Question about 1998 Chevrolet Blazer

1 Answer

Front wiper will not work, back does, only find 1 fuse are there 2, its a 98 Chev. blazer

Posted by on

  • dwpowpowpow Jul 24, 2009

    yes thank you, where is the motor



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,129 Answers

There is only one fuse, remove the front wiper motor plug and check the plug for power with a volt meter set on DC 10 amp, with the key on and the front wiper motor switch on there should be 12 - 14 volts present at one of the conections inside the plug most likely the red or green wire, make sure you touch the black probe on the voltmeter to groung while checking. If no voltage is detected replace the fuse even if it is not blown, if voltage is detected replace the wiper motor, but also inspect the plug for dirty connectors clean with electrical contact spray cleaner then plug in remove plug in remove a couple times to rub off any residual corrosion.

Posted on Jul 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

The rear wiper on my '98 Blazer LS works fine, but the sprayer for the washer fluid doesn't spray. i checked back panel for resivuior figuring it mihgt just be empty but there isn't one. the front one is...

on my chevy blazer there are 2 pumps in the front resivior one goes to the rear wiper and the other goes to the windshield if you have 2 pumps one might be bad. there could also be something plugged in the hose. on my blazer the upper pump goes to the rear wiper. hope this helps.

Apr 19, 2011 | 1998 Chevrolet Blazer

1 Answer

Location of turn signal module in 1999 chev blazer ls

For 1999 Chevrolet Truck Blazer 4WD 4.3L SFI 6cyl the Flasher is located front seating area, passenger side, behind dash, under access panel, mounted in fuse panel in glove compartment behind.

Good luck (remember rated this).

Jul 19, 2010 | 1999 Chevrolet Blazer

1 Answer

Windshield wipers dont work all the time

very common chev problem. tap on the circut boart part of the motor and see if they start. replace the circut board only, you do not need the whole wiper motor

Dec 08, 2009 | 1998 Chevrolet Blazer

1 Answer

2000 chevy blazer.....front window wipers in-op....tried changing the fuse but still wont work

The wiper motor could be bad...the only wat to know is to check for voltage at the wiper motor. If the fuse is good and you have 12VDC to the motor...then the motor is bad. If you don't see voltage at the motor, I would suspect a bad wiper motor switch.

Good Luck,

Nov 24, 2009 | 2000 Chevrolet Blazer

1 Answer

Windshield wipers do not operate all the time; where do I find the fuse box; how do I replace head lamp/bulb?

The blazer had problems with wiper circuit board contacts the board is mounted to the wiper motor if you replace this it has fixed 99% of the ones I have repaired.If you remove the front grille you will be able to access the back of the composit headlamp assembly to unplug bulb and remove it.

Sep 24, 2009 | 1997 Chevrolet Blazer

1 Answer

Brake light not working

Check fuses I'll bet you have a fuse blown

Apr 29, 2009 | 1997 Chevrolet Blazer

1 Answer

How do you remove rear hatch panel cover on 1998 chev blazer

There should be screws around the edge of the panel. There are plastic panel locks that need to be pulled out, really the only way you can do that is to gently/firmly pull up on the panel. I had to exchange my rear wiper motor. To put the interior piece back on, just pop the locks back into place and screw back down.

Apr 05, 2009 | 1998 Chevrolet Blazer

1 Answer

Windshield wipers

Mine did the same thing on my S10 pick up.
I took the motor off, drilled out all the rivets, cleaned it made sure the brushes and commutator were OK, greased the drive and put it all back and no improvement. I bought a replacement motor from here: rockauto and they have been fine ever since.

Aug 14, 2008 | 1998 Chevrolet Blazer

1 Answer

Windscreen Washer

If it is the same as some other Chevrolets they have 2 pumps attached to the side of the washer bottle. 1 for rear and 1 for front windscreen

Jul 26, 2008 | 2001 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides