SOURCE: 1999 buick regal
hi when you say hits a bump which wheel is it that hits the bump or is it the ront end hits a bump or rear and what did the fault codes say and what makes you think its not the sensors yates210456
SOURCE: abs & traction light on 1997 buick lesabre
This is a fairly common problem, Gm has actually issued a service bulletin regarding this repair. The problem probably originates from one of your wheel speed sensors that is mounted inside one of your front wheel bearings. To be sure, you need to have the car scanned to find out which one and then you have to replace the whole bearing assembly because the sensor is integral to the bearing. The bearing is not hard to do but you will need some professional tools if you want to do it yourself. At a shop it should cost between 3 and 400 dollars complete.
SOURCE: while on hilly road with lots of bumps and potholes, brakes fail
check brake fluid level if LOW good indication brakes are due.
SOURCE: After hitting a bump or pothole, my vehicle
Hello. you have either a poor solder joint or a loose connection within the systems effected. The best route to go is this. look in the yellow pages under auto electric repair shops. have them put your yukon on their diagnostic equipment to pin point the problem. J.
SOURCE: 2001 Buick Lesabre ABS light stays on even
What this means is that the abs module is seeing a problem in the abs system.This has nothing to do with the regular brakes.What you need to do is get the codes from the abs module and this will help in finding what could be causing the light to come on.When the abs light comes on the regular brakes will work normally but your abs brakes will be disabled.Let me know what codes you find and I can help or explain what the cause could be.Good luck.
109 views
Usually answered in minutes!
×