Question about Cars & Trucks

Open Question

It runs on auto on is the switch bad - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My back running lights won't work


what transmission, Stick or Auto, (totally diffr)
back up reverse , dead lamps
did you check all fuses first. ?
did you try new lamps
or better use a voltmeter to the reverse pins
and see
0v ( switch bad , PRNDL ( A/T SIDE SWITCH, M/T CLUTCH SW)
6v (or about) circuit shorted.
12v, good lamps bad.

Sep 12, 2013 | 2003 Jeep Grand Cherokee

1 Answer

My 91 jeep wrangler 4.0 will shut down all power at all speeds from idle to driving on the interstate. I jumped out the auto shutdown relay and it works fine but i cannot find the auto shutdown switch to...


There is no switch. The relay gets a signal from the computer. If there is no signal from the crank position sensor the computer will not close the relay. If it runs with the relay bypassed, chances are good that the relay itself is bad.

Feb 06, 2011 | Jeep Wrangler Cars & Trucks

2 Answers

1996 ford explorer head light has high beam but no low beam. Im wondering if it is a ground that is loose or maybe my dimmer switch is failing


The components involved in your headlamp system vary considerably depending on whether your vehicle is equipped with "Auto Lamps", "Daytime Running Lamps" and/or "Fog Lamps". In any of these cases, both the High Beam and the Low Beam elements share the same grounds. Yes, it could be the dimmer switch. It could also be the Daytime running lamp module or the Headlamp Switch or the Auto Lamp Control Unit. It is also possible that you simply have both of your Low Beam Headlamp elements burned out or have bad sockets where they connect to the wiring harness.

Jan 29, 2011 | 1996 Ford Explorer

1 Answer

Fuses are good replaced cam,crank sensers auto shut down buzzes for as long as fuel pump runs after turning key to on postion


if the auto shut down is just buzzing it is the relay engaging and disengaging really fast you have either weak voltage or weak control signal coming from the pcm possibly a bad wire. also try to switch relay out with one that is similar in the fuse box to see if it is a bad relay.

Jan 22, 2011 | 1999 Dodge Intrepid

1 Answer

Air con switch in dash works only in in number 4position,its in a 1994 1600 twin cam auto.


blower relay has gone bad. as a safety pt, when relay goes bad it runs on hi only. The relay is a resistor per say

Jan 03, 2011 | Nissan Pulsar Cars & Trucks

1 Answer

My 2001 Ford Ranger has no instrument panel lights or running lights. I turn on the headlight switch and there is nothing. I have headlights and breaklights, but no running lights or instrument cluster. ...


Hi, I am an ASE certified auto repair technician with 35 years experience, specializing in diagnostics. If my answer helped you a positive testimonial is appreciated, good luck with your problem.

It is pretty common for this problem to be a bad headlight switch. I would advise testing the switch before replacing it. That being said I would give it a 90% plus chance of being a bad headlight switch. If you want to test it yourself I would recommend getting a good repair manual at a major auto parts store. This will have a wiring diagram in it and will allow you to test the switch ones it is removed.

Dec 20, 2010 | Ford Ranger Cars & Trucks

2 Answers

2001 Audi tt manual transmission. Car won't start with key. Will run when push started


sounds like your starter or battery is bad. go to an auto shop and have it diagnosed fully,

ps. auto-zone does it for free

May 14, 2010 | 2001 Audi TT

1 Answer

Head lights cutting off and on at night while driving


bad ground on the headlight circuit,bad switch,bad auto sensor,or bad sockets or bulbs,or bad daytime running light module.

Apr 14, 2010 | 1993 Lincoln Town Car

1 Answer

I have a 96 lumina 3.1 car. the ac compressor will work fine sometimes, and other times it will not kick on. it is full of freon......?someone said the low pressure switch could be bad. i cannot find that...


Compressor clutches go bad sometimes.. it is an electromagnetic device on front of compressor. You may also need shot of refrigerant. Level may be at point where it is on brink of being low.

May 15, 2017 | 1996 Chevrolet Lumina Mini

1 Answer

1998 mazda protoge no brake lights


you just have a bad connection in there or you got a bad ground have someone check that..

Dec 05, 2008 | 1998 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...