Question about Cars & Trucks

Open Question

I have no side light or rear light or lights in the clocks everything else works fine ? this is on a 2014 lexmoto arrow

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
cursealoud
  • 42 Answers

SOURCE: All rear lights went out, brake lights work

Might be the multifunction switch on the steering column. Also called a combination switch.

Posted on Aug 18, 2008

Ad
  • 6 Answers

SOURCE: arrow warning lights on dash?

The W button stands for weather or wet, if the button is pushed the arrow apears on the dash and the vehicle is in a wet traction mode. The arrow also comes on if you are in a lower gear than drive

Posted on Jun 17, 2009

  • 15 Answers

SOURCE: turn signal and brake light

check the plug in the trunk lid mine did that and the plug was completely disconnected, yours may just be loose, or have a broken wire

Posted on Jul 20, 2009

jmgldsmth
  • 1889 Answers

SOURCE: The drivers side rear brake light/turn signal only not working

you replaced the bulb with the wrong one i.e. a two filament bulb with a one filament bulb

Posted on Oct 05, 2009

  • 1857 Answers

SOURCE: 1995 ford Windstar LX: Driver

go to mitchell1diy online for the diagnostic procedures. Your going to have to take the door panals off and you will need a electrical tester.

Posted on Aug 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 mercury grand marquis clock don't work but everything else does. How to fix it?


In dash clock display not working ' 4.6L Based Powertrains ...

www.crownvic.net > ... > 4.6L Based Powertrains

Feb 21, 2006 - 2 posts
On my 95 MGM with almost 145k miles, the in dash clock stopped displaying when ...1995 Mercury Grand Marquis 204k - Sold 08/11 - Gone but not forgotten! ... SteveS: Idon't see poll manager in replies, except north central. Airbag Light and No horn = clockspring? ' Body and ...
10 posts
Feb 27, 2014
Horn No Longer Works ' Body and Interior
10 posts
Nov 12, 2010
Cruise control stopped working! ' 4.6L Based ...
15 posts
Apr 20, 2008
setting clock in 89 crown vic ' Box Tech
9 posts
Nov 13, 2006
More results from www.crownvic.net

Dec 25, 2015 | Mercury Cars & Trucks

1 Answer

How to set clock in radio on a 2014 Jeep Patriot


Clock Setting Procedure 1. Press and hold the TIME button until the hours blink. 2. Adjust the hours by turning the right side TUNE/ SCROLL control knob. 3. After adjusting the hours, press the right side TUNE/ SCROLL control knob to set the minutes. The minutes will begin to blink. 4. Adjust the minutes using the right side TUNE/ SCROLL control knob. Press the TUNE/SCROLL control knob to save the time change. 5. To exit, press any button/knob or wait five seconds http://www.chryslercommercialvehicles.com/jeep/download/pdf/manuals/2014-Patriot-OM-1st.pdf page 240

Mar 12, 2015 | 2014 Jeep Patriot

1 Answer

No dash lights when headlights are turned on. Everything works fine on my vehicle EXCEPT today the panel lights don't work. Turn signals, hazard blinker, oil gauge, rpm gauge, speedometer, drive shift...


there is a regulator for the display brightness, you may have it turn'd down or it has stopped working;. it controls the brightness at which the dash lights are. usually has a speedo sign on it. goes up and down. it works with the main light and is conecter to them on the same lighting board if it has gone then a new light swtch control switch will be needed.

Oct 13, 2013 | 2001 Chrysler Town & Country

1 Answer

No break lights, tail lights or blinker on passenger side


check fuses with a tester. just because they look good can be missleading

Oct 05, 2009 | 1989 Jeep Cherokee

2 Answers

1998 Chevrolet Monte Carlo brake lights do not


check blubs if the center light works should be working side brake lights

Sep 07, 2009 | 1998 Chevrolet Monte Carlo

1 Answer

Warning light for broken lights is on, but everything is fine


Are you shure there might be little light back there your missing that burned out.
Could be a short try replacing the rear lights.
It happen many times on hondas and jeep i had
the bulbs make short cause all kinds probelms take a few bucks new light and take out and put the side and put in new light see it works

Jul 26, 2009 | 1995 Toyota Previa

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...