Question about Cars & Trucks

1 Answer

Wat cud be tha problem wen tha car has no power at 1st wen step on gas padel until 2 lil jerks nd takes off finally.?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 19,719 Answers

Ye, gods. is this the standard of written English in the USA?

Could be anything
bad gas
water in gas
dirty injectors
faulty sensors
bad mixture
worn or badly gapped plugs

year make model jerks on pull away


Posted on Apr 18, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: Two problems. 1. jag a noise when down shifting. 2. jerks when taking off

There is a special fluid additive that you have to add to the fluid in your transmission, simply drain one litre of fluid from the trans and add one litre of this special additive that the dealer will sell you and your problem will be solved.

Posted on Dec 01, 2008

  • 1 Answer

SOURCE: no power, jerking bad 1998 cavalier

change your TPS (throttle postion switch)

Posted on Jan 10, 2009

  • 467 Answers

SOURCE: transmission jerks when you step on the gas

check the transmission mounts, also check the transmission fluid level,

Posted on Jul 30, 2009

  • 1 Answer

SOURCE: i have black smoke blowing out the exhaust wen i step on the gas

I own a 2004 F-350 with the 6.0 Turbo Deisel...My wife has been driving it periodicll arround town and had mentioned from time to time it seemed to not want to get going. Well yesterday I went and picked the boat up and on my way home the truck lost all power and was spewing black smoke. After reading a few blogs I decided to pull the EGR Valve.. It sits right on top of the engine (from the front bumper looking at the engine) just forward and to the left of the oil filter. Two 8mm bolts and it comes off ( rotate back and forth while pulling up). The EGR valve was covered in soot and partialy in the open matter how far I manually opened the valve it stayed in that position.. After checking the price of a new EGR ., I decided a little home remedy was in need.. I let the valve portion of the EGR ( the lower porting, NOT THE ACTUATING PORTION) soak in fuel over nite. Cleaned the soot off and lubricated the valve shaft. Actuated the valve manualy an few times and it began to spring closed beautifully..A tad more touch up cleaning..reinstalled the valve and was able to hear a feel a noticeble difference in the way the turbo spooled up... no black smoke .. and running smoother... Quick fix..easy fix.. so easy I plan to make this part of my oil change ritual... pull the valve .. clean and lube... HOPE THIS HELPS ! !

Posted on Apr 24, 2010

  • 1746 Answers

SOURCE: my car keeps jerking when

Hi, it could be one of many things. Bad spark plug. clogged fuel filter. bad thottle sensor. bad fuel pump etc... You should go to a mechanic and have them diagnose the problem on the code scanner. Good luck.

Posted on Sep 15, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hello my right side front nd rear indicators r flashing but my left side indicators is not working. Checked fuses nd bulbs. Still not working. Wat cud be da problem thanks Adran.......MAZDA6 2003

Dear Adrian,
Could most likely be one of 2 problems.
Most common is a bad bulb.
A bad bulb can look fine, but will not work.
Try interchanging them from socket to socket.
# 2 is a bad ground wire.
All cars since the late 80's have a separate ground wire to every light socket.
If a ground wire gets loose or broken, the symptom will be what you are experiencing.
God bless your efforts.

Nov 06, 2015 | Cars & Trucks

1 Answer

2001 passant is jerking when pressing the gas padel

At what rpm range?
Check motor mounts and transmission mount

Also check the air tube (TOP AND BOTTOM) for hairline crack.

A worn motor mount can cause excessive vibration and damage the air inlet tube.

Jan 19, 2014 | 2001 Volkswagen Passat

1 Answer

2006 Toyota Sequoia, just purchased, however, when I come to a complete stop the vehicle jerks as if someone is pulling me backwards, enough to cause whiplash. More noticeable after driving it awhile,...

1 problem at a time

1st-- squeaks-- when the breaks where replaced where the anti-radile clips put back in, if so dose squeak rear or front

if rear check spring kits

2nd-- jerks-- this could be drive train question dose ur engine seem to rev at all wen this is happening

try this

goto an area where this is safe

driving at normal speeds put the shifter in neutral (this will NOT hurt it if you follow wat i say)
now apply the brakes dose it **** if so problem is in breaks is not get ur trans looked at
good luck

Aug 16, 2011 | Toyota Sequoia Cars & Trucks

1 Answer

I have recently bought a mazda 929 luce limited nd its got a v6 engine 3.0l 18 valve ,,its been parked for over nd year ndd upon changing da transmission fluids today i have been successful in moving...

Hello and welcome to FixYa!

One thing that can cause this is a faulty torque converter. If the torque converter is faulty, the shifting of the vehicle fails. One good reason why it only shifts on 2 gears. Have it replaced and you'll be good.

Hope this helps and thank you for using FixYa! Have a good one!

May 04, 2011 | Mazda 929 Cars & Trucks

1 Answer

Well my 99 dodge intrepid just started not wanting 2 stay running n even if i push on gas it wants 2 stall n wen i come 2 a stop it dies a lot of time even sitting n running it wants 2 die sometimes auto...

The fact that this issue began after you changed the air filter and that it idles higher than it used to sounds like you accidentally knocked off a vacuum line while changing the filter. Look around for any hoses or small rubber lines and connectors that are no longer attached.

Mar 25, 2017 | 1999 Dodge Intrepid

1 Answer

Use 1st turbo n 1st gear then change nd theaz no boost tl 2nd turbo 2nd gear no power.check engine light cums on wen start the car and turbo timer dosnt work


Feb 01, 2011 | 1999 Subaru Legacy

1 Answer

I hv a Honda accord 94. It was running great but yesterday it start creating problem. Wen I try to push gas pedal it start missing n rpm needle goes upto 5000. I thought it could be coz of spark plugs so...

Looks like some engine oil goes into the cylinder and contaminate your spark plug, thus making your plugs miss.
Look where that oil damp spark plug located at cylinder number, in that cylinder the valve seal is to be replace immediately. Valve seal is located on top of the engine that seals the intake/exhaust valve and valve guide, from oil going in the cylinder.
You could ask your mechanic to do the job, it is a bit hard to replace it. the parts needed coat just under $5.
Hope that helps you out!
Thanks for using Fixya!

Dec 12, 2010 | 1994 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13735 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides