Question about Hyundai i10

Open Question

My central locking has lost power on my i10 ? This happened after a electrical fault caused by me , by trying to fit a fuse and not a bulb into the light in the boot ! It sparked out !

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: Central locking

Solution #1 posted on Aug 20, 2008 0%20stars.png
noavatar_s.gif
RikA4
Rank:nonexpert_s.gif Apprentice
Rating: 100%, 2 votes
Hi g79radu.
The most likely cause is a faulty Central Locking Pump. I had this problem recently and it is apparently quite a common fault on the A4. When you use the key manually can you hear a kind of humming noise for about 20 seconds or so coming from the rear of the car? If you can it indicates that the pump is trying to open the doors but something is preventing it.It might just be a leak in one of the air hoses but more than likely the compressor wheel inside the pump has disintegrated. I posted a solution to this the other day so I will just copy/paste it here for you.

There are 2 ways of solving it. The first is to pay your Audi Service Centre £350-£550 to replace it for you and the second way is to do it yourself which will cost well under £100 (depending on ebay). Firstly check the Central Locking Pump to make sure the hoses haven't come off. This is located in the very back right hand corner of the boot so you will need to remove the carpet and internal trim and you will see a block of sponge. Carefully lift the top off this and you will see the pump sat inside it.
Actually there is a great set of photos online to help you and I will add the link for you at the end. If the hoses are still connected and not leaking it is very likely that the internal compressor wheel has shattered (quite a common fault). I believe it is possible to open the pump and replace this wheel (in fact there is one for sale on a very popular auction site at the moment) but my own preference was to simply buy a whole new pump and replace that (£16.00 + £8 p+p off the same auction site).
The most important thing for you to remember is that when you look to buy a replacement pump you need to find one with the EXACT same serial number. The one in the diagram shown is
8LO 862 257 N but I have a sneaky feeling yours might end in an A.
Anyway, I hope this is of some help and dont worry about the connections as both air connectors and all 3 electrical ones are different sizes and will only fit in one place each. Mines a standard A4 but I would imagine evrything would be similar for the Quattro.
Good luck.
Rik

http://www.audiworld.com/tech/elec131.shtml

Posted on Aug 29, 2008

Ad
  • 958 Answers

SOURCE: Subaru Forrsester 2003 electrical fault - I think

could be the ignition key contact with accessories. all parts you mentioned are connected to the accessories.

wiggle the key and it might work again.

tnx 4 using fixya,

drcool

Posted on Oct 04, 2008

SOURCE: central locking, electric windows and

I had the same problem and it was the fuse. I don't remember the number, but it has the symbol for the dome light and that fuse also controls the windows and locking system.

Posted on Oct 20, 2008

  • 188 Answers

SOURCE: VW Polo 2000 1.4 16V Blowing fuse for Central locking / windows

car electrics are a nightmare. the car lights up when a door is open i presume. and by bypassing the central locking. the electric computer says there is a fault. and will not start. that i think is programed in. best thing to do is. go to phone VW dealer ask about diagnostic test without repair. about £35 then fix it yourself. they garentee it right I think. the dealers have come into line better with that kind of thing phone and ask anyway.

Posted on Mar 26, 2009

  • 1 Answer

SOURCE: 2004 Landrover Freelander stop/reverse light fuse keeps blowing

I had a persistent problem of hill light warning and TCS warning lights coming on for no apparent reason. There is a wire connection between the stop light switch and the control unit to let the system know when brakes are being applied. Changing the stop light switch cured it. The replaced switch was certainly sticking and the new one was of a different design. Replaced it myself as switch comes with a wiring loom. Need to get on your back under the steering wheel! Not very expensive. My car 2001 TD4

Les

Posted on Jun 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hyundai I10,problem with central locking,the lock locks itself immediately after openingclick-open and click-closed 0.5-1.0 sec.do not have time to open the door, had to remove the power door fuse


think but not sure ? you need a new door lock drivers side .would need to remove door card to check it out ,making sure that one of the mechanical levers isnt sticking .but modern cars door locks are all in one so to speak and as such not repairable .electronics ?

Dec 17, 2016 | Hyundai Cars & Trucks

1 Answer

In my Hyundai I10 there is fault with central locking, when open it unlocks and immediately locks back, it does not stay opened


the length of time that a car says unlocked is dependent on the make
most are around 30 seconds before it relocks itself
to stop it relocking just open a door and then close it and it stays unlocke d

Dec 17, 2016 | Hyundai Cars & Trucks

1 Answer

Have 2007 Camry had a flat battery now the alarm does not work what do i do. Have to lock the car with they key instead of the remote. I have replaced both batteries but the central locking does not work?


A flated battery would not affect the central lock. Mostly it is due to the improper fitting. The door locks are operated by a solenoid in each door. First check the fuse of the central lock. The fuse boxes are in engine compartment and inside the car under the steering wheel panel beside. In most cases, it is the fuse stall the car. If the fuse is OK, then check the electrical continuity. If you are not car machanic, let the proper car electric specialist to do it for you. For them, it is a very easy and quick job to do. Aso ckeck the battery in the remote if it is porperly fitted. You have to buy a Haynes Workshop Manual for Camry 2007-2011 PN 92009.

Jul 29, 2014 | 2007 Toyota Camry

1 Answer

Mazda 2 (2004) central locking and alarm fault. My


how can i find central locking in mazda premacy tell me plsss

Oct 01, 2013 | Mazda Cars & Trucks

1 Answer

Which fuse protects the interior light Hyundai i10 1.2 comfort


hi I have a hyandi i 10 2013 I am trying to fit a remote central locking . But I am having trouble with what wires to connect to where.the remote wires are black pink white green,yellow and purple. and on the switch there is only orange,black,green and brown. I would be greatful if you could help. Thanks Graham

Jan 06, 2013 | 2010 Hyundai i10 1.2

1 Answer

Hyundai i10 Steering not rotating. It seems to be locked. Pls help. The wheels were tilted to other end so, I tried to straighten by turning the steering even before starting the engine. But when I start...


Faulty Steering?
It was not until later in the day as I check the Internet for "hyundai i10" "steering locking" that I started to worry once again. I found reviews and comments mentioning that the i10 had problems with its power steering system which sometimes caused locking while the car was in motion! This post about hyundai i10 steering locking is what really caused me to get worried again. I still puzzled a bit and not sure if that was the same case as mine as in my case the locking took place while the car was at a stand still and turned off. I'll try to follow up on this carefully to see where it goes. Perhaps I should mention this issue to the agency as they service my car after the first 1000 miles (or first month of driving it).
Update: After describing the problem on an Arabic cars forum I learned that nothing was wrong with my i10. The steering locking was normal since I tried to move the steering too much while the car was turned off. As for the key not turning in with ease, the reason was that I must have moved the steering slightly after inserting the key and before turning the key. This is the method used for turning the key whenever the steering has locked. Man, I just love those forums and i LOVE the Internet.

Oct 24, 2012 | 2010 Hyundai i10 1.2

2 Answers

Both of my headlights went off. is it the bulbs or fuse?


Well, with the choices you have presented I would have to choose bulbs. Fuses do not cause electrical problems, electrical problems cause blown fuses. So, that automatically eliminates the fuse as the possible cause of your problem.

On the other hand, your problem could be caused by anything from blown bulbs to a defective headlamp control switch to a malfunctioning multiplex control unit or a bad DRL module.

Personally, I would turn the light switch on and check for power and ground at the headlamp bulb connector. If there is power and ground, then the bulb is the cause of the problem. If there is no power and ground, then you must properly diagnose your headlamp circuits to locate the fault.

Dec 23, 2011 | 2002 Honda Accord

1 Answer

VW Polo 2000 1.4 16V Blowing fuse for Central locking / windows


car electrics are a nightmare. the car lights up when a door is open i presume. and by bypassing the central locking. the electric computer says there is a fault. and will not start. that i think is programed in. best thing to do is. go to phone VW dealer ask about diagnostic test without repair. about £35 then fix it yourself. they garentee it right I think. the dealers have come into line better with that kind of thing phone and ask anyway.

Mar 25, 2009 | Volkswagen Cabrio Cars & Trucks

1 Answer

Electrical fault


Malsmed,

Does your mazda have a central locking unit in the boot? If so then follow the wiring if you can to the fuse block and see where the wiring goes into and check the problem their? If that does not solve the then check the central locking unit in the boot and the ECU unit behind the fuse box.

Hope this will help you

Oct 23, 2008 | 1998 Mazda 626

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...