SOURCE: 03 TOYOTA RAV 4 CRANKS
have scanned if light is on. it may be a bad or failing crank sensor. for the sensor controls timimg, it will stop engine while driving. have a good day!!
SOURCE: Ran over immobilizer gadget for
2000 its aftermarket two ways remove the alarm and do away with it or find the switch to turn it off its either a small red button you press as you crank to start the engine or its a small micro switch. Better yet remove it. go under the dash you will have to remove the panel to access the relay find where the aftermarket alarm installer spliced into the ignition switch follow the wire colors thhere cut it and restore it back the way it was two colors from ignition will now match there use a but connection or solder the wire back together and wrap electrical tape to protect it from shorting out.or you can just drive it to a shop that know how to repair and remove the alarm you need two person . some one in the car and someone direct the starter by jumping the solenoid to battery with thhe ignition in the on position and someone in the vehicle so it doesnt take off and run you over
SOURCE: I just purchased a 2008
If the smart key battery gets low to where it won't start the car you can hold the smart key with the logo facing the start button close to the button then push it to start the engine.
SOURCE: how do i reset the security lock on a 2008 ponthiac torrent
Go to this link for help. Unfortunately this is a very annoying problem that gm has known about for a long time...
http://vatspasslockpasskeysecurityhelp.yolasite.com/
SOURCE: charged battery on 1997 Toyota Camry now immobilizer will not lock doors and car will not start
Here is the reset procedure:
1. Have the Valet Button in the OUT position. ( It is located on the dash panel left of the steering column)
2. Connect the battery - the alarm will sound.
3. Put the key in the ignition and turn to the ON position,
4. Push the Valet Button to the IN position.
The alarm will be reset, and the Valet Button will glow red.
Move the Valet Button to the OUT position again.
Repeat steps 3 & 4 and the Valet Button will become unlighted.
The car will start and everything will be fine.
22 views
Usually answered in minutes!
×