I need torque settings for a Toyota corolla 1,6 3zz engine

This manual has everything but cam torque

http://www.championbrands.com/aera-torquespecs.pdf

Head, crank, flywheel, rods. The hole engine? What torque setting you looking for. You can call your parts place they can tell you.

cant find the repair manual for that

which torque specs are required

suspension
use "all others" as a guide
http://www.rockfordcv.com/Toyota_torque.htm

of what the whole car.?
that is in the factory service manual (FSM)
or alldata.com


which engine,? lots of 1.6l MADE BY TOY?
NOT 4AFE (ended in 2001)
state side, we had 3 engine, non are 1.6L
the 1NZ-FE 1.5L
the 1ZZ-FE and 2ZZ-FE both are 1.8L
so what country are you in, ?
find true engine name (under hood,read stickers)
and google for that, I promise you will find it.


9th generation corolla
the e120?
world wide, (not USA) they had
1.6L I4 3NZ-FE
1.6L I4 1ZR-FE
1.6L I4 3ZZ-FE

as you can see 1.6L tells nothing.
only the real name works , getting specs on any engine.
do tell.

Get a Hanes manual from PepBoys for your vehicle.You'll find all your answers there.

main bearing
tighting in the following stages:
22Nm then 44 Nm then 45 degree then 45 degree
big end bearing
20 Nm then 90 degree

Normally the torque settings should be in your manual? If not , try call any Toyota Servic/Dealership centre.

cylinder head bolts:

step one: 22 Ft-lbs.
step two: tighten additional 90 degrees
step three: tighten additional 90 degrees

torque setting for crankshaft,head,rocker,

hey, torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:

9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10