This is a manufactures bulletin
Inoperative Right Front Door Switches
This bulletin involves replacing the right door interior
handle. The loss of ALL functions may occur when attempting to control them from
any of the switches located on the right door due to electrostatic discharge
through the right door interior handle. The right door interior handle must be
replaced to protect the switch module from static electricity. The new handle is
more resistant to electrostatic discharge.
2004 - 2008 (CS) Pacifica
The vehicle operator may experience a permanent
loss in ability to actuate ALL of the following functions from the right door
Power door locks.
Right power mirror.
Right power seat adjustments.
Right power window control.
Right heated mirrors.
Memory functions associated with the listed systems on right side (if
Loss of communication with the right door switch module to Scan Tool:
Perform a "Hard Reset of the
right door switch module. This may be accomplished by removing all power
(including memory keep alive power) from the right door switch module by
unplugging the module power connector. Alternatively, vehicle power may be
interrupted by removing the negative battery terminal when the ignition switch
is in the OFF position. If after performing the hard reset functions of the
right door switches return perform the Repair Procedure.
Disconnect the negative battery cable.
Remove the right door trim panel
Remove the door tweeter speaker. Refer to the service information in
TechCONNECT. Refer to 8 - Electrical > Audio > Speaker > Removal (Fig
Remove the power seat switch. Refer to the service information in
TechCONNECT. Refer to 8 - Electrical > Power Seats > right Seat Switch
Replace the right door interior handle, p/n 05170261AA, as described on
Mopar Instruction Sheet K6855628 included in the handle kit.
Install the power seat switch.
Install the door tweeter speaker.
Install the right door trim panel.
Connect the negative battery cable.