Question about Cars & Trucks

Open Question

Auto will not always go into reverse - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 99 jeep Cherokee i am trying to fix my reverse light i dit change the assambly and ligth buld and still not working can tell me what is goin on


99 XJ jeep, gas or diesel, i GUESS GAS and USA XJ jeep.
auto or stick we can not guess transmissions here EVER.

the a/t box, (auto)
uses a device called TRS/PRNDL or reverse switch.
to glow the lamps in the rear, fuses checked first.
you never said both are dead., dim or stuck on.>?
chapter 8w-51-5 (Gas) covers this. the book is free.
click Cherokee.
click wiring, behold a real matching schematic on your car.
no working blind, now.
the fuse.J10 is the backup fuse in the JB, cab box, 15amp.
that be always 1st first.
key on
in reverse
the backup switch has 12vdc in and 12vdc out
then that one wire goes to rear of car and lamp glows
if the lamp is ground,(both) BR-Lg 12vdc to all lamps
black wire is ground and 0v, in reverse.

real book not FAKE!
http://www.morris4x4center.com/knowledge-base/index.htm?utm_source=cj#service

Mar 05, 2017 | Jeep Cherokee Cars & Trucks

1 Answer

Vs auto have forward gears even in reverse any ideas please


A4LD stuck in forward, even while in neutral and reverse. - Ford ...

https://www.explorerforum.com/forums/showthread.php?t=216567

May 27, 2008 - 19 posts - ‎5 authors
I did find a thread that referred to an "always in a forward gear" A4LD problem, ... Eventhough band adjustment should not have anything to do with the .... in the transmission and then it auto shifts through the gears normally.

700r4 forward in all gears, even neutral, no reverse - Third ...

www.thirdgen.org/forums/.../631383-700r4-forward-all-gears.html
Oct 21, 2011 - 700r4 forward in all gears, even neutral, no reverse ... It has no reversebut when I put it in reverse it tries to pull the motor down like the rearend ...

my car is not moving forward or backwards even with gea


Dec 27, 2015 | Cars & Trucks

1 Answer

My A160 Benz semi auto having problem with trnsmission can not engage forword or reverse.


when a transmission is in drive it will always try to drive. even with the foot on the brake it is still trying to drive.
Run the fault codes for the transmission as I suspect there will be a problem in the torque converter clutch/ servo/solenoid .

Jan 03, 2015 | Cars & Trucks

1 Answer

No reverse till truck warms up


I am assuming the oil and filter is OK and that leaves just the pump. Check and see if the transmission has two pumps and if the oil for reverse is picked up by the drive gears is the same that picks up fluid for the reverse. If not that then it could be a solenoid or something sticking in the valve body. If the same pump picks up fluid for both then look for a solenoid that controls reverse. It could be on the outside and easy to replace. If you go to a local auto parts store they can look it up and probably tell you for sure what the problem is. Auto Zone is very helpful in these matters.

Mar 06, 2014 | 2002 Chevrolet Silverado 1500

1 Answer

Won't go into reverse. have to wait 2-4 min. to go into reverse sometime wait longer. of course the truck has a auto trans


Sounds like the torque converter is malfunctioning... or the trans is about to go... ( reverse always seems to go when a trans is gone bad).
Of course there could be an issue with a shift solonoid sticking too... hard to tell without a better discription...
does anything happen? I mean any noise... or shaking or anything while the waitting is going on?

Oct 06, 2010 | 1992 Toyota Pickup

1 Answer

1991 ex auto. rough idle when shifting into a reverse or drive. not in P or N though


always start any trouble shooting by checking fluids so check your tranny fluid first then get back to me replace as needed lol

Jan 19, 2010 | 1991 Honda Accord

2 Answers

Transmission hesitates going into reverse only!


Solenoid Pack in the transmission is going out of it. I have put two in mine...both under warranty in my 2000 Explorer

Mar 05, 2009 | 1991 Ford Explorer

2 Answers

My reverse is gone what do I do?


the "sun shell" or reaction shell broke inside the transmission< if you notice 2nd gear is also gone or working funny. Transtar makes a hardened shell that costs about 40$ but you need to remove the transmission to fix it, and overhaul is best. The burnt fluid smell is because the torque converter has been slipping when you are on the highway, sonex makes a repalcement valve that should be installed by a train proffessional. Solution is rebuilt trans with new converter and parts i have listed in the paragraph

Feb 21, 2009 | 1995 Chevrolet Blazer

1 Answer

Reversing light dosent always work


Hi ddsnail123,
What you could be dealing with here, is a bad earth connection, or just as likely, a sticking or defective reverse lamp switch ( you'll find that on the gear box. If it's a manual it will have two cables and if it's an auto, it will be on the main gear selector switch)....The other alternative is, that the lamp holders or the connectors may be corroded inside and require cleaning or replacement....

All the best Johngee10

Sep 01, 2008 | 1999 Daewoo Nubira

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...