Question about Cars & Trucks

Open Question

I have a 2010 16tdi management light and glow light on had management unit replaced but not the fault any ideas Please

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 11800 Answers

SOURCE: Engine management light on perminant

U1600- Electronic key-immobiliser system fault. Something is wrong with your key, it's no longer recognized properly by the safety system.
Have the immobilizer thoroughly inspected and if it's not it then the key's chip is failing - you will have to replace it.

Posted on Jul 01, 2011

Testimonial: "Thanks very much for the answer to my problem will do what you recommend sounds expensive THANKS"

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Van will not rev above 2800 rpm


I think I would check in the tank and see if excess mastic didn't end up inside of the tank and is clogging the sump tube.

May 22, 2016 | Cars & Trucks

1 Answer

What does the glow lamp warning indicator on a 2003 VW Polo mean?


It may mean a glow plug fault or a brake light switch fault. You need computer software to interrogate the engine management.

Jul 01, 2014 | Volkswagen Golf Cars & Trucks

1 Answer

Limp mode glow light enginemanagment and exhaust light


you have to scan it for faults then you will know exactly whats wrong

Apr 16, 2014 | 2010 Skoda Fabia 1.2

1 Answer

Glow plug light wont go out


Your diesel vehicle is equipped with glow plugs, and also with a Glow Plug Light that will either come on and stay on, or flash or blink when a fault is detected by the ECU (engine management unit). When the Glow Plug Light comes on, the ECU stores information about the condition that has caused it to come on.4 Jan 2016

Is It Safe to Drive With the Glow Plug Light On? ' YourMechanic Advice

https://www.yourmechanic.com/article/is-it-safe-to-drive-with-the-glow-plug-light-on Glow plug light wont go out Google Search

Oct 25, 2017 | Ford F-250 Cars & Trucks

2 Answers

Glow plugs light flashes on dashboard when driving golf estate mk4 diesel


The glow plug light in VW cars are telling you you have a fault not with the glow plugs but with the engine management.Get a garage to do a diagnostic check for you.

Dec 30, 2010 | Volkswagen Golf Cars & Trucks

1 Answer

Engine managment light flashes (glow plugs light)


the car is going into limp mode due to an engine management fault. have to check what the fault is with a code reader. if the milage is high 100,000+ could be a turbo fault (overboosting), as this will put the car into limp mode.

Feb 21, 2010 | 2005 Volkswagen Passat

1 Answer

Engine light and emmisions worshop on dash


You will need to have another code scan done. A faulty glow plug will certainly show up on a scan, but should NOT bring on the engine MIL light. Erase all faults showing at present. This should extinguish the engine light. Thin start and stop engine a number of times until the light comes back on. This will re boot on-board computer. Do another scan and the fault should show up. If possible do a live reading, paying close attention to the (oxygen sensors) lambda units
Best of luck
John

Oct 03, 2009 | 2005 Volkswagen Passat

1 Answer

Mondeo diesal 2002, glow plug light


Hi

The glow plug coming on on the Diesel Mondeo is an engine management fault indicator. The car goes into "limp mode" when this happens or in other words safety mode is triggered. This explains your loss of power.

To find the cause of this light coming on - the car will have to go on an OBD scanner at a service shop which will read the codes stored in the cars computer and give you an answer as to what is causing the fault to show.

Hope this helps - please remember to rate my answer as ratings are important to me as an expert on the site. Thank You.

Jul 13, 2009 | 2000 Ford Focus

1 Answer

BMW320 Engine Management Warning Light won't go out


run the fault codes first as the light also reports on transmission problems
just turning a light off doesn't fix the fault that put it on in the first place

Aug 16, 2017 | 2000 BMW 3 Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...