Question about Mercedes-Benz E-Class

Open Question

My 2010 e350 has 4 fog lights that won't turn off

Posted by on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Wiring diagram to install OEM 2010 Toyota Camry fog lghts

here is a link that can help you.
http://www.donmar.com/Tech/FogLight-TCA-303.pdf

Posted on Dec 26, 2010

dttech
  • 4803 Answers

SOURCE: My fog lights won't turn on Nissan sentra GEX 2002

There are several things that can cause your fog lamps to not work. The fog lamp circuits need to be diagnosed. Your entire fog lamp circuit can be tested at the plug for the fog lamp relay located n the relay box.

PIN 5 on the relay should have battery power at all times. This power comes from Fuse #43 (15 Amp) in the fuse and fusible link box in the engine compartment. If there is power at this pin, the fuse and the circuit between the fuse and the relay is good.

PIN 3 on the relay goes to the fog lamp bulbs. There should be continuity to ground through the bulbs on this pin. If you have continuity to ground, connecting a jumper wire between PIN 5 and PIN 3 should make the fog lamps come on unless there is a short circuit to ground, which will cause Fuse #43 to blow. If there is no continuity to ground on this pin, the problem is either that BOTH fog lamp bulbs are burned out or there is a break in the wire between the relay and the bulbs.

PIN 1 Is the battery power for the primary coil in the relay. This power comes from the headlamp switch and power is only supposed to be present here when the headlamps are on and the dimmer switch is on LOW BEAM. If power is not present at this pin, the problem is a bad headlamp switch or an open circuit between the headlamp switch and the relay.

PIN 2 Is the control circuit for the primary relay coil. The control circuit should have continuity to ground when the fog lamp switch is set to the ON position. If there is no continuity to ground with the fog lamp switch on, the problem is a faulty fog lamp switch, an open between the relay and the fog lamp switch, or an open between the fog lamp switch and ground E37 (right front of engine compartment) and ground F7 (left rear of engine compartment) Please note: This circuit has redundant grounds....if one ground is not making good contact, the other ground can still make the circuit work.

PIN 4 on the relay is not used.

If all of the circuits/pins are working as described above, replace the relay.

That is pretty much it... That is all you really need to know to get your fog lamp circuits diagnosed. Let me know if you need further assistance.

Posted on May 13, 2012

  • 6 Answers

SOURCE: Fog lights civic 2010

i have no experience to intall it, my boyfriend is car repair technician, so i can tell you some tips about it,
1,fog light mounted bumper in the hood
2,the fog light should be below the headlights
you should notice you local laws, if install the fog light is awful.
more information about car diagnostic, you can view my boyfriends E-shop:greebid.com

Posted on Jun 04, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why do my fog lights stay on 2010 equionx


Is the Service Vehicle Soon light illuminated on the dash? If so, the BCM has detected an electrical issue in the wiring circuit to the fog lights. If the SVS light is not illuminated, it is most likely the fog light relay is stuck in the on position. Open the hood and find the fuse center located on the driver side at the front shock tower. Remove the cover, look at the schematic on the underside of the cover and identify the fog lamp relay. Remove the relay and see if the lights go out. If the lights go out, you may need to replace the relay. You can substitute a like relay in the fuse center to verify relay is bad before buying a new one.
Good luck.

Oct 15, 2014 | 2010 Chevrolet Equinox

2 Answers

2010 jeep grand cherokee laredo fog lights


If it didn't come with fog lights, it may also have not included a fog light relay and/or fuse. Check the owner's manual for fuse and relay locations, and then check if the necessary parts are there.

Apr 21, 2014 | 2010 Jeep Grand Cherokee

1 Answer

2010 Dodge Avenger Fog lights won't work


fuse or chang the head light bulb

Jan 15, 2014 | 2010 Dodge Avenger

1 Answer

The tail light and the front fog lights don't want to turn off. They only turn off when I take the batery out


light relay faulty, contacter inside relay stuck in connected positon, constantly sending voltage to the lights no matter switch or key position.

Dec 13, 2013 | 2010 Toyota Hilux 3.0

1 Answer

Fog lights civic 2010


i have no experience to intall it, my boyfriend is car repair technician, so i can tell you some tips about it,
1,fog light mounted bumper in the hood
2,the fog light should be below the headlights
you should notice you local laws, if install the fog light is awful.
more information about car diagnostic, you can view my boyfriends E-shop:greebid.com

Jun 04, 2013 | Cars & Trucks

1 Answer

2010 routan fog lights activation


Is it factory installed already?? Not sure what you mean here. There is no activation except to turn on the low beams of the headlights and then turn on the fogs. The fogs will only work when thelow beams are on.

Jun 24, 2012 | Cars & Trucks

1 Answer

2009 Camry fog lights wiring diagram


this link says 2010, but if you look at the diagrams its for a 09 , I couldn't copy and paste the diagram, so heres the link http://answers.edmunds.com/question-2010-Toyota-Camry-fog-light-wiring-diagram-91027.aspx

Aug 09, 2011 | 2000 Mercury Cougar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...