What's the best method for removing clear coat oxidation from a silver 03 Honda civic? Best method and product.

SOURCE: 2003 Honda Civic -LX Timing belt

90000 Miles on the Timing Belt. Do not let this go! A timing belt failure can cause internal engine problems.

Should cost around 200 or so, depending upon your local labor rates.

Good Luck!

Brian

SOURCE: Alternator Removal

what i heard that it is like removing it from under the car which is not possible without lifting the 4 wheels. Also you may want to first do this before removing the alternator, even the multimeter shows the alternator failed test. Simply go underneath the car to check for the wire that comes out from the alternator and goes to the battery to charge it up. This particular wire that is coming out from the alternator to charge up the battery is completely fused or burnt.

SOURCE: need to replace a clutch in a 1994 honda civic

no special tools as long as you buy a quality clutch kit that has a disc line up tool. these cars are come of the easiest i have done. you will need a 32mm socket for the CV axles (not a special tool, but fairly large for your average tool kit to have) a floor jack with a block of wood is needed to support the engine. other than that, very straight forward.

SOURCE: program key fob for 2003 Honda civic

Contact our local Honda dealer with your VIN# they can provide you the code from it Honda's are NOT coded by year the are coded by VIN# at the bottom of windshield

SOURCE: 2003 honda civic how to remove door panel

Step one Look at the inside door handle. Behind it you should see a little cover, You pop that off and there will be 2 phillips head screws behind it. remove them.

Pop out the door handle, and unplug the power lock plug,

Youll also have to take the door lock rod, by spinning the plastic door handle 90 degrees until u can wiggle it out.

next remove the sail panel( The little triangle shaped piece in the corner of the door on the top, ( may have a tweeter in it) ( it just pops out)

Next take a screwdriver (flat head) and pry off the cover of the door handle, there will be
2 phillips head screw behind it ( remove screws)

Unplug power window connector (big green plug)

Now just start gently pry the door panel off with a screw driver, see if u can peek behind the panel and see where the panel clips are, and pry near those areas