Question about 2006 Hyundai Tucson
It's a good idea. The filter keeps particles from the clutch plates from entering the valve body. The damaged valve body is expensive.
Posted on Apr 17, 2017
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Hyundai Tucson
The transmission filter is inside the transmission. You have to drain out the oil and remove the transmission pan and gasket. The filter is made of metal guaze and is screwed/bolted to the underneath of the valve body.
Posted on Apr 09, 2009
IF YOU ARE NOT FAMILLIOR WITH IT TAKE IT TO A SHOP.There is one and it is a very messy job you have to take trans pan off to drain fluid (tricky) and the filter is under the pan.
Posted on Apr 14, 2010
Things You'll Need:
Fuel-line disconnect tool
New fuel pump
Flat head screwdriver
Ratchet and socket
The assistance of a friend (only when you are ready to remove the back seat)
Rubber hose plugs
Two adjustable wrenches
Locate the fuse panel under the hood of your vehicle, then open it and remove the fuel pump fuse with your hands.
Start your car and allow the fuel system to depressurize by allowing the car to idle until the engine dies.
Reinstall the fuse, then disconnect the battery with a ratchet and socket. Drain the gas from the gas tank with a siphoning kit.
Remove the back seat by unbolting the base with a ratchet and socket and lifting the seat out with your hands. The bolts are located on either side of the seat near the base. You will also need the assistance of another person to lift the seat out safely.
Remove the wiring harness by gently pulling it from the connector, and detach the rubber grommet with a flat head screwdriver. Unbolt the fuel tank cover with a ratchet and socket, remove it with your hands, pull the wires through the grommet, detach the fuel line hoses with a fuel-line disconnect tool, and lift the hoses out. Cap the hoses with rubber hose plugs.
Reach directly into the gas tank, then remove the fuel filter using two adjustable wrenches, placing one on either side of the fuel filter. You will recognize the fuel filter by its filtering paper cartridges.
Install the new filter, then follow the previous steps in reverse to complete the installation. Refill your gas take when finished
Posted on Feb 10, 2011
Testimonial: "thaks Question: why I need a new fuel pump ? its necesary to change fuel pump too ? thanks again"
You didn't say if this vehicle was Automatic Transaxle or Manual Transaxle. No need
here are two photos: One is Manual, the other is Automatic. The manual trans has a separate switch (all by itself), however, the automatic (of both the 4 cylinder and 6 cylinder) use the trans range switch to provide power to the back up lamps
Hope this helps
Posted on Feb 16, 2011
Tips for a great answer:
Feb 19, 2015 | Hyundai Tucson Cars & Trucks
Nov 16, 2012 | 2006 Hyundai Tucson
Apr 03, 2017 | 2006 Hyundai Tucson
Apr 20, 2010 | 2006 Hyundai Tucson
Nov 17, 2009 | 2006 Kia Sportage
Jun 12, 2009 | 2006 Hyundai Tucson
Jun 05, 2009 | 2006 Hyundai Tucson
61 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: