Backing plate ??? For the brakes ?
This video is for trail blazer , envoy ! All vehicles are pretty much the same , need speical tools !
1AAuto com PART 1 Replace Rusted Rear Brake Backing Plates Trailblazer...
SOURCE: buick century 2000 wipers
I found the following description on the web, this covers a bunch of the questions I was going to ask...
I own a 2000 Silo and wondered the same thing and do see some GM vans with this problem.
When I bought mine I also bought the Haynes Repair manual (1997
thru 2001 all models GM) #38036 to learn how to fix this and a LOT of
other components in/on the van.
For $20 it's worth it.
To answer your question: If the wipers stop at the position
they're in when the switch is turned off (Fail to park), disconnect the
multi-function switch electrical connector. (This is located under the
dash next to the firewall and steering column)
If the wipers now park, replace the multi-function switch. If the
wipers still do NOT park, check the wiring from the wiper motor to the
switch for a short circuit. If the circuits are good, replace the wiper
motor.
Note: There are other adjustments needed for proper operation than just bolting and new motor on.
You can have a look at this manual at any automotive parts supply store.
SOURCE: how to replace a coolant level sensor, 2000 buick century
The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.
SOURCE: replace heater core in a 2000 buick century
please do not tamper wid the aircon as the system is pressure filled with co"2 liquid gas.
SOURCE: How to change the rear lights on a 2003 Buick Century.
yes you will you will have to take side trims and sill panel off get a 10 mm ready and take the bolts out the tail liaghts should come out the license lamps have screws in them and if you looka t them but you should be able to twist bulbs and pull them out / Please rate my response thank you very much
153 views
Usually answered in minutes!
×