Question about Cars & Trucks

Open Question

Do I have to factory order a new cig lighter for my 05 pt cruiser? Isn't there a way to go around it?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 60 Answers

SOURCE: my 2002 pt cruiser lost power steering suddenly

check to see if the serpantine belt is still there. It sounds like like it broke. this belt runs all of the accesories on the vehicle including the water pump. So if this happened it probably starting running hot too

Posted on Jun 23, 2009

  • 615 Answers

SOURCE: '05 PT Cruiser O2 sensor problems.

I had a similar problem with my car. It turned out the O2 sensors were fine and the issue was a leak in the throttle body causing the engine to run lean. If you have an ODB2 scanner you can look at fuel trims, etc and will be able to tell.

Posted on Mar 28, 2010

  • 5 Answers

SOURCE: 2001 PT Cruiser: How too remove crankshaft pulley 2001 PT Cruiser...

GET A 3 SPOKE PULLEY EXTRACTOR AND SCREW IN THE BOLT BUT IN THE CRANKSHAFT HOLE PUT A MUCH SMALLER SCEW SO YOU WOUNT MESS THE INSIDE UP

Posted on May 26, 2010

  • 41 Answers

SOURCE: What does a "circle around

that is the symbol for tire pressure monitoring system.it monitors tire pressures.check all tires pressures and fill to the recommended pressure listed on the drivers door sill area.light should go out after.if not you may have a faulty tire pressure sensor.

Posted on Nov 25, 2010

  • 1915 Answers

SOURCE: 05 pt cruiser turbo.oil is

It is getting into your exhaust manifold-the return line is either restricted or blocked, or the oil seal inside the turbo housing is either leaking or blown, usually due to excessive crankcase pressure.Try disconnecting the oil feed and return lines first, clean them out, and try it again-if it is still there, the turbo will have to come out and it will have to be gone over for blown seals.

Posted on Aug 17, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the ECM located?


How To Change The PCM On A Chrysler PT Cruiser ...

? 14:05
https://www.youtube.com/watch?v=fLN48sAKpiE
Jul 24, 2014 - Uploaded by The Hapless Housewife
How To Change The PCM On A Chrysler PT Cruiser ... things wrong with my car now, but had I replaced the PCM (aka) ECM a long time ago, ...

Chrysler PT Cruiser Engine Computer Module ECM PCM ...

www.ebay.com > ... > Engine Computers

eBay
$169.00 - ‎In stock
Chrysler PT CRUISER Engine Computer Module ECM PCM ECU - "Plug & Play" in eBay Motors, Parts & Accessories, Car & Truck Parts ' eBay.

Chrysler PT Cruiser Engine Computer



Dec 30, 2015 | 2002 Chrysler PT Cruiser

1 Answer

Timing alignment marks


Timming for 2.4 avenger

Jan 14, 2014 | 2009 Chrysler PT Cruiser

1 Answer

Radio, horn cig lighter not working, fuse good


Possibly a bad ignition lock cylinder or bad ignition switch.

Sep 18, 2013 | 2001 Chrysler PT Cruiser

1 Answer

Lighter in 2002 pt cruiser not working


Could be the lighter element, the socket, or the fuse.

Sep 29, 2012 | 2002 Chrysler PT Cruiser

1 Answer

Replacing 2004 PT Cruiser Turbo battery


there is a metal bar holding the battery on my 05 pt cruiser, how doi remove it

Jan 20, 2012 | 2004 Chrysler PT Cruiser

1 Answer

Cigarette lighter aren't working in 2002 pt cruiser


Usually a 30 amp fuse is the culprit in this case.
Fuse is usually under the dash.

If fuse is good...then, I'd check the back of lighter socket to see if we have voltage.
If we do...then you have bad element in lighter itself.

Hope this helps...

Jul 23, 2011 | 2002 Chrysler PT Cruiser

1 Answer

Why cigarette lighter does not work?


80 Series cig lighters have a fuse and a thermal couple, as do most cig lighters. The fuse will blow if too much current is drawn but if an acceptable but high current is drawn for a long period the thermal couple may blow.
Note: the thermal couple can not be replaced like a fuse.

Dec 16, 2010 | 1991 Toyota Land Cruiser

1 Answer

When tun on the a/c to my 05 pt cruiser it doesnt


This is because the engine does not accelerate and the RPM falls below the minimum the PCM is in charge of sending a signal for the engine to increase the RPM.Thanks

Feb 27, 2010 | 2005 Chrysler PT Cruiser

2 Answers

2000 Buick Century lighter fuse blows when TomTom plugged in.


this is the cigar lighter receptacle causing the problem, take my word on this.

Aug 17, 2009 | 2000 Buick Century

2 Answers

CIGARETTE LIGHTER


It could be as simple as a blown fuse, could also be a bad socket or bad connections.

Jul 23, 2008 | 2006 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...