Question about 1990 Nissan 300ZX

1 Answer

Cant find the fuse

I cant find the fuse that governs power between the ignition and starter in my 1990 300zx. What does it look like, located?

Posted by on

  • Jon Alberts Aug 01, 2009

    Thats it...Thank you!

  • Chuck McFadden May 11, 2010

    Is it a manual transmission? If so there is a relay located behind the left inner fender well remove the plastic inner fender and it is up in the corner towards the drivers compartment.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

There isn't a fuse on the starter wire from the ignition. if you are not getting a connection it is more than likely a problem in your key cyclinder.
when you move the key into run (right before you attempt to crank) do you hear the fuel pump prime? usually this sounds like a gush of air and liquid.

Posted on Aug 18, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 jeep wrangler, no power to ignition or accessories, after replacing starter.


Take it to a shop. U fu--ed up royally doing the swap. If you had done the job correctly you would not be having this problem. Decent thing to do at this juncture is help your buddy pay for the correct repairs.

Apr 15, 2017 | Jeep Cars & Trucks

1 Answer

Ignition fuse location


The ecm fuse also powers the pass-key module on the key barrel.
See diagrams below. I recommend you probe the starter enable relay socket to see if it is getting the ground signal from the pass-key decoder whole someone tries to start the car.


0996b43f8020e235-lxsvs4ftyjtcqsaualeaxmu4-1-0.gif

0996b43f8020e230-lxsvs4ftyjtcqsaualeaxmu4-2-2.gif

Aug 26, 2017 | 1991 Chevrolet Camaro

1 Answer

2004 NISSAN MAXIMA, STARTER RELAY LOCATION UNKNOWN.


It's located in the IPDM / ER - intelligent power distribution module - engine room ( under hood fuse box )

Aug 03, 2017 | 2004 Nissan Maxima

1 Answer

Lost power to ignition,power window's and heater.


look for the fusible link located from battery to starter or from the starter to the ignition.

May 28, 2013 | Cars & Trucks

1 Answer

Diagram of a 2000 chevy express wiring of a starter


( one question i have is every time the ignition fuse blows do i need to replace the starter relay? ) NO ! You have a dead short to ground on one of the circuits that fuse feeds. Do you know how to find a short circuit ? Video's on youtube show how. The fuse that blows ,is it IGN - A 40 amp. located in the under hood fuse/ relay center ? That fuse feeds B+ voltage to the ignition switch ,which powers up other thing's ,fuse's etc.. Not just the starter relay ! I see five other fuse's that get power from that fuse when ignition switch is in the start or run position . In the I/P fuse panel the gauges fuse #4 10amp , air bag fuse #10 10amp , turn b/u fuse #16 20amp. , Plus trans fuse #20 10 amp ! Pull out these fuse an try to start the van. if the ignition fuse doesn't blow the problem is in one of these other fuse circuits. There is one more fuse that get's B+ power from the ignition switch and ign A fuse ,crank fuse fuse #8 10amp. this powers the control side of the starter relay .
You can find a free wiring diagram here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine . Under system click engine , under subsystem click starting. Click the search button then the blue link.
If you pull those fuse's i mention and it still blows the fuse look for a shorted ignition switch or wiring from ignition to the starter relay , not the relay itself. Park neutral safety switch . Isolate the circuit , pull the relay out of it's socket ,pull the crank fuse #8 in the I/P fuse box. with a ohm meter check to see if that part of the circuit is shorted to ground. Do you know how to do that ? Do you have a volt ohm meter ? You can buy one cheap at parts store .

Sep 14, 2017 | 2000 Chevrolet Express Cargo

1 Answer

Cant find the fuse for the fuel pump


The fuel pump does not have its own fuse. The fuel pump circuit is protected by fuse # 8 (20 Amp) in the Power Distribution Center in the engine compartment. This fuse also supplies power to the Ignition Switch and the Starter Relay.

HINT: If the starter cranks the engine, this fuse is OK.

Jan 07, 2012 | 1997 Chrysler Sebring

1 Answer

What size fuse for a 1993 dodge stealth starter relay located fuse box


The starter relay in a 1993 Dodge Stealth has no fuse of its own. The starter relay is powered directly from the BLACK/YELLOW wire coming from the ignition switch.

Jan 04, 2012 | 1993 Dodge Stealth

2 Answers

I have a 2004 dodge stratus that has power to lights but does not turn over when i try to crank even after jumping it off.


Hi.

Check ignition switch fuse. This is a 20 Amps. see that it has not blown. In 2004 Fuse should be nr 8 in the power box under the hood (newer models #24).

Once you are sure that battery, fuse and wires are OK, check starter and ignition switch. Check if there is 12V to starter while cranking. If there is power and the starter motor does not turn, then the motor is gone.
If there is no power to starter motor when you crank, then the ignition switch located inside the steering column may need replacement. Before repairing, try reading error codes with a code scanner.

Apr 15, 2011 | 2004 Dodge Stratus

2 Answers

No power to ignition terminal on starter


Check your fuse, look for broken ignition wire, test your ignition switch.

Jan 15, 2010 | 2002 Ford E350

2 Answers

1993 ford explorer - toublshooting fuse/electical problem


I believe the fuse for your starter is in the power distribution box, 93 explorer 4.0L 4X4. find diagram for this in Chilton Ford Ranger/Explorer/Mountaineer 1991-1999 Repair Manual 26688 page 6-43 Fig.88 Be aware that there are (4) figures for the 93 4.0L explorer and each shows a different part of the same engine wiring. See top right 'power distribution box' follow lines to the part of your engine you are concerned with, which fuse number, then look inside your engine, passenger fender, push down on the protective ?wall then pull the cover up, see your diagram and fuse numbers. The diagram for inside fuse box, page 6-31 fig.63 I hope this helps

Jul 05, 2008 | 1993 Ford Explorer Limited

Not finding what you are looking for?
1990 Nissan 300ZX Logo

194 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...