Question about Cars & Trucks

Open Question

I need a new operation panel for my. Window A/C where can I get one

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


if its cable operated i bet the cable has snapped or the cable has come off the runners u might need a new window regulator, its probably why the window has been held in the closed position with the piece of wood, hope this helps

Oct 07, 2016 | Cars & Trucks

1 Answer

Rear passenger and passenger front window can not be opened at the drivers controll

You need to take it apart the contacts need to be cleaned .
When the window is open water gets in their is corrotion
I do it to mine once every 2 years use denatered alc leaves no residue.

Feb 27, 2015 | 2008 Lexus Rx 350

1 Answer

Windows will not operate--don't know where fuse panel is

donot force the power windows if they arent working.The motor inside the door that operates the motor probably is jammed.The fuse must be behind the glove compartment near ECU fuse panel.if the Window fuse is bad then put a new one of the same rating.If that goes bad too, you need to check for three things.first check the window panel if it isnt short.if thats ok then you should check the window motors they are probably jammed and are putting too much load on the fuse to operate.lube them with WD 40 , also the window channels.if the problem fixes nothing to be done further.if fuse go bad again , you need to check the window panel wiring that might probably be short at some point.

May 09, 2011 | 1995 Jeep Grand Cherokee

1 Answer

The drivers side power window will go up very slow or get stuck and stop completely when trying to put the window up, the back side of the window seems to come off track.

Sounds like you need to replace the window regulator inside the door. It is the scissor like apparatus that the window rides on. If the power window motor is weak it also might need replaced. I would first take the door panel off and inspect it. Then I would spray and lubricate all the moving parts to make sure they aren't binding up. Operate the window with the panel off and look for smooth operation. The plastic bushings that ride in the metal track of the window regulator break or wear flat on one side. Through my experience they make it so you can't just replace the bushings. A window regulator and motor will cost you anywhere between $175 and $300 dollars new depending on where you go.

Mar 27, 2011 | Honda Element Cars & Trucks

2 Answers

1991 oldsmobile cutlass supreme drivers side window keeps coming out of track, how do I fix

generally the door panel has to come off. With the panel removed you can see the tracks. There is an adjustment for each track, and you can observe the action of the window in the track as you operate the window. slacken both track adjustment bolts if fitted, operate the window untill fully up, tighten each adj bolt and operate the window through the cycle. Make any further adjustments as needed. When correct install the door panel, and recheck the operation of the window.

Good luck.

Jan 31, 2011 | 1991 Oldsmobile Cutlass Supreme

1 Answer

Driver side window will not operate. All other

check switch if good and nothing slipped under switch than need to remove door panel to test motor

Apr 08, 2010 | 2007 Chevrolet Equinox LS New Cars

1 Answer

Passanger window wont roll all the way up and makes noise and slips from it's position.

Window is misaligned/off track. Temporary solution; With door open, have 2nd person operate window while you press on glass from both sides. Guide window to full up position. Complete repair requires removal of inner trim panel (see my solution for trim panel removal). With panel off operate window (2nd person if needed). Observe window tracking movement. Look for broken loose parts inside door. If needed, observe correct operation of functioning door. Usually (if no parts damaged) glass needs to be loosened when fully up. Then correctly aligned in track. Then re-tightened.

Jul 10, 2009 | 2000 Honda Accord

2 Answers

My passenger side window doesn't roll up and it slides down into the door

Before the failure, did it make any knocking or griding noises? When you operate the button does the motor make it's normal noise? Did the window become loose and fall down inside the door abruptly? Some vehicles have issues with the "window regulator". This is the cabling device that hoists and lowers the window on the inside rail. Some automakers use plastic bits to keep the window on the rail. If those become loose or break, the window will fall off the tracks. Continued operation of the window will cause the regulator (cables, gear or motor) to fail. If you want to attempt a DIY fix, remove the door cover (a mechanic will usually call this a door card) and see if the window is off the rails. Good luck.

Jul 06, 2009 | 1999 Jeep Grand Cherokee

4 Answers

Door window on 2000 jaguar s type

take off inner door panel, lower track and put the window back in. If parts on track are broken buy new ones. Use urathain to reinstall window.

Jul 28, 2008 | 2000 Jaguar S-Type

1 Answer

Power window problems

Repair procedure: REAR POWER WINDOW MOTOR INSPECTION 1. Remove the rear door trim panel. (Refer to BD group-Rear door) 2. Disconnect the 2P connector from the motor.f07bc65.gif 3. Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

Jun 16, 2008 | 2000 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14398 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides