Question about Mitsubishi Cars & Trucks

Open Question

I have a mitsubishi 2007 raider v8 having trouble shifting and skiping gears. so i used the scan tool and it show me two codes. PO871 and PO733.

I assume its the transmission shift solenoid I couldnt figure out where are they located at on the transmission. I need help to located the transmission shift solenoid.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 321 Answers

SOURCE: shift solenoid relay.. internal or external?

Trans model is the 4L60E,and the shift solenoids are mounted on the valve body,just inside the bottom pan.There are 2 shift solenoids,one EPC solenoid (Electronic Pressure Control)One TCC PWM solenoid (Torque Convertor Clutch,Pulse Width Modulated),one 3-2 kickdown solenoid,and a manifold pressure switch.As far as a shift solenoid relay switch,i have never heard of that.The power for the transmission solenoids comes through the ignition switch ,and uses a fuse,not a relay.Accessing the solenoids only requires dropping the bottom pan,and the valve body does not have to be removed,to change the solenoids.The shift solenoids are the TWO solenoids right side by side and look identical..They are the only two solenoids inside the pan that are in fact identical.Good luck.

Posted on Sep 28, 2008

tommyboinow
  • 324 Answers

SOURCE: 1994 nissan altima gear shift lockout problem

replace the brake pedal switch, it is mounted in front of the brke pedal, this is what makes the silanoid work, if it is not working the silanoid will not.

Posted on Nov 26, 2008

  • 82 Answers

SOURCE: 2002 Lincoln LS V8, gear shift shows E, check transmission light

sounds like tranny computer is bad take it to a grage and have a computer put on it cost about $50.00 to do this

Posted on Feb 23, 2009

  • 412 Answers

SOURCE: trouble with the transmission solenoid

USUALLY A SHIFT SOLENOID DTC IS REPAIRED BY REPLACING THE TRANS SOLENOID PACK ASSEMBLY..LOCATED ON OUTSIDE OF TRANSMISSION..YOU MUST BE CAREFUL WHEN CHANGING PACK..CLEAN ALL DIRT/DEBRIS FROM OUTSIDE OF PACK..YOU DON'T WANT ANY DIRT TO ENTER TRANSMISSION..SOLENOID IS A SMALL BOX LOCATED ON SIDE OF TRANS FACING FRONT OF VEHICLE..YOU MUST REMOVE TRANS COOLER LINE HOSES FROM FITTINGS ON TRANS..REMOVE INPUT SPEED SENSOR..UNPLUG PACK..8MM SCREW HOLDS IT..3 BOLTS HOLD PACK TO TRANS..YOU MUST CLEAN ALL GASKET RESIDUE THOROUGHLY BEFORE INSTALLING PACK..I'D RECOMMEND GETTING SOMEONE WHO HAS DONE THIS BEFORE IF YOU ARE NOT COMFORTABLE DOING THIS..I HOPE THIS HELPS

Posted on Dec 30, 2009

dttech
  • 4803 Answers

SOURCE: Where is the Transmission Solenoid

The TCC solenoid is located inside the transmission. Replacing the solenoid usually does not fix the problem when it comes to a P0741 code. It is usually due to debris getting caught in the TCC regulator valve or the tubine shaft seals being worn out. This usually results in a transmission overhaul.

Posted on Dec 27, 2010

Testimonial: "You are 100% correct.I did end up getting an overhall"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Engine light goes on after get it fixed for same problems for 4 weeks.


what was the problem?it might seem that the same problem recures after being fixed,use the diognosis scan tool to know exactly wher the problem is before fixing it again.

Nov 16, 2014 | 2007 Mitsubishi Raider LS

1 Answer

Raider wont go into gear


My MITSUBISHI RAIDER IS NO GOING IN REVERSE WHILE IN REVERSE SHIFT Is in GEAR

Dec 27, 2013 | 2006 Mitsubishi Raider

1 Answer

I have a 2007 Sebring with 61k miles. I was told by dealer that it has two codes P1790 & P0733. It shifts hard when going to higher gear. Please help.


We use the site as you do ,we have no info
Use Google to look up the codes
2007 Sebring OBD Codes P1790 & PO733
With the transmission code park it & don't use it
Hopefully you haven't used it at all, even ten miles
or you will ruin the trans.
Why would you go to a dealer, be given codes & they
let you leave or you decide to leave the dealership?
You could take it out of there to a local shop
for further diagnoses of the codes, but to drive
it,that is asking for trouble

Aug 02, 2013 | Cars & Trucks

1 Answer

I have a message (air condition no connected)in my car LEXUS VG 470 v8 model 2006 and i can't read the trouble code with scan tool please help


You need a professional scan tool to read
body codes & the correct software
for asian vehicles, as well as enhanced data

Mar 08, 2013 | Cars & Trucks

1 Answer

I have a 2004 stratus and the transmission drops into low and the engine light comes on,. I have several codes that are stored PO740,P0841, PO733, PO871, PO700, and PO562 (sysem low voltage). Would this be...


I doubt it is the computer but its possible.
Code 740 is a problem with the lockup torque converter.
Code 841 is a low-reverse pressure switch problem.
Code 733 is a third gear ratio error.
Code 871 is an overdrive pressure switch problem, and code 700 is the generic code that means there is a problem with the transmission or the trans control module.
You would need to clear the codes and drive it again.
The codes that return would need to be checked to find the problem. It could be in the wiring harness too. If all of the sensors and switches check out ok, then the module would be suspect.

Feb 09, 2013 | 2004 Dodge Stratus

1 Answer

Sometimes truck will not shift into 2nd gear for awhile. does not matter if cold or hot


If it's an older truck it needs a vacuum modulator, if newer there is an electrical modulator that controls shift points. Replace the unit.
murf427

Aug 02, 2012 | Mitsubishi Raider Cars & Trucks

1 Answer

My 2000 Saturn sl1 recently showed codes po733 and po734.What exactly does this imply and where would I start if I wanted to try fixing the problem myself?


po733- gear 3 ratio incorrect, po734- gear 4 ratio incorrect. this is how to fix. You can try replacing the shift solenoids inside the transmission as long as the trans fluid is nice and clean looking. If the trans fluid is dark or burnt looking, it time for a new tranny if you need further assistance please let me know and i will be glad to assist you. Thanks, Midwest-Tek

Aug 28, 2010 | 2000 Saturn SL

1 Answer

Need to know what this trouble code means for 2007 chrisler 300 2.7 litre v6 code PO871


Hi,

The P0871 is for the overdrive clutch's pressure switch. All pressure switches are inside the solenoid pack.

Let me know,if needed further assistance

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

May 27, 2010 | Chrysler 300 Cars & Trucks

1 Answer

Code Reads PO733 & PO734, car runs great but these two codes show up when I check it out on my scanner. Any help or advice?


po733- gear 3 ratio incorrect, po734- gear 4 ratio incorrect. this is how to fix. You can try replacing the shift solenoids inside the transmission as long as the trans fluid is nice and clean looking. If the trans fluid is dark or burnt looking, it time for a new tranny

Mar 01, 2010 | 2002 Saturn S-Series

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...