Question about 2000 Dodge Neon

Open Question

I have a 2000 dodge neon. It keeps blowing the #10 fuse in the interior fuse panel. It will run all day untill i put it in drive. The fuse is a 15amp it says LDP ABS, PTU SOL. ENG RLYS, ENG MOD.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2000 dodge neon

there are two ground wires. One by each headlight assembly on the main crossbar. One or both may be loose. Mine had the same problem found that problem tightened ground and that fixed the problem. No more fuse light.

Posted on Dec 13, 2008

  • 6674 Answers

SOURCE: dies after driving for 10 minutes

I think I'd have to gamble on a new relay, and clean up contacts in those sockets with electrical cleaner, then add dielectric grease before plugging in new one. Do the pump first obviously.

Posted on May 05, 2009

  • 957 Answers

SOURCE: starter fuse keeps blowing

Sounds like a short in the system. you will need to inspect the wiring and posably, bench test the starter. Check the cables to the battery. Make sure the wires and the battery are in good shape.

Posted on May 13, 2009

  • 224 Answers

SOURCE: 99 dodge neon # 10 fuse ing feed 15 amp blows out

There's a short in the circut. Check continuity of the wires that feed from that fuse (you'll need a wiring diagram to identify each wire). You've got something that is causing too much amperage to move through the circut and the fuse blows. Make sure the amperage on the fuse is correct for the application (your owner's manual or fuse box diagram should tell you what amperage rating to install in each fuse slot).

Posted on Jul 03, 2009

  • 12 Answers

SOURCE: 2003 Dodge Neon - fuse to dash and tail lights

there could be a short somewhere in the wires

Posted on Mar 13, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2000 dodge caravan just stopped running while i was driving. it keeps blowing the 4th 20 amp fuse counting down from the rear of the fuse block. when you use a jumper wire to bypass the fuse the van runs....

If it is like the 2000 Neon it is power to the computer and without it the vehicle won't run. That hard part will be finding the reason it is blowing because if you bypass it with a straight wire you take a chance on burning the vehicle computer out. My problem turned out to be the Alarm power wire coming free from where it had been attached at the rear of the fuse panel and brushing up against that position and causing the fuse to blow.

Sep 09, 2011 | 2000 Dodge Grand Caravan

1 Answer

Passenger headlight keeps blowing out fuse high beam ok this is a dodge neon 2000

Check inside your headlight for water. This can short out the fuse.

Sep 06, 2011 | 2000 Dodge Neon

1 Answer

2000 dodge neon keeps blowing #10 fuse 15 amp usually after engine is hot and when im turning right it blows! now as soon as i turn the key fuse blows immediately!

You may have to replace your "clock spring" in your steering wheel, this works the horn and cruise control and air bag.....Thats the only thing i can think of...when you turn your wheel....michael_cass_73.jpg

Jun 18, 2011 | Dodge Neon Cars & Trucks

2 Answers

Fuse 10 Blows every time I put it into drive. It does'nt blow in park ,neutral or reverse. Only in drive. This is driving nuts.

had same problem with a 2003 dodge neon after hours of messing with wiring found wiring harness underneath car had rubbed through rubbing against trany taped wires solved problem

Jun 04, 2011 | 2000 Dodge Neon

1 Answer

I have a 2000 Dodge Neon that keeps blowing the ignition and air conditioning fuse. It will crank, but when you put it in drive and accelerate...the fuse blows and it dies. Just before this started the...

Before you do anything else, please review this article:

Where's The Fuse?

Then I would say that the most likely cause of your problem is that the A/C clutch circuit is shorting out.

Jun 02, 2011 | Dodge Neon Cars & Trucks

1 Answer

Fuse 10 that conacts my raido and interior lights ECT keep blowing every tim i put one in

You have a SHORT CiRCUiT problem and only ur Auto Electrician can pinpoint where it is! The wire going to ur DOME light might have splintered and touch the body ground! The STEREO might have problem in its amplifier and power line thats why it kept blowing ur 10amp FUSE! Hope that might help u out! Taah!

Nov 15, 2010 | 2000 Dodge Stratus

1 Answer

I have a dodge neon 2005 lxt 70.000 mile .It just stopped running when i was driving and froze up.I had a mechanic look at it and he changed a fuse.But it happened again when I drove it 10 miles Do you...

sounds like if it keeps blowing the fuse you have a short somewhere. I had similar problem and the short ended up frying my main computer before I finally found it

Aug 30, 2009 | 2005 Dodge Neon

2 Answers

1998 dodge neon ignition feed fuse in the car keeps blowing

Are you using the same power feed from the old radio? If so, your new radio may require a higher current fuse. Check the manufacturers information the came with the custom radio and make certain the current (amps) required is the same.
If the new radio has a higher power amplifier for increased audio, it will blow a low rated fuse.
On the other hand, it sounds as though you may have pinched the power feed wire in the radio bracket, trim cover or have it resting agaist a sharp bracket. So when you put the car in drive, the dash flexes enough to cause the short.
Does it blow the fuse when you shift to reverse?
let me know.

Jul 19, 2009 | 1996 Dodge Neon

1 Answer

The tail lights and interior dash lights have quit in 95 neon

Well, check the fuse box in the engine compartment...then check the fuse on your side panel at the end of the dash...last place, Flashers are located either on the bottom of the fuse block or on a module under the dash. They are replaced by simply pulling them straight out. Note that the prongs are arranged in such a way that the flasher must be properly oriented before attempting to install it. Turn the flasher until the orientation of the prongs is correct and simply push it firmly in until the prongs are fully engaged.

Jul 16, 2009 | 1995 Dodge Neon

Not finding what you are looking for?
2000 Dodge Neon Logo

Related Topics:

95 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides