Question about Jeep Cars & Trucks

Open Question

Electical fault on my jeep 1996 - Jeep Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont start/turn over clicks when turn key/battery good


If the battery is good as you state. then the starter must be at fault, if you can reach it give it a light tap with a hammer and try again. if this fixes it you need your starter replaced or repaired.

Jan 17, 2013 | 1996 Honda Accord

1 Answer

Red flashing engine light 1997 jeep 4.0 liter


First I suggest scanneing the PCM (computer) to find fault codes stored there; note this codes for additional details.

Dec 06, 2012 | 1996 Jeep Grand Cherokee

1 Answer

Just Had truck serviced oil ,lube,etcHas 99115 Miles ,Check Engine light comes on


The check engine light is on because the ecu has detected a fault in on of the sensors of your jeep. Have the trouble codes read from your jeep to determine which sensor is bad.

Feb 21, 2011 | 1996 Jeep Grand Cherokee

1 Answer

JEEP CODES P1391 AND P1398


p1391= crankshaft / camshaft position sensor intermitant signal, check, wiring, connections & sensors
p1398= engine control system missfire detection limit reached probable causes, wiring,poor connections,engine mechanical fault,ignition/fuel system fault (causing misfire) or camshaft/ crank shaft position sensor

Jun 04, 2010 | 1996 Jeep Grand Cherokee

1 Answer

I need the fault codes 12 21 51 for 96 jeep cheroke 4.0


have the p0 codes pulled. they stopped listing the 2 digit ones in 95

Apr 26, 2010 | 1996 Jeep Grand Cherokee

1 Answer

The dash lights are not working in my 1996 Jeep Cherokee. How do I fix this problem?


Had same problem with my 1996 Jeep, fuse 25 kept blowing. It was a short circuit in the transmission selector case. Seems to be a design fault where the wires for the light there, cross over a steel bar and get worn down every time you move the selector from park to drive and back. Bit of elect' tape fixed it.

Mar 21, 2010 | 1996 Jeep Grand Cherokee

1 Answer

Shuts off while driving


check out the cars alarm first, a fault in this would cut off the engine,,,and removing the battery lead just resets it every time

Feb 19, 2010 | 1996 Jeep Grand Cherokee

1 Answer

1996 jeep cherokee 4.0 shuts off while driveing. think it is afuel problem?


on this engine the most common problem is the crankshaft poistion sensor (CKP sensor), it will set a fault code in the computers memory, so have a local autozone or kragen test the system for the crank sensor code.

Oct 20, 2009 | 1996 Jeep Grand Cherokee

1 Answer

1994 jeep chrokee lights wont come on


I believe that you have checked the fuses and bulbs by now.A common problem is the headlight switch that you use to turn them on.It plays up and will stop all the lights from working.Get it checked as a starting point.Its a cheap item and is easy to replace.A good auto/elect. will be able to help you if needed.Hope this helps

Oct 04, 2009 | 1996 Jeep Cherokee

3 Answers

1996 Jeep Grand Cherokee - Will Not Start or Run


they have crankshaft sencers on the transmission on jeeps. it would be up high on the drivers side on front of transmission. they will cause it to not get fuel or fire and can run then quit.

Jul 19, 2008 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...