when the speedometer stops working then the check light comes on does the engine change in the way it runs either at cruise or accelerating then this indicates a speed sensor in the transmission has an intermintant problem if there is no check engine light or change in the way the car runs then it is possible the problem is in the speedometer head or connections at the instrument cluster for the speedometer if the light is on then you need to have the computer checked to see if a code is set for the sensor,if so then that is probably were the problem is keep in mind it can also be a poor connection at the sensor,if this not were the problem is then it probably is in the cluster for the speedometer head or the speedometer head itself

Mar 02, 2011 | 1999 Pontiac Sunfire

1 Answer

CHECK ENGINE LIGHT , ABS LIGHT STAYS ON


ck engine light,,depends on what side of instrument cluster the light on,,one for engine & ones for other system failure ,,abs light on mean that ur abs is in op,,if u have a chance to take ur car to advance auto or auto zone,,they can scan ur car for free & let u know whats wrong,,hoped it helped

Apr 18, 2010 | 1997 Pontiac Grand Am

2 Answers

Beeping


When you turn key on check if airbag light on instrument cluster comes on. 5 beeps is the tone to let you know your airbag light in instrument cluster is inop..

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/terry_db4da071b7da3ac1

Sep 03, 2008 | 2003 Ford Escape

Not finding what you are looking for?
2003 Dodge Neon Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...