Question about Kia Cars & Trucks

Open Question

How do I replace my shifter cable on my 2003 kia rio.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 35 Answers

SOURCE: Replace Ignition Coil - Kia Rio 2002

must dismantle all wires and battery...

Posted on Sep 24, 2008

  • 1 Answer

SOURCE: My 2003 Kia Rio Cinco back hatch latch handle is

We had the same problem.
I took out the bolts outside, then crawled into the back area of the car, and took a screw driver, and slid it along the inner hatch catch, and found the safety latch and released the hatch. Then I took the inside off, and disconnected the handle device from the inside. It was rusted, and broken. I went to Kia, and bought a new one and reinstalled, after greasing the new one up. Took me a while, but they wanted 280.00 in labor, so it was well worth it.
Just be patient and go slow. A good metric socket set will be the best thing, with a regular and phillips screw driver.
Good luck
David

Posted on Jun 24, 2009

  • 1 Answer

SOURCE: Keys locked in 2003 Kia Rio Trunk

Go to the dealer they can give a copy of the key. Do not forget to bring personal ID and ID identication for car.

Posted on Aug 21, 2009

  • 137 Answers

SOURCE: How do you replace a brake light bulb in a 2003

You open the trunk and go to the side that needs the brake light replaced, behind the light is usally 1 or 2 plastic twist bolts, undo then and the whole brake assemble sould come out the turn the light left or right then pull straight out and replace the bulb

Posted on Jan 24, 2010

arauzvictor1
  • 466 Answers

SOURCE: knock sensor replacement

Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.

Posted on Mar 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What must i strp inside my kia rio 1.4 2013 to change my gear shift cable that snapped


Dimanche T bar shifter and console it should bolt to the end of T bar and unbolt at gear selector.

May 25, 2015 | 2013 Kia Rio

1 Answer

How do I replace the clutch cable on a 2003 Kia Rio?


they are really easy to do the end just goes into a little hole then it just goes agains the stop inside the hole they are really easy to do , look on youtube you may find your answer there

Jan 19, 2015 | 2003 Kia Rio

2 Answers

Why does my 2003 Kia Rio have hard time going into 1st, 2nd, & sometimes reverse? Unless I press REALLY ******* clutch.


The clutch system in the Kia rios of those years are clutch cables, not hydraulic. There is no need for clutch fluid. Have a mechanic look at your clutch cable tension.
If it turns out to be a tranny prob thank Korea for building cheap cars.

Jun 29, 2014 | 2003 Kia Rio

1 Answer

Camshaft sensor for 2003 Kia Rio causes check engine light


I would guess a wiring issue. Check all the cabling and make sure all connectors are nice and snug with no signs of corrosion or burnt.

May 05, 2013 | 2003 Kia Rio

1 Answer

2003 Kia Rio manual transmission, stick is stiff g...


I would check the operation of the shifter cable. It may need lubricated.

May 20, 2010 | 2002 Kia Sedona

3 Answers

Need to find free resources regarding 2003 Kia Rio Cinco Manual


here you go 11 is shift rod end oem# ok2n117423 , 16 shift rail , 18 snap ring , oem # ok30a17486 22 arm 42155448

Feb 17, 2009 | 2003 Kia Rio

1 Answer

Can not get it to go from Park to Drive. Is there a shift Lock on the 2003 Rio?


simple...look at the shifter and you will see on the side a button. just push down or move forward then you can start the car and shift into gear.

Jun 17, 2008 | 2003 Kia Rio

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...