Question about Nissan Cars & Trucks

Open Question

What would make a 1995 Nissan maxima have a cut back while driving and motor cut off if I move the wires to the maf sensor

If I start the car an let it ldle it will idle until i shake the maf sensor wire connector then it will shut off.i tried unplugging the connector while car ldles an it still runs

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

3dmaster
  • 183 Answers

SOURCE: Idle problem

Yes you can,

do this with your RPM setting,

you ahve to just set you engine race settings,

try & having funn with your car,

THNX

Posted on May 18, 2008

SOURCE: 2000 nissan sentra

You prpbably need a new ECM/computer. Nissan had a problem with the ECM box and the foam inside the box. The glue, which Nissan used to attach the foam onto the box EATS up your computer internaly. The vapors from the glue it self damage the ECM/computer. Nissan actually has a campaign to remove the foams out of the ECM box. By the way ECM has 80000 mile warantee, so if your car has less than that, Nissan will replace it for free. I see it all the time. Sentra with heater circuit code
needs an ECM 95% of the time.

Posted on Jul 17, 2008

  • 1 Answer

SOURCE: 1995 nissan maxima cuts off while driving

Check your battery terminals, if they're corroded replace them. That did it when I was having this problem.

Posted on Jan 06, 2009

  • 1 Answer

SOURCE: car is stalling and idleing irradically.

I Would Suggest That You Complete A Engine Cylinder Leak Down Test.....(not A Compression Test But A Leak Down Test) this will tell you if you have internal problems....possible worn rings or a burnt valve(s) I would use a smoke machine to check for vacuum leaks also. Good Luck

Posted on Mar 26, 2009

  • 82 Answers

SOURCE: 1996 Nissan Maxima oxygen sensor

hye there ,,there are 3   o2 sensors on your car,,one for each bank,,,and the 3rd sensor is located after the cat this one usually goes first,,,,just make sure you no if your cars an import or not as they can be different,,,then you should be safe when ordering ,,hope that helps,,,

Posted on Apr 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Why does my 2000 nissan maxima looses power while driving


Sounds like the maf sensor. Im assuming its throwing a check engine light? Get it read at AutoZone and look up the code. Go from tjefe

Jun 03, 2014 | 2000 Nissan Maxima

1 Answer

Will my car a (97 nissan maxima)run hot wen the camshaft position sensor or maf sensor is bad


No that would not affect temperature in any significant way. the engine in most cases just won't run or will be hard starting.

Jun 21, 2012 | 1997 Nissan Maxima

1 Answer

1995 nissan maxima that is running rough and occassionally stalls out. We have replaced the spark plugs and wires and run fuel injector cleaner through it. Cant afford a lot so trying to run through...


check your MAF sensor first..thats what it was on my 4th generation Maxima after tearing down the whole tbi system and what not....just pull out the sensor itself and clean it up, see if thats it, if not....idle control valve probably. or wiring.

Jul 23, 2011 | 1995 Nissan Maxima

1 Answer

I have a 1995 maxima that shakes and cuts out really bad when it is in drive or reverse but if i put it in neutral it stops shaking and cuttin out any ideas?


on the right side where the timing belt cover is there is a fat wire harness...over time from the motor rocking back and forth on the motor mounts will wear even short or break these wire diesect the harness and inspect......a simple diag test is to put it in nutral and manualy rock the the motor back and forth front to rear with a long bar to see if acts up doing this if not ...it may be a internal transmission tourque converter locking up issue...

Apr 27, 2011 | 1995 Nissan Maxima

1 Answer

The starter isnt working


The Starter is on the right (Top Side) of the motor. The only thing you will have to remove is the breather attachments (air filter,maf sensor,etc.)

May 11, 2010 | 1995 Nissan Maxima

1 Answer

Got a 1995 nissan maxima with 179,000 that hesitates or misses.


hello, also check plug wires,distributator, cap and rotor button, you can check plug wires,at knight time, crank engine, with hood up, walk around car, look at plug wires while motor is running, see if any sparks are coming from plug wires, also if it clunks, like you said, you may have broke motor mount, transmission mount, check for air lines leaking also

Apr 08, 2010 | 1995 Nissan Maxima

1 Answer

I have a 1995 Nissan Maxima, when the engine gets


Id say fuel pump pressure. That would be the first thing I would check.

Mar 09, 2010 | 1995 Nissan Maxima

2 Answers

Nissan 1995 maxima keeps stopping


It is most likely to be your fuel relay, however check your fuel filter and fuel pump.Hope this helps

Jan 09, 2009 | 1995 Nissan Maxima

1 Answer

1995 nissan maxima cuts off while driving


Check your battery terminals, if they're corroded replace them. That did it when I was having this problem.

Jan 04, 2009 | 1995 Nissan Maxima

3 Answers

1995 nissan maxima bogging


so you hear any different sound from the exhaust?
sounds like a plugged cat.
paul

Sep 24, 2008 | 1995 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

713 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...