Question about Cars & Trucks

1 Answer

Have fitted new batteries gauge says fully charged key on but how do I get it to drive forward

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 604 Answers

Start the car and put it in gear

Posted on Apr 19, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My sons1999 Jeep Grand Cherokee had the gauges light on and would not start like battery was dead. Had it jump started and it started.When he put in park it stalled jumped again and worked.


Sounds like a charging system problem and the alternator may not be working. The gauge light will come on if the charging gauge is showing low so you will look at the gauges. Have the battery and charging system tested

Jan 05, 2016 | 1999 Jeep Grand Cherokee

1 Answer

Battery fully charged, car wont start, cant remove key, 2004 cadillac cts


There is a magnetic switch on the 'park' position. The car only starts or releases the key in 'park' is enabled. Maybe this switch is not working! Try to replace it!

Apr 11, 2012 | 2007 Cadillac CTS 3.6L

1 Answer

Replaced failed starter with new one on my 1977 porche 924, turn key and nothing. I have a fully charged battery.


check power and ground cables for fit and corrosion. If ok check starter switch wire(the little one) for voltage when key is turned,if none is ignition fuse/switch problem.

Mar 02, 2011 | 1987 Porsche 924

1 Answer

Jeep would not start at all 3 weeks ago . As if Battery was Dead. 2 hours later it started right up. Battery was fully charged . Been driving it every day for 3 weeks with no problems and then today it...


try taking off the battery terminals and see if they have dirt and grime behind them thats not letting current flow clean them with wire brush sounds like not getting current

Sep 24, 2010 | 1995 Jeep Grand Cherokee

1 Answer

Have a 2006 sportage cannot lock the car with remote key since the car has stood for about 3 months in garage car battery fully charged and new battery fitted in key ?


unlock the car with the key then press/hold the button down on the remote to lock car.if this doesnt work try lock the car....etc.

Mar 02, 2010 | 2006 Kia Sportage

1 Answer

1988 nissan300 zx auto non turbo engine will not turn over battery fully charged just clicks when I turn key sounds like click coming from under dash. All gauges work but when turn key all gauges draw down...


You've got to check remove and clean your battery terminals and the connectors.Also check the main ground on the block from the battery negative terminal. Then check the tightness of the large red wire going to the starter from the positive battery terminal. And lastly, make sure the small push on terminal to the starter solenoid is tight. if not remove it and pinch it hard with your thumb and index finger. Push it back into place and see if it will start. If so while it is running check your charging systenm with a voltmeter,it should read between 13- 14.5 volts. If it does not start then jump the battery from another vehicle and then check the charging system. If your charging system is fine and the next morning you cannot get it to turn over you'll need a new battery.

Sep 06, 2009 | 1986 Nissan 300ZX

2 Answers

Gauges jump w/ acceleration & batt/charging light on


First, have the battery charged and load tested. If it does not pass load test, replace it. An alternator is not made to charge a battery. it's job is to maintain the current state of charge. By driving and attempting to charge it that way you over-worked the alternator and may have damaged it or the regulator. Once the battery is fully charged and in good condition, you will need to check the charging system for proper operation. If the gauge system does not return to normal, it will need further diagnosis to correct it.This isn't a "cure" but rather, what you need to do in order to get back to "square one". With the alternator running "flat out" trying to charge a dead battery it can put out over 15volts, possibly damaging the dash/body control module or computer.

Aug 28, 2009 | 2001 Chrysler Town & Country

2 Answers

Battery test proper voltage, new alternator test normal to low voltage,have trouble starting at times. while driving amp gauge shows varying readings of 14 to 10


If you test battery with a load test it will probably fail. Battery is bad. Also have alternator tested. Go to any parts store, even walmart they all test for free. I would put my money on bad battery. Cells getting weak.

Jul 17, 2009 | GMC Safari Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...