Question about Seat Cars & Trucks

1 Answer

When I fold up the small back seat and put it back again, it does not line up with the bigger one next to him...

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    Visited the website for 3 consecutive days.

  • Expert
  • 108 Answers

Push it down

Posted on Apr 19, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Rear seat won't fold down (60 part of 60/40 seat)

I had the same problem on my '03. The seats would not fold down using the latch release as I had always done. So I tried a combination of pulling up on the side latch AND the top latch and the seat folded down. It really doesn't FIX the problem but circumvents offending  defective part. I will use this method until it doesn't work then I might shell out the $$$$$ to the dealer.

Posted on Jul 01, 2008

SOURCE: how to fold down back seat

There should be a loop between the seat and backrest, pull that and the seat will pull toward the front seats. After that, pull the lever located at the outside of the backrest. This lever is on the outside of the seat by the door-side of the seat. Pull that up and allow the backrest will fold down and the headrest will pivot back and your seat is folded down.

Posted on Jul 12, 2008

  • 22 Answers

SOURCE: how does the back seat fold up in a 98 chevy pick up ext cab?

There is a little loop of material hanging under the seat on both sides, pull this towards the front of the truck and the seat will unlatch to fold up.

Posted on Apr 02, 2009

  • 1077 Answers

SOURCE: 2003 Toyota Corolla LE back seat fold down? how?!

Open the back trunk, look near the top of the trunk, and pull the two black levers. They have a seat folding down symbol. That will release the locks to fold the back seat down.

Posted on Jul 04, 2009

  • 1 Answer

SOURCE: back seat (middle belt) belt stuck and unable to release.

Hi, We are having the same problem with our son's car. Were you able to come up with a solution?

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

200 Suburban. We took the seat out to haul something. My wife wanted to clean it before putting it back in. Folded the seat open and now we can't fold it down to put it back in.

Just like when you folded it down to remove it that same latch release must be use to refold it. If that does not work flip the seat face down so you can look at the locks on the side hinge point and see if both sides are releasing. If not it is a cable issue. These can be released by hand but if re installed you will have a very hard time removing the seat again. Good Lock. If all else fails and you don't want to spend a lot go to the junk yard for advise or a paint shop they deal with this all the time.

Aug 12, 2015 | Chevrolet Suburban Cars & Trucks

1 Answer

How to fold down rear seat on Porsche Cayenne

Remove headrest, there is a small button on the base of the headrest mount you need to push in. Next pull up the strap at the front of the seat cushion bottom, then flip forward. Press in the flipper on the top of the seat back and pull forward.

Sep 06, 2014 | 2009 Porsche Cayenne

1 Answer

How do you fold the back seats on a nissan tino 2001

You do it from behind. Pull the handles on the LEFT and RIGHT and push up

Apr 09, 2013 | 2001 Nissan Almera Tino

1 Answer

How to remove a rear seat of a 2007 Chrysler 300 SRT8

1- pull up on the front edge of the seat cushion to remove it; it is held in by spring loaded fasteners
2- if you also want to remove the rear backrests, you need to remove the smaller one first by folding it down and removing the two screws from the bracket and then it just slides off of a pin attaching it to the bigger seat back. the bigger section is removed last the same way.

Mar 26, 2013 | Cars & Trucks

1 Answer

2008 Ford Expedition rear folding seat in down position will not come up

More then likely the electric motor is failing, going up puts allot more load on the small motor. Have a dealer check this and confirm my guess.

Oct 30, 2012 | 2008 Ford Expedition Limited

1 Answer

On a '97 jeep grand cherokee limited, do the back seats lay forward? If so, how do you put them down? Thank you.

On each side of the back seat (the part you sit on), there is a loop. Pull this up, and the seat cushion will swivel up towards the front seat back. Visible at the lower corner of the seat back, is a lever that tou can pull up ( the earlier versions needed to be pushed down or back). The seat back will then fold /down/forward. The headrest must be removed so that the seat back can fold flat. The headreat can be removed by turnibg the small knob at the base of one of the head rest shafts. There is a small arrow indicating the direction of rotation to accomplish this.

May 09, 2011 | 1997 Jeep Grand Cherokee

3 Answers

I have a 4 door 2000 Chevy Malibu and the back seat is supposed to fold down to make a larger cargo area. I believe the latch is located on the trunk side of the back seat but I can't find it. Can anybody...

I have one and after climbing allll over the car, its in the trunk. 2 strings you can hook your fingers through. you pull on them. They are located at the front, just where the trunk hinges open, in the middle. I was annoyed by the "should" answers because I still had to crawl all over my back seat and then finally into the trunk before I just randomly started pulling and pushing things haha.

Apr 06, 2010 | 2000 Chevrolet Malibu

1 Answer

My trunk won't open

should be a button or lever or pull tab somewhere along the top of your back seats that allow them to fold down..... and your trunk should have an emergency release lever inside the trunk

Sep 09, 2009 | 2005 Nissan Sentra

1 Answer

Cant fold down the rear seat in our 1997 Chevy Tahoe

in the middle of the seat cushions in the back of the seat there is a little loop, pull that loop forward and that will have the seat's bottom pulled down to the floor agains the back of the front seats. Next simply apply a lil muscle to the back of the back seats and the seats should fold down nicely into the open space. Be sure to remove the headrests so the seat will fold all the way down. post any issues u may have.

Mar 31, 2009 | 1997 Chevrolet Tahoe

1 Answer

Just got an 2002 Chrysler Voyager. I can fold down the rear bench seat using the black lever on it but can't find a lever, or other release device to fold down the middle bench seat. How can this seat be...

i dont think they were meant to fold down but you should be able to take them out to haul bigger items. some of the vans they make are made that way so that you have to remove the seats rather than fold them down

Dec 06, 2008 | Chrysler Voyager Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Seat Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

77514 Answers

Adam Truesdale

Level 3 Expert

485 Answers

Are you a Seat Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides