Question about Pontiac Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
open the trunk and look up under the speaker area there r two straps located there pull on these straps one for each back seat then the seats will let down
Posted on Jan 02, 2009
If the seat belt light comes on intermittently with the belt buckled, it may have a bad switch in the buckle or a loose connection @ the switch. This may also set a diagnostic trouble code in the srs control module & keep the srs airbag light on.
Posted on Mar 27, 2009
It's under the hood, on the driver's side, under a square, black box with a lightning symbol on it. Loosen the flower-shaped screw that holds the lid of the box down, remove the lid, flip it upside down and when you look at the inside of the lid, you'll see a map of all your car's fuses. There's also a fuse diagram on the very end of the dash, but it's accessible only when you open the driver's side door. When you're driving, that end of the dash is blocked by the closed door.
Posted on Jul 01, 2009
On W-Body vehicles, the front seats are secured to the floorpan by
two front hook attachments and two rear bolts installed to nuts welded
to the floorpan.
The manually operated two-way front adjusters provides only fore and aft movement of the seat. When the seat adjuster handle located on the front seat is pulled up, the seat adjusters unlock, permitting travel of the seat. When the seat is in the desired position and the seat adjuster handle is released, the seat locks in place.
A power operated six-way seat adjuster is available. The adjusters are activated by three 12 volt, reversible, permanent magnet motors with a built-in circuit breaker. The motors are energized by a switch bolted on the seat side panel.
The three motors drive the front seat and rear vertical actuators and a horizontal actuator. When the adjusters reach the limit of travel, torque is absorbed through the rubber mounted grommets located between the motor and the support. An overload relay is provided in the circuit and will open should excessive stall be applied.
The optional 60/40 split bench front seats have seat back head restraints on the driver's and passenger's seat back. The head restraints are designed so they cannot be removed from the seat back without first inserting a small rounded tool inside the head restraint support tube to release the locking tab. The 60/40 split bench seat is equipped with a reclining mechanism on both the driver's and passenger's side. The recliner lever is located on the outboard side of the spring cushion. When the lever is pulled upward, the spring loaded dual linear reclining unit located in the cushion frame is released, allowing the seat back to be pushed rearward or allowing the spring loaded reclining unit to bring the seat back forward.
Bucket seats are equipped with manual reclining mechanisms. An optional six-way power seat adjuster is available. Some bucket seats are equipped with inertia seat back locks. This system allows the seat back to fold forward without requiring the occupant to release a locking lever or access to the rear seat area. During a sudden stop or deceleration, or if the front of the vehicle is nose down, the inertia system of the seat back lock will engage, holding the seat back in its rest position. A release lever is provided to allow manual release of the seat back lock when the vehicle is in the nose down position. The release lever is located at the lower rear outboard corner of the seat back.
Some W-Body vehicles (notably Pontiac coupes) have passenger front seats equipped with an E-Z Entry device. This is actuated, in an unoccupied seat, by completely folding the seat back forward disengaging the adjuster, and sliding the front seat forward to gain access to the rear seat area. To return the seat to its normal position, return the seat back to its rest position, and slide the entire seat rearward, engaging the adjuster.
W-Body rear seats are available in several styles including a rear seat with an integral child restraint device.
Posted on Sep 01, 2009
Check the connector on the cylindrical motor under the seat. You can see it from the back seat well. The connector has a tendency to come loose because of stuff pushed underneath the seat.
Posted on Jan 10, 2010
Tips for a great answer:
Apr 23, 2014 | 2000 Pontiac Grand Prix
Jan 10, 2014 | 2004 Pontiac Grand Prix
Oct 19, 2011 | 1999 Pontiac Grand Prix
May 03, 2010 | 2005 Pontiac Grand Prix
Nov 29, 2009 | 2007 Pontiac Grand Prix GXP Sedan
Oct 13, 2009 | 2004 Pontiac Grand Am
Oct 07, 2009 | 2005 Pontiac Grand Prix
Aug 16, 2009 | 2004 Pontiac Grand Prix
Dec 31, 2008 | 2004 Pontiac Grand Am
14 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: