NOISE WHEN LETTING OUT CLUTCH WHILE IN GEAR

Can't push clutch pedal in - JeepForum.com

www.jeepforum.com > ... > TJ Wrangler Technical Forum

Dec 11, 2010 - 7 posts - ‎3 authors
Driving home last night and the clutch pedal falls to the floor. ... Forums > TJWrangler Technical Forum > Can't push clutch pedal in ... Comes back up but then Ican't push it back in at all, even trying to stand on it, won't budge. Clutch locking up?
10 posts
Jul 30, 2011
Clutch Pedal Frozen Need tech help
10 posts
Sep 8, 2009
Clutch pedal stuck in the up position.
6 posts
Jul 26, 2009
Any more to clutch adjustment?
10 posts
Nov 28, 2008
More results from www.jeepforum.com

1998 Wrangler Sahara - Won't go into gear! Help please! - Jeep ...

www.wranglerforum.com/.../1998-wrangler-sahara-wont-go-into-gear-h...

Oct 5, 2010 - 22 posts - ‎7 authors
With the engine off, i can push the clutch in, and shift through all the gears ... to move - the clutch isn't disengaged even with the pedal fully depressed. .... Also, trying to bleed the system, can't find the bleeder screw. .... 1991 Jeep Wrangler Stuck In Gear? jeffasel, YJ Tech Forum, 5, 10-19-2010 09:42 AM. Getting difficult to push clutch pedal down, HELP
20 posts
Jun 17, 2011
How to bleed my clutch Be spacific.
11 posts
Feb 26, 2011
Clutch Problem?
30 posts
Jun 22, 2010
My Clutch Problems and How I Resolved Them
8 posts
Jan 28, 2009
More results from www.wranglerforum.com

You have a clutch slave cylinder failure and the reservoir is empty. Replace the slave cylinder and bleed the air of the system after refilling the reservoir.

Checked the clutch fluid level in the slave cylinder?

maybe your forks and or linkage is bad or not right for your ranger depending on what kind of kit you got hope this helps

I hope its your release bearing, but I had this same issue with my Audi and it turned out to be I need a new transmission, the gears are not catching it sounds like. your synchros may also be off. Does it do this in every gear, and once it does move, does the clutch slip?

you will have to remove the trans for inpsection, i suspect the release bearing is stuck on the tranny out put sleeve

One of three things 1) All the hydraulic fluid was suddenly lost from your clutch - check the fluid reservoir level under the hood on the fire wall bulk head 2) the clutch lever or release bearing has broken 3) the clutch diaphragm spring on the clutch plate has broken These last two can be checked by waggling the end of the clutch lever but any repair requires the transmission to be removed. Might be a good time to change the clutch and bearing while you are it.

clutch is broke need new clutch ..........expensive parts plus labour?

your clutch may be shot(the clear fluid was most likely from a hydrulic assist line)i do believe you have a hydrulec clutch

The clutch has rusted to the flywheel drive the truck down the road you will have to start it in gear (1st) while driving push the clucth pedal to the floor and keep pushing up and down on the gas pedal to get the truck to rock forwards and backward the clutch should brake loose.