Question about Isuzu Cars & Trucks

Open Question

Metal brake line diagram for front abs for 1998 isuzu rodeo

Need diagram for front metal brake lines on 1998 Isuzu rodeo

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

crayzeetrayn
  • 837 Answers

SOURCE: pinging sound from vehicle

The pinging is commonly caused by fuel problems ... usually a tankful or two of premium will clear it up. If not have it checked.

The front and rear shocks are different. You can even check this by going to www.autozone.com

Posted on Feb 18, 2009

  • 384 Answers

SOURCE: 1999 Isuzu Rodeo

one gose to the parts store and get the broken part . find the master cylinder reservoir , when at parts store find out what kind it fluid ittakes. refill reservior with brake fluid .put on your safety glasses raise side of that is broken remove wheel , place on jack stand. remove broken part try not to let all the fluid drain from reservior. may have to use a trick or two to get it off but it dose come off , install new one ,check fluid again top off if necessary . IT VERY VERY IMPORTANT IT DOSE NOT RUN DRY. start at the farest brake ,on the back of where the tire gose there is a small nut with a hole running throw it that is called a bleeder valve. 2 people will be needed 1 in the kar and 1 to say hold it back to the back side of tire loosen bleeder nut then re tigthen hand tight.then yell ok the person inthe car will pump the brake paddle 7 to10 ten times slowly press to floor then back up1 one thousand then down again a thousand between each pump. after 7 to 10 pump the car person will yell ok and hold down the brake then the under buddy turns the bleeder nut open,letting out air trapped in the lines repeat until you get a good stream of fluid. move to other side of car, car person will re fill reservoir putting cap back on reservior each filled bleed the brake same way . by this time the paddle should be getting hard not going to the floor. if it is recheck brake line work for leaks . if not game on after back is done recheck fluid move to front .do the one not broken first then broken last paddel should be hard like you have brakes don t forget to top off fluid again . then turn hard. if it is you are done if not look for leak and fix
once the car is in action it may or may not have to be done again goood luck DONOT STRIP BLEEDER NUT

Posted on May 23, 2009

  • 497 Answers

SOURCE: 1996 rodeo, ABS/Brake warning light on dim, will

Get an OBD reading

Posted on Oct 07, 2009

  • 2 Answers

SOURCE: 1998 isuzu rodeo 2.2 standard abs light stays on

I believe that was a recall item several years ago

Posted on Dec 12, 2009

  • 1757 Answers

SOURCE: i need diagram for 2.2 l for isuzu rodeo timing

My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following 2 LINKS. They have the Serpentine and Timing Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies:
For the Serpentine Belt:
http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/rodeo/1998_isuzu_rodeo_drive_belt_routing_diagram.htm
For the Timing Belt:
http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/rodeo/1998_isuzu_rodeo_timing_belt_diagram_marks.htm

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does the starter relay fuse for a 1998 Isuzu rodeo look like and where is is located in the fuse box


Crystal, this is what I found on the Rodeo starter fuse/relay.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
99 Isuzu Rodeo LS Underhood Fuse Box Diagram Circuit Wiring Diagrams
1997 Isuzu Rodeo Question Fuse Box Diagram Electrical Problem
1999 Isuzu Rodeo Main Fuse Box Diagram Circuit Wiring Diagrams
1998 Trooper Relay Solenoid Starter 1998 Isuzu Trooper All of

Jul 06, 2016 | Isuzu Cars & Trucks

2 Answers

I have 2000 isuzu rodeo lse replace brake pads and


CHECK SENSOR ON THE PADS, OR BRAKE SIDE

Jul 24, 2010 | 2000 Isuzu Rodeo

1 Answer

How do I add freon from a can to my 1998 Isuzu Rodeo? I'm not sure where the valve is to attach it.


You should have R-134A in your system. That being the case locate the two metal lines that go from the Firewall to the compressor. On each line you will find a port that may have a black or blue cover on it. On the larger line remove the cover and connect your Hose and gauge, that should be the Low pressure line. The good news is those 2 connectors are different sizes and the refill kit will only fit the low pressure side.

Jul 20, 2010 | 1998 Isuzu Rodeo

1 Answer

I need diagram for 2.2 l for isuzu rodeo timing


My sincere apologies for the delayed response.
I am personally going back to answer your unanswered questions.

I do not know if you still need this information, but I am going ahead and answering it anyway. You may want to Print the Diagrams for future use.

CLICK
on the following 2 LINKS. They have the Serpentine and Timing Belt Diagrams you will need.
If you would: Before Clicking: Let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my apologies:
For the Serpentine Belt:
http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/rodeo/1998_isuzu_rodeo_drive_belt_routing_diagram.htm
For the Timing Belt:
http://www.2carpros.com/car_repair_information/year/1998/make/isuzu/model/rodeo/1998_isuzu_rodeo_timing_belt_diagram_marks.htm

Sep 29, 2009 | 1998 Isuzu Rodeo

1 Answer

Replacing front brake line


its really easy your gonna need a line bender they are cheap about 10 to 15 dollars and some line and wrenches dont forget to get help bleeding the brake line after replacement.

May 22, 2009 | 1999 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...