Question about Nissan Cars & Trucks

Open Question

Where do I find the computer on a Nissan terrano 1996 2.7 tdi

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1201 Answers

SOURCE: firing order for nissan terrano vg33 engine 1996

If it's the vg33e engine--- it's 123456 in a counter clockwise rotation.

Posted on Jan 24, 2009

  • 1 Answer

SOURCE: heater plugs for nissan terrano 2

i have a nissan terrano 2.7 dti heater light not coming on some times dose and some times does'nt and it wont start

Posted on Mar 20, 2010

charleshucke
  • 1114 Answers

SOURCE: how do remove the centre

Take the wheel off. then the grease cap. There will be a keeper that has 2 screws, take those out, then remove the keeper. You will see another keeper, but this one is actually a nut. There are two round holes on the keeper, take a punch, or a common screwdriver, and a hammer and tap it off. If will spin. Make sure that you keep these parts free of dirt, as the wheel bearing will pick it up and ruin it. Once you have these removed, then the wheel assembly will slide right off. When you are installing them make sure that you have seated the wheel unit on before you thread the nut on. Tighten the nut as far as you can using a screwdriver to spin it on, and then tap it tight with the screwdriver and hammer, make sure that you do not get it too tight, or you will cause the bearing to wear prematurely.

Posted on Mar 19, 2011

  • 33 Answers

SOURCE: Hi! i have my nissan

It's good to have the rotors turned when you replace your brake pads. It should not cost too much. And it keeps the new pads from wearing down so fast.

Posted on Apr 25, 2011

jmacn1
  • 58 Answers

SOURCE: nissan terrano 1996 2.7 diesel

The sensor is located behind the crank pulley/harmonic dampener. To replace:

1 Remove the tire/wheel and splash shield.
2 Remove the bolts, then loosen the mount bolt and pivot the side engine mount out of the way.
3 Loosen the idler pulley center nut and adjusting bolt, then remove the A/C compressor belt.
4 Loosen the alternator mounting bolt, nut and adjusting bolt, then remove the alternator belt.
5 Loosen the mounting nuts and adjusting nut, then remove the P/S pump belt.
6 Remove the dipstick and pipe.
7 Remove the crankshaft pulley.
8 Remove the upper covers and lower cover. NOTE: Do not use the upper and lower covers for storing removed items.
9 Remove the CKP sensor from the cylinder block.
10 Install the CKP sensor in reverse order of removal.

Posted on Feb 23, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi. Could you tell me which fuse controls the electric aerial. Nissan terrano ll 1996 import.


typically the fuze is under the hood. It is a inline fuze attached to the antenna motor.. I may be hidden under the fender, so find the motor for the antenna and follow the wires till you come upon the fuze holder. It comes apart with a twist, be sure to replace with the same value fuze. 2 amp usually. It has been my experience that these fuzes blow because of a short in the wiring or a short in the motor itself. so if your replacement fuze blows right after you put it in, you have more than a fuze problem.

Mar 03, 2015 | Nissan Cars & Trucks

1 Answer

Nissan oil capacity


With or without a filter? Have you lost the dipstick? Fill it to the full mark, about 6 liters without filter, plus 1 litre to fill the oil filter. Run engine then check levels again. Try not to overfill the sump.

Jul 08, 2014 | 1999 Nissan Terrano

1 Answer

How to get the abs light to go out on a 1996 nissan terrano


Get the ABS system fixed, that usually turns the light off. Get the computer scanned for the fault codes and work from there.

May 19, 2014 | 1999 Nissan Terrano

1 Answer

How to disable abs light


I hope you are not serious.

If you are, please send me an updated spreadsheet of where and when you will be driving on a public road so I can stay home and out of your way.

When you crash the least you will be liable for is reckless driving, the most: probably will be reckless driving causing death.

Fix the ABS...

May 19, 2014 | 1999 Nissan Terrano

1 Answer

Shutdown and turn on again


please RUN the scanner/computer for easy diagnostic. You can have some Ignition Coil+cables+sparkplug+sensor,+PCM or BCM+ etc, faulty.
see the diagram.
God bless you106cb690-9c9e-4147-b8a0-d15a0745099d.jpg

Jul 09, 2013 | 2005 Nissan Terrano 2.7

1 Answer

How much transmission fluid to put in nissan terrano 1996


useless question without the details. Year?Engine size?Transmission type?
check this link and find your car for details. It's a quick google search. Hope it helps.
http://carsmind.com/specification.php?make=NISSAN&model=Terrano

Feb 02, 2013 | Cars & Trucks

1 Answer

Hi! i have my nissan terrano 2004 model 2.7 tdi, my problem i don't know if its in my disk pad or in my rotor disk co'z when aim in the road my break is noisy i replace it several times but it comes...


It's good to have the rotors turned when you replace your brake pads. It should not cost too much. And it keeps the new pads from wearing down so fast.

Apr 25, 2011 | Nissan Pathfinder Cars & Trucks

1 Answer

My Nissan terrano 1996 2.7 diesel engine would, every so often die on me and would take several turns before it would start again, I have replaced fuel filter + housing with brand new parts and that seemed...


I just had the computer on my Terrano rebooted, which seems to have solved the problem with it 'die'-ing and surging. One of the local Auto Electrical places sorted it.

Dec 27, 2010 | 1996 Nissan Pathfinder

1 Answer

What is the fuel consumption of nissan terrano 96 model manual trans? are terranos turbo charge?


This is all info that can be found on edmunds.com or msn auto.very simple stuff

Nov 29, 2009 | 1996 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...