Question about 1996 Isuzu Rodeo

2 Answers

Replace highbeam 1996 rodeo

How do you replace the highbeam on 1996 zisuzu Rodeo

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 202 Answers

U open the hood, Put your hand behind the light unscrew it lefty loosing right tightly change the light bulb. The bulb has for low and High beam so the bulb has two elements when u take the old one u will see one is burnt

Posted on Jul 24, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Isuzu Master
  • 2,984 Answers

LIGHTING Headlights REMOVAL & INSTALLATION Non-Aerodynamic
Fig. 1: Replacing a sealed beam headlamp

replace highbeam 1996 rodeo - bd06397.gif

  1. Disconnect the negative battery cable.
  2. Remove the front grille and/or headlight bezel.
  3. Remove the headlight bulb retaining rim, headlight and disconnect the wiring.
  4. Before installing, spray some silicone grease into the bulb socket.
  5. Connect the wiring and install the bulb.
  6. Install the retaining rim and grille.
  7. Adjustment: turn the adjusting screw (A) for vertical adjustment. Turn the screw (B) for horizontal adjustment.
Aerodynamic

Fig. 2: Replacing a headlamp bulb

cf46ef4.gif

Posted on Jul 24, 2009

  • Greg Bernett
    Greg Bernett Jul 24, 2009

    Fig. 3: Replacing a headlamp bulb







    1. Disconnect the negative battery cable.
    2. Open the hood and disconnect the headlight bulb electrical connector.
    3. There are two possible designs. For the first design, turn the bulb to remove it from the housing, for the second unscrew the retaining cap and remove the bulb.
      WARNING
      Do not touch the glass portion of the halogen bulb. Any contamination on the bulb may cause the bulb to burst when turned ON. If the bulb is contaminated, clean the glass portion with rubbing alcohol.


    4. Hold the bulb by the plastic portion only. Install the bulb and connect the wiring harness. Make sure the sealing ring is in place.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How can l remove back door on my 1996 Honda passport door from inside.


How To Install Replace Fix Broken Rear Outside Door ...

? 9:52
https://www.youtube.com/watch?v=bUV6BZfVxDY
Jun 15, 2011 - Uploaded by 1A Auto Parts
1A Auto shows you how to repair, install, fix, change or replace a broken .... The outside door handle is broken on my HondaAccord and the child ... How To Install Replace Broken RearOutside Door Handle 1996-00 Honda ...

Can't open rear door - Car Forums and Automotive Chat - Automotive ...

www.automotiveforums.com > ... > Isuzu > Rodeo ' Passport ' MU
Can't open rear door Rodeo ' Passport ' MU Car Forums. ... The driver side rear door on my 95 Rodeo won't open. ... You can remove the door panel without opening the door. ... I've got a 96 Rodeo and the DS RR door was stuck as well. ... I went to aHonda dealer (lack of ISUZU dealers in my area) to get the part, it only ...

Oct 30, 2015 | 1996 Honda Passport

1 Answer

How many highway mpg does 4wd v6 1996 rodeo get?


Gas mileage is nothing to boast about. One test Rodeo averaged just 13.9 mpg. Here is where I got that information. Hope it helps! http://consumerguideauto.howstuffworks.com/1991-to-1997-isuzu-rodeo-6.htm

May 09, 2011 | 1996 Isuzu Rodeo

1 Answer

How can you tell if the timing chain on a 96 4X4 Rodeo needs to be replaced?


I have a 1997 3.2 L Rodeo. This vehicle, and yours too actually uses a rubber timing belt that is suggested by Isuzu to be replaced every 60,000 miles.

It is not a difficult process,and takes about 6 hours to complete.

Feb 24, 2011 | 1996 Isuzu Rodeo

2 Answers

Is the 1994 Isuzu Rodeo v6 compatible with the 1997 Isuzu Rodeo as far as engine parts...alternator, MAF sensor..etc?


go to the rockauto.com site and compare part numbers for each year and see if they are the same.

Sep 08, 2010 | 1997 Isuzu Rodeo

2 Answers

Is it necessary to take the timming belt off to replace the water pump on a 1996 isuzu rodeo


3.2L engine, you will have to remove timing belt to replace water pump, your water pump is timing belt driven, I would replace timing belt while in there, good luck, hope this was very helpful.

May 14, 2010 | 1996 Isuzu Rodeo

1 Answer

Does 1996 rodeo motor will fits 2000 rodeo isuzu


THE 1996 RODEO HAS A 2.6 - 3.2 ENGINE. THE 2000 RODEO 2.2 - 3.2 ENGINE.LOOK LIKE THE 3.2 ENGINE WILL FIT.IT HAS SAME 3.68 BORE X 3.03 STROKE.

Feb 21, 2010 | 2000 Isuzu Rodeo

1 Answer

Can i take a motor from a 1994 rodeo with a 3 coil pack ignition system and put into a 1996 rodeo with a 6 coil system


no dont do it... i made this mistake. they switch wire harnesses in 1996 so if you do it you will have to redo the entire top end of the motor

Feb 20, 2010 | 1996 Isuzu Rodeo

2 Answers

1996 rodeo no start


Is the ignition fuse okay?

Aug 01, 2009 | 1996 Isuzu Rodeo

1 Answer

Water pump replacement 96 isuzu rodeo


Remove belt, fan, fan shroud and fan bracket. Remove timing covers, timing belt and water pump. Replace timing belt and the hydraulic tensioner with new ones. I suggest you get a mechanic to do this as you can easly get it out of time. Not an easy job.

Jul 03, 2009 | 1996 Isuzu Rodeo

Not finding what you are looking for?
1996 Isuzu Rodeo Logo

378 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14380 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...