Question about Suzuki Cars & Trucks

Open Question

Where is the low pressure switch located on suzuki aerio 2003

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: 2003 suzuki aerio clock light no longer works how to fix

Funny you should mention that, I’ve been working on the same problem with my 04 Aerio for 2 days. If you've checked the bulb and that didn’t fix it then it's probably 1 of the 5 little resistors on the circuit board. They’re really small and aren’t soldered very well. Pull the clock and pop the white ABS cover off the back, once you remove the clock from the dash you won’t even need any tools to pop the rear cover. Now plug the clock back in (make sure you get the plug back in the right way or you’ll short everything out) then turn your key on and GENTLY push on each resistor with your finger while watching to see if the light flashes on. If it does then that’s the resistor with the bad connection. I say GENTLY because I wasn’t and the lose resistor popped off on mine and no matter how many times I try soldering it back on I cant get a good enough connection to make the light work.
If you do find the lose resister, use a small tipped medium heat soldering iron and fine electrical solder to carefully solder the ends of the resistor with a little solder as possible. What ever you do don’t knock the little thing off or you probably never find it again, and you probably never get it to make a connection again. I’d start with resistor 430, it’s the nearest of the 2 on the side of the plug-in pins on the circuit board. Hope you have better luck then I did…..

Posted on Jan 16, 2009

Ad
  • 1201 Answers

SOURCE: location of fuel filter 2006 suzuki aerio

In the fuel tank, accessed by removimg the fuel pump.

Posted on Jan 26, 2009

  • 1 Answer

SOURCE: WHERE IS THIS PORT LOCATED?

Yes, on my 2002 xl-7 the low side port is behind the grill as ibass215 says. The cap is light green and marked with an "L". Thanks Susuki, couln't you find a more hidden place?

Posted on Sep 06, 2009

  • 1986 Answers

SOURCE: removing front door panel on a 2003 suzuki aerio

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls

Posted on Sep 23, 2009

wireguy212
  • 1627 Answers

SOURCE: what type of oil does my 2003 suzuki aerio take?

You should be useing 5w30 oil in this car.

Posted on Dec 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Me esta dando un codico con el escaner 1709


english please. 03 suz aerio
no engine option stated, nor tranmission.?
DTC P1709 is a suzuki only factory code P1 mean that.
so only suzuki books work for that
I log in to alldata
and see
Trouble Code:P1709
Engine Coolant Temperature And Barometric Pressure Signal Circuit Malfunction
Trouble Code Conditions:
Too long high signal of pulse signal from ECM to TCM continues to be out of specification. or Too long low signal of pulse signal from ECM to TCM continues to be out of specification. or Too long or short low signal of pulse signal from ECM to TCM is detected in continuous 8 pulse.
Possible Causes: TCM errors. check

only a real FSM will help here.
get one. or get service at Suzuki.

Jan 10, 2014 | 2003 Suzuki Aerio

1 Answer

Add fREON bird low


H stands for High Pressure and the L stand for Low Pressure.
The A/C system is split into two sides, a high pressure side and a low pressure side. An AC compressor is basically a pump, so it has to have an intake side (low pressure side) and a discharge side (high pressure side).

Sep 18, 2013 | 2003 Suzuki Aerio

1 Answer

Why my car 2003 suzuki aerio Sedan turn off when im driving


ill add guesses. stalls. does it restart, easy????
1: lost electrical power to the EFI system.
2: lost fuel pressure
3: lost spark , lost fuel injections.
4: egr leaks, (clean and get it to close, it must close at idle or the engine will stall. 50k mile service point in the manual.

Apr 14, 2013 | 2003 Suzuki Aerio

2 Answers

Where located fuel sensor Suzuki Ario 2003


Component location diagrams for most 2003 Suzuki Aerio cars and light trucks sold in the U.S. from 1990+.
clsk2003aeri003.gifIgnition System Components Location Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
Components on diagram:
  • TP Sensor
  • Ignition Coil
  • ECM
  • MAF Sensor
  • CMP Sensor
  • clsk2003aeri007.gifElectronic Shift Control System Components Location Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
    Components on diagram:
  • Data Link Connector
  • Transmission Range Sensor
  • Throttle Position Sensor
  • Pressure Control Solenoid Valve
  • Battery
  • clsk2003aeri010.gifInstrument Panel For Connector Layout Diagram Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Clutch Switch
  • Thermistor
  • Brake Light Switch
  • Blower Motor Relay
  • Heater Fan Motor
  • clsk2003aeri011.gifInstrument Panel Harness Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Wiper Switch
  • Washer Switch
  • Data Link Connector
  • Turn Signal Relay
  • Radio
  • clsk2003aeri015.gifHeadlight System Location Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Headlight Relay
  • Headlight
  • Clearance Light
  • Headlight Diode
  • Clearance Light Relay
  • clsk2003aeri022.gifFuel System Components Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Fuel Pump Relay
  • Fuel Tank Pressure Sensor
  • EVAP Canister
  • Fuel Tank Pressure Control Valve
  • Fuel Filler Cap
  • clsk2003aeri027.gifFloor For Single Unit Parts Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
    Components on diagram:
  • Wheel Speed Sensor
  • ABS Control Module
  • G Sensor
  • Air Bag Control Module
  • EVAP Canister Vent Valve
  • clsk2003aeri030.gifInstrument Panel For Ground Point Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • Instrument Panel Ground Points
  • clsk2003aeri036.gifEngine Compartment For Single Unit Parts Diagram for 2003 Suzuki Aerio 2.0 L4 GAS
    Components on diagram:
  • Throttle Position Sensor
  • Horn Relay
  • Radiator Fan Control Relay
  • Cruise Control Module
  • Condenser Fan Relay
  • clsk2003aeri037.gifEngine Compartment Components Diagram for 2003 Suzuki Aerio SX 2.0 L4 GAS
    Components on diagram:
  • MAP Sensor
  • Knock Sensor
  • Noise Suppressor
  • Heated Oxygen Sensor
  • Sep 18, 2011 | 2003 Suzuki Aerio

    1 Answer

    My a/c isnt working in my 2003 suzuki aerio. I have been told its an electrical problem in the air conditioning circuit... or if the conditioning compressor clutch will not engage try with the ignition key...


    Hello Jgilly90,

    I'm not sure if i would place a jumper across the low pressure switch. Unless the troubleshooting tree in the service manual
    suggested this test I would be careful experimenting.
    Here is your HVAC schematic:





    2003 suzuki aerio hvac schematic-lgkuwp4aw4khkvxj1psb51j4-3-0.png

    Aug 17, 2017 | 2003 Suzuki Aerio

    1 Answer

    Where is located the fuel relay pump suzuki aerio 2003


    under hood in relay / fuse box it will be marked fuel pump

    Dec 16, 2010 | 2003 Suzuki Aerio

    1 Answer

    Which pins are shorted on AC pressure switch to get the AC compressor to cycle to fill unit with freon?


    You should not have to do anything to charge that AC system, except to start the engine and turn on the AC to maximum, then charge the AC system, when there is enough pressure in the system the low pressure switch will trip the AC compressor on and you can continue to fully charge the AC system.

    Jun 06, 2010 | 2003 Suzuki Aerio

    3 Answers

    2003 Suzuki Aerio A/C problem


    one ,the big one is the high pressure side, dont mess with it. you want to fill on the low pressure side. its the small connection port, usually colored blue on the cap.

    Aug 11, 2009 | 2003 Suzuki Aerio

    1 Answer

    My break lights wont work on my 2003 suzuki aerio


    Sounds like your brake light switch, located on the brake pedal, has gone out. Shouldn't cost too much more than $20 to get a new part and about 30 min. to fix. Good luck and thanks for using FixYa!

    Jun 27, 2009 | 2003 Suzuki Aerio

    2 Answers

    Suzuki aerio engine 2.0L have timming belt or chain?


    TIMING BELT SHOULD BE 60,000 MILE CHANGE

    May 08, 2009 | 2003 Suzuki Aerio

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    17 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Suzuki Experts

    yadayada
    yadayada

    Level 3 Expert

    76673 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22219 Answers

    Boyet Soriano
    Boyet Soriano

    Level 2 Expert

    293 Answers

    Are you a Suzuki Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...