Question about Cars & Trucks

1 Answer

What do I fix to stop left and right sway on my 1996 Seville concord

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 923 Answers

Get a front wheel alignment? It sounds like you have tow-out instead of tow-in. Tie rod ends may be loose, or bushings and/or ball joints may need replaced. Perhaps shocks too.

Posted on Apr 18, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What do I fix to stop left and right sway on my 1996 deville

shock absorbers and anti sway bar rubbers and mounts
if it occurs at slow speeds and is most noticeable at the rear
( like a duck wobble) check the rear tires for belt separation

Apr 18, 2017 | Cars & Trucks

1 Answer

Jeep sways at around 30mph. Have replaced almost entire front end...any ideas

sways at what speeds.?
with side winds or not.?
loaded car or unload, trailer?
sway as in body tilt , left to right.
or diving?
answer like a pilot.?
roll , pitch , yaw..?
are wheel bearing tight.?
are tie rods? tight.
ball joints tight, there are tests for each,
shock good (dampeners)
get a suspension shop check it for near nuttn? do so. saves time and money and safety issues.
they will find it fast, (tell em' diagnosis only")

Mar 23, 2015 | 1996 Jeep Grand Cherokee

3 Answers

My break peddal goes all the way to the floor and break fluid is leaking out by the back right tire area why

Sounds like the brake wheel cylinder is leaking check the master cylinder and it will low or empty.

Jul 24, 2014 | 1996 Chrysler Concorde

1 Answer

I have a 2000 Chrysler Concorde. Good Car. 145000 miles. Changes the struts last year and this year changes the bushings in the front wheel drive. The car is making a popping noise in the front end and...

could be cv joint but jack up wheels and move tire up down and left right up down if play check ball joints /anti-sway bar bushings--------if play left to right than check idler arms and steering system /and anti sway bar bushings

Dec 07, 2012 | 2000 Chrysler Concorde

1 Answer

1996 Chrysler Concorde: Engine turns over, but will not start.

I think you have to replace the O2 sensors in the exhaust system. this just my guess. you can check from repair shop and then fix it

Aug 16, 2012 | Chrysler Concorde Cars & Trucks

1 Answer

Alarm system will not shut off and cant start car.disconnected battery and reco,no solve problem.can the remote be stuck inalarm if battery dead?

you need to press the lock/unlock on the remote.
a POSSIBLE trick turn the door key to the right then the left, get in and crank engine
if that does not work get a new battery for remote.
if you disconnect the battery the alarm will sound when you reconnect and you will have to have the remote handy to stop it

Sep 19, 2011 | 1996 Cadillac Seville CA Value

3 Answers

What are swey bars on a ford focus

A sway bar is a suspension piece that keeps the left and right side of vehicle connected to help with turns. They are held together through sway bar links at each end, which are fairly common to break or rattle over bumps.

Mar 27, 2011 | 2003 Ford Focus

1 Answer

Have a 1996 explorer sport with 200k. Daughter said the truck started to drive "like a boat tossing and turning" at highway speed. Front end was rebuilt not long ago. shocks seems fine and...

Yes this sounds like A sway bar condition and yes you can Replace just the links and bushings. I would not replace the sway bar its self unless that is infact what broke. I hope this helps you out. i would appreciate it if you would rate me.
thank you

Nov 15, 2010 | 1996 Ford Explorer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14512 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides