Question about Mitsubishi Endeavor
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If you have the silver-metal valve cores, on the rims, there is NO reset proceedure. Under the valve cores is a transmitter, which is battery powered. It sends a "yes/no" signal to the tire pressure ECM. Note that ALL 5 tires transmit to the ECM. The signal is "at or above" the specific target pressure needed, or is is below the target pressure. What to do: get a GOOD tire pressure gauge, not those cheap ones that look like pencils. Set the tire pressures to the specification, INCLUDING the spare. Your light should go out. If not, there is the possibility that one of the sensors is innoperative, and that will involve a trip to the dealership, to get it replaced under warranty. Try the tire pressure resetting, adn don't forget the spare. Get back to me if this works. Glad to help, and thanks for choosing FixYA.
Posted on Nov 11, 2008
After you adjust the tire presuure you must drive the vehicle for a few miles then look at the gage again/ you can also disconnect battery for 15-20 minutes. Please rate my response Thank you very much
Posted on Jan 28, 2009
SOURCE: low tire pressure idiot light
Your nissan also has a tire monitor on your spare tire if your spare has low pressure and the other 4 tires have correct pressure the light will stay on . after you ajust the spare also the light should go away.
Posted on Mar 24, 2009
Some newer Toyota vehicles have a sensor in the spare tire. Tires loose air over time naturally. I would check out the spare.
When did this TPS light start coming on?
Have you had new tires put on, or had a flat repair done before the light?
Posted on Apr 28, 2009
Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.
Posted on Jun 08, 2009
Tips for a great answer:
Apr 30, 2013 | 2011 Land Rover Rover Range
Jan 08, 2013 | 2011 Toyota Highlander
Aug 12, 2011 | 2005 Mitsubishi Endeavor
Jan 14, 2011 | 2005 Mitsubishi Endeavor
Jul 24, 2010 | 2006 Mitsubishi Galant
Sep 01, 2009 | 2006 Mitsubishi Endeavor
Dec 15, 2008 | 2007 Mitsubishi Endeavor
33 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: