Question about Cars & Trucks

Open Question

650 Rincon only moves in low gear acts like it shifts to reverse when it shifts to second or drive

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chrischronic
  • 235 Answers

SOURCE: 1995 crown vic gear problems/gear shift wont lock

if the shifter is loose and sloppy feeling then the shift cable bracket has come loose under the dash at the steering wheel. remove the lower panel under the steering wheel so you can see under the dash then get flash light and look while jiggling the shifter. you should be able to see the cable and bracket. if the bracket is loose then tighten the bolts. note this bracket is at the steering colum.

Posted on Jan 22, 2009

Ad
  • 14036 Answers

SOURCE: gear shift won't move out of park sometimes

look for transmission shift interlock solenoid fuse.or a bad brake switch will cause transmission not to come out of park.

Posted on May 16, 2009

jaysonemanme
  • 500 Answers

SOURCE: 1995 crown vic gear problems/gear shift wont lock

most likely the shift tube bushings are bad- you may have also lost a few screws in the shift tube or they could just be loose. you have to pull the steernig column down to inspect/repair it.

Posted on May 31, 2009

ghost45
  • 1280 Answers

SOURCE: 2001 Hyundai - reverse gear is inoperative. The

If I understand you correctly, you have ALL forward gears working, but reverse doesn't?... then the problem is in the transmission itself or the linkage on the trans linkage into reverse.

Posted on Oct 18, 2009

  • 1 Answer

SOURCE: 1991 Caprice No reverse. Moves in neutral. All forward gears OK.

This is Ron out of Vero Beach Florida. I have been doing trannys for years. The problem you described is caused (more than likely) by a seized clutch pack. Depending on the trans, and your car should be RWD with a 700r4 tranny, there are several sets of clutch packs and at least one band. Automatic transmissions rely on fluid pressure to "engage" the correct set of clutch discs, at the right time , to engage and change gears. I have seen in the past, where a customer parks his car for the evening and the next morning, no move. What happened?? More than likely, a clutch pack was on it\'s way out but cause the car was hot the plates were free, but after cooling, they can weld themselves together and actually "lock-up". In the morning you know the end result. Your tip on "moves in Nuetral" is the give away. Ron

Posted on Jan 18, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Like to find out why transmission will shift in reverse and first but not drive and second will not move in Drive and second gears 1976 Motorhome will drive in reverse and first gear


Because 2nd and third gears use a different clutch pack than first and reverse. It sounds like the 2nd and third clutches are gone.

May 23, 2016 | Cars & Trucks

1 Answer

I have a 1994 chevy Van G20 series it will go in reverse and in low gears but wont shift


Check your E-break first, secondly check to make sure you have no errors kicking from the control unit (engine computer module) which may or may not trigger a check engine light. Moreover it could be several things. Since it's an automatic the drive train maybe damaged, controller unite could be damaged, the transmission could (and probably) is dying. I'd have a professional mechanic check it out.

Jul 31, 2014 | 1994 Chevrolet G20

1 Answer

CODE PO871


First thing tomorrow, take it back to the shop that rebuilt it!!

Jul 03, 2017 | Dodge Pickup Cars & Trucks

1 Answer

Car wont move when in drive gear


either low on fluid or forard clutches are out..

Dec 30, 2013 | Toyota Passenger Cars & Trucks

1 Answer

2005 honda rincon wont move


Check transmission fluid level. If it's ok need to have trans fluid pressure checked. Need schematic, but should be a port on the side of trans for this. If to in depth then take it to a repair shop. Could just have a clogged trans filter.

Jul 11, 2013 | Cars & Trucks

2 Answers

1994 Cadillac Deville - won't shift into reverse after sitting overnight or for a couple of hours. Will shift into 1st and then will shift into reverse. What is causing this?


Check the transmission fluid level, reverse needs twice the pressure to activate that drive does. If low refill and try again. If fluid good, I`d say the tranny 3rd reverse clutch is worn out. Recheck the condition of the fluid on the dipstick, if it appears burnt or very dirty I`d still suspect internal tranny clutch issues. It also has a low reverse clutch, but goes into 1st gear as you said.

Feb 02, 2011 | 1994 Cadillac DeVille

1 Answer

The transmission is in "D" but the tach is showing as if it's in "2". It's not shifting as it normally would in "D". I put it in "2" and it there's no change. I put it in park then neutral and that all...


Your shift indicator is simply stuck. Until you have the time to fix it, your best solution is to start from park then slowly shift to the next setting which is reverse, then neutral then park. All automatic transmissions shift pretty much the same which means you only have to move 3 notches the opposite way from park to be in drive. You don't need a shift indicator for that. Later you can replace the indicator with a dealer factory replacement.

Jul 31, 2010 | 1998 Ford Windstar

2 Answers

1991 Caprice No reverse. Moves in neutral. All forward gears OK.


shift linkage needs adjusting,,could be bent, easy fix, located along firewall to fram beneath the column, ask your son wut he ran over and didnt tell u about... hope i could help...:)

Mar 22, 2009 | 1991 Chevrolet Caprice

2 Answers

1991 Caprice No reverse. Moves in neutral. All forward gears OK.


What engine? Rear wheel drive ?Sounds like shift linkage or cable out of adjustment slightly. Have a look at where cable or rod attaches to transmission for adjustment. If not sure of what your looking for get back to me with info.

Mar 21, 2009 | 1993 Nissan Maxima

Not finding what you are looking for?

Open Questions:

Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77544 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...