Question about Cars & Trucks

Open Question

I need to know the prices for the 2 plastic roof,and 9 of zinc. 5 mts large x 1.20 wide, thanks Marlene

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Zinc roof of house leaking badly


Call a roofing company for a free estimate.

Feb 27, 2017 | Cars & Trucks

1 Answer

Doorhandle


for passenger side:
1. unclip screw cover 'center flap' of inside door opener plastic cover, flap is 3/8"x 3/8" (center of plastic cover)
2. remove phillips screw now showing
3. push fabric panel (edge of door opener plastic cover-at hinged end of chrome handle) to allow uncliping of edge of plastic cover (top rt & lwr rt (for passenger side) of plastic cover)
4. open chrome inside door handle to allow plastic cover to be removed-slide plastic cover toward rear, free end of door to remove cover
5. remove switch panel-gently pry with wide non maring pry bar (cover wide blade screwdriver using cloth) do rear of sw panel 1st (don't pry front edge)
6. slide switch panel toward rear to allow removal
7. remove large phillips screw under sw panel
8. remove the 2 plastic covers near top, hinge edge -use plastic spoon handles to encourage caps to pop off. May also require small screwdriver approx 1/8" in to complete pop off
9. remove the 2 phillips screws w/ captive washers
10. remove 3 phillips/hex screws along the bottom inside of door panel
11. on outside/rear edge of panel push the 2 center pins of each in about 1/8"-this allows the clip to be pulled out w/ pin pushed in
12. remove plastic cover (REAR OF SIDE MIRROR)-pull window edge up and back.
13. lift rear of door panel (not hinge edge) up allow hinge edge to pivot around lower pin in door (hinge edge)
14. remove the 2 rt edge "L" brackets (gently pry center plastic pin out) (note the color and replace as removed)
15. slowly peel the clear plastc away from the non hinged end to expose the plastic panel with 3 phillips head screws
16. remove the 3 screws and panel for access to door handle.
17. using access area now available unlatch the rod attached to exterior door handle (unclip plastic to rotate clip up to allow rod to slide out-toward hinged edge)
18. using access area now available remove rod from ext door handle from inside door area
19. remove the 3 -10mm head bolts
20. remove the ext door handle (bottom edge out first)
reverse order to replace door handle

Mar 24, 2014 | 2003 Toyota Avalon

1 Answer

Replace park bulb.vt commodore


To replace the front parklight globe on a vt commodore can be a little tricky.

1.turn the lights on to see which 1 is inoperative once you know turn lights off.
2.open bonnet
3.go to side that is inoperative and on the back of the headlight you will see a round large plastic cover turn this to release it.
4.under the headlight globe there will be 2 wires flow these to the park globe socket gently twist and pull it out.
5.once the sockets out and you can see the globe ,pull the globe out of socket.
6.push new globe into socket
7.refit the socket in headlight
8.refit all trims
9.turn lights on make sure new globe is work..

Jan 22, 2014 | Cars & Trucks

1 Answer

Hi When i try to open the roof (full - cabrio) i


I had the same problem and the solution is very simple. The 2 plastic pieces near the back seats which open widely (on the right and left from the seats) are stuck with the roof during the opening. All you have to do is gently push them out with your hand and the roof will open normally.

Jul 07, 2011 | 2006 Volkswagen Eos

1 Answer

2000 ford explorer, fuse box don't show me what fuses are for


There are two fuse boxes. A baqttery junction box under the hood on the drivers side and one inside on drivers side. Good luck.


Fuse/Relay

Location

Fuse Amp

Rating

Power Distribution Box

Description

1 60A** I/P Fuse Panel

2 40A** Blower Motor Relay

3 50A** 4 Wheel Anti-Lock Brake System

(4WABS) Module

4 30A** Power Windows, Power Moon

Roof, Power Seat

5 50A** Ignition Switch, Starter Relay

6 20A** Transfer Case Relay

7 - Not Used

8 20A** Air Suspension

9 40A** Air Suspension

10 30A** PCM Power Relay

1 10A* A/C Relay

2 30A* Heated Seats

3 30A* Heated Backlight

4 15A* Fog Lamps and Daytime Running

Lamps

5 4 3 2 1

10 9 8 7 6

12 11 10 9

8 7 6 5

4 3 2 1

15 14 13

2 1 1

9

6

10

8

7

5

4

1

3 2

175

MEGAFUSE

Roadside emergencies

197

Fuse/Relay

Location

Fuse Amp

Rating

Power Distribution Box

Description

5 - Not Used

6 10A* Powertrain Control Module

7 30A* 4 Wheel Anti-Lock System

(4WABS) Module

8 15A* Rear Wiper Motor

9 20A* Fuel Pump Relay and RAP

Module

10 15A* Horn Relay

11 15A* Parklamps Relay and Mainlight

Switch

12 30A* Mainlight Switch and

Multifunction Switch

13 15A* Heated Oxygen Sensor, EGR

Vacuum Regulator, EVR Solenoid,

Camshaft Position (CMP) Sensor,

Canister Vent Solenoid

14 30A* Generator/Voltage Regulator

15 - Not Used

1 - Wiper Park Relay

2 - A/C Relay

3 - Wiper High/Low Relay

4 - PCM Power Relay

5 - Fuel Pump Relay

6 - Starter Relay

7 - Horn Relay

8 - Rear Wipe Down Relay

9 - Blower Motor Relay

10 - Rear Wipe Up Relay

1 - Not Used

1 - DRL Diode
2 - Electronic Engine Controls Diode

Apr 06, 2011 | 2000 Ford Explorer

3 Answers

How to change the battery in a 2000 venture


1. Remove the rubber hood gasket at the base of the windshield along the car-right side by pulling up on it
2. Pull up and remove the triangular plastic shield in the car-right rear corner of the engine compartment
3. Remove the rear bolt on the large diagonal bar holding the fuse box
4. remove the two front bolts on that diagonal bar, and the other nearby car-right bolt holding the front of the plastic shield to the front rail
5. Pull up and right on the large bar and fuse box to position it out of the way to expose the battery
6. remove the bolt and spacer at the rear lower base of the battery
7. first remove the negative battery cable (8mm), then the positive cable
8. pull the battery out
9. swap the thermal cover onto the new battery, remove protective terminal caps (if there), and reverse the procedure to reinstall the new battery. Always install the positive cable before the negative to avoid welding your wrench to the car.

Nov 06, 2009 | 2001 Chevrolet Venture

1 Answer

One side of my panoramic roof will not close. Help !


One of the plastic clips have broken, you can google a fix for that, I did mine not too hard to do. Price aprox 75$

Aug 04, 2009 | 2005 BMW X5

1 Answer

Saab 93 convertible 1999, how do you refill hydraulic roof


To check the oil level open the boot - at the very back remove the 4 plastic clips that hold the carpet in place. Slightly to the left of the center there are 2 holes - shine a light in the bottom and look through the top one to check the level.
To add oil - fold down the seat backrest. Remove the plastic trim - held on by 4 screws and 2 pop out plastic cllips. Undo the 8 large bolts that hold the cover in place - 2 on top and 3 on front and back.Then lift up the cover from the front edge. You will then be able to get to the resevoir - you will need a funnel to poor fluid in.

Jun 27, 2009 | 1995 Saab 900

1 Answer

How wide is the rear cargo space in a Chevrolet HHR Panel


it's not that wide. i rented one a year ago to drive home from the airport. while it was a pretty cool looking vehicle it only impressed me as much as a cavalier or cobalt does. it's not that wide in the rear. it might fit, but i'd check to see if there's specs online or stop by your chevy dealer. the HHR is not a work vehicle. you're better off with an s-10 or colorado.

May 15, 2008 | 2007 Chevrolet HHR Panel LT New Cars

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...