Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
addatives don't fix the problem. They only make the problem a bigger deal when they stop masking the problem. You have a main seal leak. if you don't know what that is go get it fixed. It is not a simple fix.
Posted on Feb 01, 2009
either the cam seals are leaking or the valve cover gasket is leaking into the timing cover. maybe even head gasket...
but in most of the cases like oil leaking from behind the timing cover the camshaft seal is the faulty .and replacing the camshaft solves the problem.
no its not a costly part to be replaced.
you can get it from a local car repair tech or from
www.autozone.com service center.they also deal in parts.
This will help. Thanks please keep
updated.please please do rate the solution positively .thank you for using fixya
Posted on Mar 19, 2010
If you haven't had the timing belt replace (60,000 miles is the suggested service intervale) this is an overlap of having the timing belt replaced.
If the timing belt is not due for replacement and its the cam shaft seal that is leaking. Its a pretty easy fix. Remove the top timing belt cover , and the crankshaft sensor wiring you may have to remove the front engine mount . Set #1 piston at TDC, Loosen tensioner w/ spring slip off belt. **Remove sprocket pull out old seal with a sharp pick. Greese and install new seal make sure its flush with its bore . Reistall sprocket. Slide belt over Cam sprocket tighten tensioner. Install cover and mount (if applicable) Check timing marks by turning crank two revolutions.
** If CamSprocket Bolt is difficult to remove then remove valve cover and use a 21mm wrench to hold the Camshaft while you crack off Cam Sprocket Bolt.
You will see the groves on the Camshaft where you can place a wrench to hold the shaft.
After you replaced the seal replace the valve cover gasket ONLY IF YOU HAD TO REMOVE THE COVER TO HOLD THE CAM WHILE REMOVING ITS BOLT.
This is about as major as it gets.
Posted on May 17, 2010
i have a 1996 1.3 toyota corolla and i changes my roccer cover off a glanza turbo and my car leaked oil we changed the gasket but still seemed 2 b leakin a small bit we also put on gasket sealer now the car is not leakin oil but the oil light is commin on only when the car is under 1000 rpm does any1 no wat is worng with it?
Posted on Nov 03, 2010
Tips for a great answer:
Oct 13, 2016 | Toyota Cars & Trucks
Aug 17, 2012 | Toyota Corolla Cars & Trucks
Jul 30, 2011 | Toyota Celica Cars & Trucks
Jan 18, 2011 | 1992 Toyota Corolla
May 19, 2010 | 1996 Toyota RAV4
Jun 02, 2009 | 1985 Toyota Pickup
Feb 01, 2009 | 1998 Toyota Camry
Aug 11, 2008 | 2002 Toyota Sequoia
12 people viewed this question
Usually answered in minutes!