Question about Chrysler Cars & Trucks

Open Question

Fuel filter for Chrysler Cirrus 1999. - Chrysler Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
fischmilch
  • 96 Answers

SOURCE: 1999 Chrysler Cirrus Lxi 2.5l high rpm

The throttle position sensor may be misaligned. This tells the computer how much throttle is being applied, and when they go bad, or come out of alignment, the idle tends to get up there. If that's not the issue, remove your air cleaner, the housing and everything until you get to the MAP sensor. Give it a good spray with carb cleaner, let it dry and replace the air cleaner with a new one. If the MAP sensor detects minimal air flow, the computer jacks up the idle to compensate.

Posted on Nov 07, 2008

Ad
fischmilch
  • 96 Answers

SOURCE: 1999 chrysler cirrus

Check the coil packs, or the Ignition module. Disconnect the harness to the ignition module. And test the leads to see if there is current. I don't know what the specs should be, but it will be minimal. Never overlook fuses either.

Posted on Nov 07, 2008

Molson02536
  • 3854 Answers

SOURCE: 1999 chrysler cirrus transmission will not shift

It sounds like it may be you speed sensor at the transmission which is also called Vehicle Velocity Sensor (VVS), The sensor or the wire harness may have gone bad and needs to be replaced, but it's a good thing to have your car scanned at Auto Zone since they scan free of charge. I just want to make sure it is the VVS and not the transmission Control Module (TCM), Check the fuse under the dash and under the hood and look for any blown fuse like the TCM fuse. Good luck and hope this helps, keep me posted

Posted on Jun 24, 2009

ZJLimited
  • 17970 Answers

SOURCE: 1999 Chrysler Sebring Convertible code P1495. I

Code 1495 = Leak Detection Pump Solenoid Circuit

Remove the connector from the solenoid (should be on the back wall, just to the drivers side of the air-hat). You will have the solenoid to check and the harness. What you want to measure is the voltage coming from the harness and the resistance of the solenoid.

Turn the key to the "ON" position but do not start the motor; the voltage at the connector should be at least 10V or more,.now, check the resistance of the solenoid (should be around 35 ohms).

Hope helps.

Posted on Jun 03, 2010

  • 149 Answers

SOURCE: 1999 chrysler cirrus stalling problem with fault

p0455
Evaporative emission
(evap) control system leak detected (no purge flow or large leak)

Posted on Aug 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is fuel filter on 1999 Chrysler cirrus


the filter is located on top of the fuel tank. you will have to lower the tank to replace it. if your changing it due to a running symptom then you should check the fuel pressure and volume with a gage. as this can cause a running problem.

Sep 19, 2014 | 1999 Chrysler Cirrus

2 Answers

Change oil


Here is a tutorial on changing the oil in a 98 cirrus (I assume it would be the same on your car) : http://autoresource.internetautoguide.com/change-oil-98-chrysler-cirrus-3178.html

Oct 14, 2013 | 1999 Chrysler Cirrus

1 Answer

1999 chrysler cirrus will not start


make sure you have a good solid ground for fuel pump @ tank ! I can\'t express this enough. Is power getting to pump ! can you hear it run when you have an assistant turn key to on position ? it will hum for 2-3 seconds. computers rarely go bad ! just heard about a new fuel pump was wired wrong @ the manufactors who built it. that would suck. good luck

Feb 05, 2013 | 1999 Chrysler Cirrus

1 Answer

Where is the fuel filter located for 99 chrysler cirrus


It's underneath the car, on top of the fuel tank in the fuel pump module

Dec 25, 2010 | 1999 Chrysler Cirrus

2 Answers

1999 Chrysler Cirrus Oil Capacity - 2.5L


With new oil filter 4.5qts.
With out new oil filter 4qts.

Mar 31, 2010 | 1999 Chrysler Cirrus

1 Answer

How do you install a fuel pump on a 99 chrysler cirrus


fuel pump is under the rear seat on right side in fuel tank you have to remove seat

Jul 30, 2009 | 1999 Chrysler Cirrus

1 Answer

Fuel will not pump to engine


FUEL FILTER IS PLUGGED UP

Sep 07, 2008 | 1999 Chrysler Cirrus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8567 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...