Question about Cars & Trucks

Open Question

I have a courage 20 the engine skip cranks but if I remove the sparkplug it cranks over?

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My ford expedtion rition xlt 5.4l v8 is skipping what could be the problem?

possible vacuum leak or coil also make sure connectors to the coils are attached properly

Oct 08, 2015 | Ford Cars & Trucks

1 Answer

I think i lost the spark engine just cranks over but does not start

then just check if you have spark at any of the sparkplugs...

1. remove one of the spark plugs,
2. re-connect the cable
3. make contact between sparkplug anode and engine (have rubber gloves - it helps... there is 15kv on the sparkplug...)
4. turn engine and check if there is spark in

you can check that on all/any cylinder

if there is no spark - check:
1. starter fuse
2. ignition fuse
3. coil
4. distributor cap if mechanical...

hope this will help you - do not forget to vote...

Feb 22, 2015 | Cars & Trucks

1 Answer

Check engine light on engine cranks but wont start and there is no spark coming out from sparkplug

The check engine light is most likely a misfire code. You need to check your coil packs for supplied voltage. If you have 12 volts supplied, check your ground to the packs. If your ground is good then most likely the coil pack is pad.

Jul 29, 2014 | 2000 Mitsubishi Galant

1 Answer

Kohler courage 6.5hp wont start?

Could be a short in the coil for the sparkplug. Check the magneto- pull the plug wire off the spark plug and hold it close to the frame of the while someone tries to start it. Keep all parts of your body clear of the mower- only hold the sparkplug wire. When the motor turns over, verify spark from the wire to the frame. If no spark, you likely have a bad magneto coil. If you have a good spark, try taking the air filter off and use some engine starter fluid (not much) and then try and start again. If it starts and runs for a second with the starter fluid, you probably have a problem with your fuel not getting in, which leads to troubleshooting the carb and intake.

Apr 26, 2014 | Cars & Trucks

2 Answers

My 1994 v6 nissan pickup idles rough and seems to skip some at idle when driving it runs fine I can't tell it it skips or not I have replaced sparkplugs sparkplug wires belts fuel filter and coil but it...

Check your exhaust manifold. A blown gasket or even a small crack in the manifold may cause this. Its also possible that your airflowmeter is faulty

Apr 07, 2014 | Cars & Trucks

4 Answers

Will not start, what do I look for first

Are ou getting a spark at the spark-plug, and then check to see if fuel is getting to the cylinders.... Please say the year and model, and whether fuel injected or carburetor.... then I can further diagnose.

remember to rate the answer.

Dec 26, 2010 | Ford E-150 Cars & Trucks

1 Answer


this sounds like a tuneup is needed, if you have the 4cylinder engine then replace the sparkplugs the boots and the coilhousing, the coil housing is the part thats holding the coils when you remove the top cover it on the bottom of it. good luck.

Sep 04, 2010 | 2002 Pontiac Grand Am

1 Answer

'79 Chevy van has been in storage for five years. How do I get it running again?

Start by cleaning the fuel tank (water from condensation accumulates in it), clean the fuel lines, clean and adjust the carburettor, drain the old oil, remove the sparkplugs,put some fine oil in the cylinders and crank the engine manually, put new oil,oil filter,sparkplugs,distributor cap and air filter, replace the water and start the engine. Check for leaks, run the engine for an hour followed by an oil engine cleaner.

May 22, 2010 | 1979 Chevrolet C/K 3500

1 Answer

Car cranks but won't start

first thing is to check for spark, remove a sparkplug, insert a screwdriver and place near aground crank engine and see if it sparks, if you have spark then its a fuel problem, if theres no spark then check the cap ,rotor and disturbutor, also make sure your timing belt didnt break, remove upper cover and spin engine cam gear should turn, well start there, hope this helps.

Dec 07, 2009 | 1997 Toyota Camry

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14403 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides