Question about Cars & Trucks

Open Question

For Jeff Armer, yes I tried another relay no results. Also checked B+ it was 12v.Thanks for your ideas. any others, Im stumped.

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 6 Answers

SOURCE: both dim headlights will not burn. brights work just fine. checked fuse and switched relays with no result. any other ideas??

Most headlights have two different bulbs: one for regular/dim and one for bright. It's time to replace your headlights.

Posted on Oct 28, 2012

Ad
  • 20 Answers

SOURCE: Jeff Armer, in a 2010 Ford Edge Limited, how does one fix the anti theft system to make the car start?

Try resting computer by taking both battery cables off for about 5 minutes

Posted on Jul 09, 2016

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the transmission control solenoid located on a 2005 chevy cavalier 2.2l


Hi Ashley Farmer , my name is Jeff Armer . Which solenoid , your Cavalier has four , Pressure control solenoid , TCC - torque converter clutch solenoid , 1-2 shift solenoid and 2-3 shift control solenoid . And all are located inside the transmission . Do you have a DTC - diagnostic trouble code stored in the PCM - powertrain control module ?

Jan 28, 2017 | Chevrolet Cavalier Cars & Trucks

3 Answers

Cranking on my 2001 4cylinder ls s10 is weak got the timing chain kit replaced every thing and still weak


Not sure what the timing chain has to do with the engine turning over, but see other post.

Jan 24, 2017 | Cars & Trucks

2 Answers

Fuel pump won't pump it's new


Did you check for B+ voltage at the pump an check the ground circuit ? Fuel pump relay in the under hood fuse box ?

Oct 06, 2015 | Cars & Trucks

1 Answer

Car horn not working


as with all elect. fails check all fuses
in this case the 15 amp fuse marked, HORN
can i presume all else works good> car drives.?
all answers, USA spec car. nobody ever tells location, so..... if not USA< all answers wrong. the usa car has just 1 horn.....
got voltage to horn? 12v
Yes or no.?
if yes horn bad.
got voltage from horn relay
yes, bad wires.from, relay to horn
no, got voltage 12v to horn relay coil,
yes, good, no bad fuse.
got 0v to other relay coil (all tests honking)
yes, bad relay.
no, bad horns switch.

if you want me to guess. sure.
1: bad wires ../connections, end to end.
2 bad horn
3: bad relay
4: bad horn switch.

Dec 27, 2013 | 2005 Toyota ECHO

2 Answers

My 2001 pt cruiser will run ten minutes stall and wont start back no fire at all but will start back up normal after a couple hours and then run ten mins and stall out have replaced coil pack cam/crank...


A mechanic would check the ASD relay and the coil for voltage when the engine will not start.
You might also want to check the computer for trouble codes.

Aug 09, 2012 | Cars & Trucks

2 Answers

I have a 1995 ford f50 that will not start with the key. Replace ignition switch, clutch interlock safety switch, starter relay on the passenger fender. I can manually jump start by crossing the pole s at...


Check the small wire going to the starter relay. It should have 12V when the ignition is in the start position. If it doesn't, you either have a bad igntion switch or a wiring problem from the switch to the relay. If you don't have a volt meter, you can use a 12V test light. Let me know if you need more help.

Aug 25, 2011 | 1995 Ford F150 Styleside Regular Cab

2 Answers

No power coming thru power wire to my stereo decks any ideas?


You have two wire of 12V + going to your stereo, one is hot all the time and one comes from the ignition switch ( which turn on the stereo when you switch on the car), if it's the +12V one which is hot all the time, you can take another wire from your car's cigarette lighter 12V outlet. if it's the ignition +12V one, you can trace back the wire to ignition switch and change the wire if it's broken.
Hope it helps and please rate the answer if it was helpful, thanks!

Mar 08, 2010 | 2003 Kia Rio

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...