Question about Cars & Trucks

Open Question

I need systematics and or pic of a silanoid on a kalbelco lc300 mark4 trachoe the solenoid was stolen.wires cut, So no factory connectors are available. Thanks

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 108 Answers

SOURCE: can't find wiring connector for a 2001 ford taurus

dont do it they do make a kit and its about 80 bucks u have an amp in trunk near antenna it involves running wires to the trunk i have kit for 98 i am not sure if ur car is same body style if so email me at mikes84vette@yahoo.com

Posted on Mar 27, 2009

Ad
emissionwiz
  • 76682 Answers

SOURCE: replacement radio

no codes but not just any radio will fit in the dash, contact these folks for advice and help picking the right radio.

http://www.crutchfield.com/S-h7kThgkJtQZ/

Posted on May 12, 2009

  • 71 Answers

SOURCE: 1987 Mercury Sable won't turn over.

I don't know if there is a free wiring diagram available, but to turn the engine over you will need to purchase or build a bumper switch. A bumper switch can be easy to build and relatively inexpensive. Get two gator clips and a bumper type toggle switch. Connect about three foot of wire to each side of the switch, this will create a broken circuit. Locate the ignition wire which is on the starter, since there has already been a lot of damage to your wiring, one more cut won't hurt. Clip this wire and skin it back and connect one gator clip and then connect the other gator clip to a hot battery, this will create a complete circuit. Switch the car on and push the button, it should turn the car over if the starter good. If the starter doesn't turn over then that may be your whole problem.

Posted on Jul 22, 2010

skychief2001
  • 21873 Answers

SOURCE: Need a pic to show me which is the intake heater core hose on my '97 Lumina. Which hose do I cut to install a flush kit? Thanks!!

Technically it does not matter which heater hose you use.
When the garden hose is attached to the tee fitting, and you open the drain for the radiator, clean water will flow thru the cooling system with the engine running.
Keep in mind you may need to take the thermostat out to get flow without the engine being hot.

Posted on Sep 15, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need stereo color wiring diagram for 1995 Chevy Astro Van. Old radio stolen.


Easiest to replace would be the factory Delco AM/FM CD...plug in to existing terminals. If wires cut, you should include the plug in terminals with the replacement radio...Local Pic-A-Part is my go to salvage yard radio $25-$75...Walmart also sells radio wire install kits...$14.95? Hope this helps.

Apr 21, 2016 | 1995 Chevrolet Astro

1 Answer

Location of purge silanoid 4x4 jimmy


The Purge Solenoid has a 2 wire connector with a dark green/white wire, and a pink wire.

If you are interested, here is a wiring diagram:

moz-screenshot-1.pngpctech1_4.gif

This is the purge solenoid/valve:
pctech1_6.jpg

I believe it is located within the circled area:
pctech1_7.jpg

Feb 17, 2011 | 1997 GMC Jimmy

1 Answer

Sometimes starter will not work unless i short the silanoid


Either the wire from the ignition switch to the solenoid is bad, or the solenoid itself is bad.

Sep 25, 2010 | 1978 Chevrolet Chevette

1 Answer

Need to wire up disel pump on vw golf


the stop solenoid is on the diesel pump some of them were covered by a steel cover which u have to cut off to see the solenoid and then one of the wires that was goin to the immobillizer is from the ignition put it on the solenoid and it will start

Apr 02, 2010 | 1996 Volkswagen Golf

1 Answer

How do you disconnect the daylight, lights?


This is hard to explain without pics, but I will give it a shot: Just under the the steering wheel is the DRL (daytime running lamps) with a big white connector inserted into the backside of it. This connector has many wires. You need to locate the black/yellow wire. Cut the wire, and insert a swtich in between the two cut ends to enable/disable the DRL. This link has a great how-to instruction

Procedure:
Cut the Pin 12 Black/Yellow Stripe wire to disable the DRL "circuit"
operation. A switch can be installed inline between the two separate Black/Yellow Stripe wires for manual DRL operation if desired.

I just did mine over Christmas and it works with no problems.

Mar 16, 2010 | 2001 Toyota 4Runner

1 Answer

We replaced the starer and there is a problem with a ground in the front next to the firewall that is a ground strap and is on a post when i put the wires on the battery the cars silanoid comes on with out...


sounds like your hooking your starter up wrong.
put the main battery wire on the solenoid side for the battery and the igniton wire on the s for starter no the field. once the igniton is turn on 12 volts to the small
igniton wire on the solenoid causes a magnetic fields and connets the starter lead to the battery hot or positive animating the starter.

Feb 10, 2010 | 1995 Jaguar XJ6

2 Answers

My car was stolen and some one cut all the wires


reconnect the wires buy buying but connectors and connect the wire to each color coded wire. match up green to green black to black black with green stripe to black with green stripe. You can go to www.alldatadiy.com to look at the wiring codes, cost $24.00 for one year for your car. if your not able to use a pair of wire crimps then you may wat to take it to a shop.

Aug 30, 2009 | 2001 Ford Mustang

1 Answer

92 t bird starter silanoid wiring


One Big Wire Goes Each Big Post On The Relay And Others But The One With The 90 Degree Connector Goes On The Wire Post That Comes Off Battery The 90 Degree Connecter Plugs Onto The Same treaded Post

Jul 10, 2009 | 1992 Ford Thunderbird

2 Answers

1993 Ford Explorer battery was stolen and they cut all the cables


which wires ? the ones connected to the battery? or the wiring harness? if it's the battery cables then the large wire is the positive side normally red and the negative side is black and is half the size of the positive wire. The battery will have a + and a - on it so you know that the positive wire is + the larger wire and the smaller is black.

Mar 28, 2009 | 1993 Ford Explorer Limited

1 Answer

1994 nissan altima gear shift lockout problem


replace the brake pedal switch, it is mounted in front of the brke pedal, this is what makes the silanoid work, if it is not working the silanoid will not.

Nov 16, 2008 | 1994 Nissan Altima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...