Question about Mitsubishi Cars & Trucks

1 Answer

Is there an overflow tube on the outside of the radiator plastic water container on Mitsubishi express van 2005 I was filling it and one came loose?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has answered 1,000 questions.

  • Mitsubishi Master
  • 2,494 Answers

Yes the hose runs from near the radiator cap to the bottle.

Posted on Apr 25, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 253 Answers

SOURCE: 2005 chrysler town & country coolant leak

check the temp. coolant senser sometimes they will leak mine did and drove me nuts.If not there could be a main gasket leak.

Posted on Mar 15, 2009

  • 10 Answers

SOURCE: 2001 porsche leaking radiator fluid.

check for imperfections in the welding on the radiator

Posted on Apr 27, 2009

  • 12 Answers

SOURCE: plastic panel came loose under car, near where front area close to underneath radiator?

just a guard to stop stones an general rubbish sticking to the bottom of the rad hope this helps

Posted on May 21, 2009

  • 78 Answers

SOURCE: where is oil fill plug on mitsubishi express van manual trans??

fuel filer will be located blow ur chasy near fuel pump, generally.

n about Oil fill hole, it will located next to the engine, below the hood, or above the gearbox, for manual transmission. thank u

Posted on Jul 17, 2009

  • 22306 Answers

SOURCE: How do I get to the water pump on 89 mitsubishi

what plastic cover ?? the timing belt cover??

Posted on Nov 13, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


Four bolts hold it onto the support bracket. Remove both radiator hoses and disconnect the electrical connections to the temp sensor and fan sesnor. Take out the 4 bolts and lift up and away. Transfer the sensors from the old radiator to the new one. Do not mix up the locations of the sensors. Re install the radiator, put back the 4 bolts and reconnect both radiator hoses. Fill the radiator with the correct mixture of antifreeze and water for your vehicle. If it won't all go in, start the engine and let it run until the thermostat opens and then finish adding the coolant. Add water to the radiator until water can be seen circulating. Add some water to the overflow container and put the cap on the filler neck. Run a little longer then shut the engine off. When the engine has cooled off check the level in the overflow bottle and add coolant to the mark.

Feb 19, 2015 | Cars & Trucks

1 Answer

My Mitsubishi express 93 manual van what's just

sounds like thermostat or just air pockets trapped in the cooling system.

Jan 27, 2013 | Cars & Trucks

1 Answer

Mitsubishi challenger is using toomuch water

check for loose hose clamps . expanded top hose ( over clips). faulty radiator cap, signs of corrosion at top or bottom of radiator. overheating engine remove radiator cap wqhen warn and completely fill run engine and watch for air bubbles in radiator Make sure that the radiator is sucking water back from the overflow bottle The little hose is good and the cap is allowing this to happen. check for leaks in the heater hoses anjd taps

Jan 21, 2013 | Cars & Trucks

1 Answer

Keep looseing water out of radiator into resivior no water coming from exhaust no water in the oil cannot see a water leak only water comic from head of resivior it's a Mitsubishi l200 4 life+ 55reg

Most radiator start draining water if there is microscopic leaks or punctures. The system is a sealed unit and is not supposed to drain unless there is huge pressure within due to heating that can release the pressure cap on the radiator to release water to the overflow tank.
So the radiator must be filled and allowed to stand and if there is loss after a day or after the engine is running for sometime , you must check the pressure cap or else there is fault on the radiator ASSUMING that the engine is working normal- timing and tuning in correct condition.

Aug 22, 2011 | Mitsubishi Pickup Cars & Trucks

1 Answer

2005 kia sedona 76,000 overheats the engine

My 2005 KIA Sedona started overheating in Winter 2009/2010 and was loosing antifreeze. No leaks from the heater hoses or radiator hose. No pressure in the radiator either.

I had found a site where folks were discussing the same things and someone brought up the rear heater. Apparently KIA has run steel hoses running under the chasis to the rear of the van and these rot.

I looked under the rear at the wheel well and located the lines and they were wet with antifreeze. I traced the lines to the firewall and found where the lines were connected to the coolant system and bypassed the rear heater lines.

I then filled up the radiator and overflow tank with antifreeze and started the van. I rocked the van to get air to move out of the lines and kept adding antifreeze until it was full. then used the overflow tank to top it off.

Hope this helps.

Feb 12, 2011 | 2005 Kia Sedona

1 Answer

I'm not too familiar with Saturns ('98). How do I fill the radiator. There is little smoke around where the engine is and I just checked the oil, coolant, and transmission and they're fine, so I'm guessing...

if the radiator was empty the engine would be extremely overheated, some dash lights would be telling you about it and you could smell it. Radiator coolant level is maintained through the overflow container on top of the inner fender, it looks kind of like a wiper fluid container. opaque plastic, snap open lid, connected to radiator via a hose, has hot and cold fill lines on the outside.

Jun 23, 2010 | 1998 Saturn SL

1 Answer

2005 Honda Civic LX, had the timing belt and water pump replaced, about 1 month after the temp started to heat up when idling, never while moving. Found the overflow container full, I replaced the...

Are your fans working? If not thats your problem.. I would check your coolant flow make sure your radiator is not clogged and pump is working...

Mar 25, 2010 | 2005 Honda Civic

1 Answer

Coolant low light came on?

you have a overflow container that ties into your radiator it should be white plastic with black cap check the level and fill with straight antifreeze up to the fill line not the top but if it is already full and you have low coolant in the radiator then you most likely have a bad water pump this is if the light is acurate and not malfunctioning

Jun 29, 2009 | 1999 Jeep Grand Cherokee

1 Answer

2001 porsche leaking radiator fluid.

check for imperfections in the welding on the radiator

Apr 27, 2009 | 2002 Porsche 911

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

77947 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8832 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides