Question about 2004 GMC Envoy

1 Answer

2004envoy stalls looses power dies idling - 2004 GMC Envoy

Posted by on

  • Ryan Lutton
    Ryan Lutton Apr 17, 2017

    Hello, did you recently disconnect the battery for any reason?



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    Uploaded 5 video answers.

  • Expert
  • 50 Answers

Clean the Throttle motor bore.

Posted on Dec 22, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2004envoy starts fine going down road stalls looses all power but dont die turn off and starts back up and runs fine and then out of nowhere stallls again

How is your air filter element?
Dirty fuel will do the same.
Check those and if is ok test spark plug leads and coil.
Stop using ethanol if you are.

Apr 16, 2017 | Cars & Trucks

2 Answers

Saturn vue will start but will only stay runnuing about twenty minutes then stalls wont start

Does the car loose power before stalling or does it simply die without warning? If it loses power first, you're likely looking at a fuel pump or fuel system problem. If it just dies, you probably have an ignition problem. Does the check engine light come on before it dies?

Jan 07, 2015 | 2003 Saturn VUE

1 Answer

My 89 f-150 300,000 miles starts great runs great with good oil pressure never been hot loses power at times and will die when idling. the check engine light comes on immediately when this happens and

check all vacuum hoses for deterioration /hard /loose. Check power brake booster for air leaks with the foot on the brake (idle will drop or stall)

Nov 22, 2014 | 1989 Ford F 150

1 Answer

Motor shuts off when started up,shuts off when driving.

hot engine or cold, or both? 180F+ is hot.
Shuts off, idling or on the fly, say at 30mph right foot down it dies?
just clue here...
engine stalls. is complex. but in the macro its below, using tools finds the reason,, but you never said did it restart easy./??????
1: lost of engine compression hot engine, (or overheated)
2: lost 12vdc electric power at stall (caused it) dash goes dead. ?
3: lost spark, test spark at the failure point. if dead trouble shoot speak.
4 bad fueling, too lean (say the fuel pump dies) or too rich.
too rich causes wet spark plug tips. (lots of causes )
5: stalls due to idle RPM too low, below 800 is too low.
too low idle rpm is caused by many things, but top 2 are.
A: EGR stuck wide open, clean it, as the books shows at 60k miles
B: ISC stuck closed. (same deal clean it)

now repost and say when it stalled,
at a read light or flying up a hill wot, wot= wide open throttle.
and when it dies, is the restart easy or hard.

Dec 05, 2013 | 1997 Jeep Grand Cherokee

1 Answer

1995 ford stalls intermittantly

check for a bad/loose ground wire in the battery or where it connects to the engine or chassis

Jul 31, 2017 | 1995 Ford F350

1 Answer

Car stalls when in idle

You need a tune-up. Not a major problem, and it will fix all your problems. Please don't forget to rate this answer.

Feb 23, 2010 | 1995 Toyota Camry

2 Answers

Idle problems with the car it stalls then dies

leak in the air hose would send to much oxygen to the engine and causing a stall

Oct 07, 2009 | 1988 Buick Riviera

2 Answers

Fiat uno struggles to idle on its after i have warmed it up using

Would this be the 1108cc or 1372cc model Uno ? You will find the vacuum advance unit attached to the distributor. Check the pipe connection from the vacuum advance to the carburettor - loose or damaged. This is normally the main cause for uneven idling/stalling. Alternatively the carburettor needs adjustment via the carburettor idling screw. Hopefully this will help. Good luck.

Jun 09, 2009 | 1985 Volkswagen Jetta

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides