Question about Cars & Trucks

1 Answer

Why only left turning signal not blinking only when headlights on? green arrow pointing left seen but not blinking. When headlights off, both turning signals work perfectly,

Nissan, Frontier 2000, Manual shift, turning signals work perfectly except when headlights on, and only left turning signal not blinking, bulbs, fuses checked and ok, turning signal macho replaced and problem not fixed

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 818 Answers

It sounds as though you have a wiring problem around that particular light/signal.

Check the black earth leads to the light and the signal - it may be nothing more than a 'bad earth' due to corrosion where the earth wire connects to metal.

Check the main power wires, too. It should be an easy fix .. make sure the wires are clean and secure

Posted on Apr 16, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My left blinker blinks very slowly and wont blink at all with headlights on, right one works fine. Also green turn arrow lights on dash when you turn on headlights?????


It is hard to say for certain without knowing the year, make, and model of the vehicle, but I would look for wiring problems in the steering column and blinker switch, especially if the headlights and blinkers are both controlled from that location.

Dec 16, 2015 | 1990 Jeep Comanche

1 Answer

WHERE ARE THE GROUND WIRES FOR THE FRONT TURN SIGNALS LOCATED ON A 1994 CHEVY C1500


try moving the wires around the socket or could be the flasher

Apr 24, 2014 | 1994 Chevrolet C1500

2 Answers

2006 ford Taurus dash lights not working and alarm when headlights are left on is also not working


If you have the owner's manual, check the chart showing which fuse is for the dash lights and that alarm. Try replacing that/those fuse(s) to see if you're back in working order. (Not sure where your fuse panel would be, but try the area under the dashboard on the driver's side.)

Nov 19, 2012 | Cars & Trucks

1 Answer

Problem with turn signal when headlight is on


this sounds like a earthing problem , so check the wiring for the head lights, see if any wires are trapped between something, bare wire touching car body , anythingthat doesn't look correct, could also be the indicator lever itself with a problem , but check the headlight wiring first

Jun 03, 2017 | 2002 Chevrolet Express

1 Answer

Turn signals do not work


This is one FLASHER fault; ?m referring to the blinker "flasher fuse", it is the bottom round fuse under the dash in the fuse block.

REPLACEMENTThe turn signal flasher and hazard units are usually located located under the dash either to the left or right of the steering column on most models.
  1. Remove the turn signal flasher unit or hazard unit by pulling them up from the electrical connection.
  2. To install, push the unit(s) into the electrical connector

Good luck (remember comment and rated this).

Apr 10, 2010 | 1989 Jeep Comanche

1 Answer

I turn on headlights and the left turn signal remains on "not blinking" I signal a left turn without the headlights and pannel lights illuminate with the turn signal


have turn signal bulbs checked, normally when one comes on and oes not flash/blink the opposite side is burnt out.

Dec 07, 2009 | 2004 Isuzu Rodeo

1 Answer

Driver side signals only work when headlights are OFF


What may have happened is either the headlights wiring or the parking lights wiring somewhere along the wiring fused to the left turn signals wiring. Depending on if the turn signals go on when you put the parking lights on or the headlights on.

If the signals come on when you turn on the headlights than you only need to locate the light green wire that comes off the left turn signal harness.

Next follow that wire the entire way back to the firewall looking for another wire fused to that wire as you go.

If there are no signs of this you need to continue looking on the other side of the firewall all the way back to the turn signal and hazard flasher unit which is a black box that connects to a black harness located next to a grey harness behind the knee bolster.

But if the signals come on when you turn on the parking lights than you will also need to check the wiring from the rear left signal and follow that light green wire all the way back to the turn signal and hazard flasher unit.

This should fix your problem, but if not than your problem may lay within the the wiring between the turn signal/hazard switches and the turn signal and hazard flasher unit.

Also you may have a burnt circuit in the junction block. This block is where the light green from the rear left signal and front left signal meet. Don't have a description but if you cannot find it let me know and I will go out to the yard and look myself and let you know.

Apr 22, 2009 | 2004 Dodge Intrepid

1 Answer

99 ford taurus headlight/blinker problem


sounds like a bad ground through one of your lights, the right front or rear turn signal bulb.

Dec 14, 2008 | 1999 Ford Taurus

1 Answer

1991 s10 turn signals


heck the ground wires for your signal lites and also remove the bulbs and see if there is any corrosion in the lite sockets ( pig tails ).

Oct 26, 2008 | 1991 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...