1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release.
3. Insert and remove key from ignition 2 times. Do Not turn ignition.
4. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.
5. Release door lock switch on drivers door panel.
A Chime will sound 3 times indicating that you are in programming mode.
6. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
7. Repeat step 6 if you are programming additional remotes.
8. Remove key from ignition to exit programming mode.
SOURCE: keyless remote transmitter programming
You will have to have a Jeep/Chrysler/Dodge service tech hook up their programed OBD2 scanner to reset.
SOURCE: Setting up keyless remote entry with a new remote
1. Close all doors.
2. Press and hold the Unlock button on door lock switch on drivers door.
Hold until instructed to release.
3. Insert and remove key from ignition 2 times. Do Not turn ignition.
4. Insert key in ignition a third time and leave key in ignition. Do Not turn ignition.
5. Release door lock switch on drivers door panel.
A Chime will sound 3 times indicating that you are in programming mode.
6. Press both the Lock and Unlock buttons on the remote up to 30 seconds.
A chime will sound 2 times if remote has programmed successful.
7. Repeat step 6 if you are programming additional remotes.
8. Remove key from ignition to exit programming mode.
SOURCE: How to program 2002 i35 infiniti keyless remote?
The procedure goes like this. First get in the car and lock all the doors. Secondly insert and remove the key repeatedly until the turn signal indicators on the dash flash twice simultaneously, it should be like seven or eight times. Then turn the key on and press the lock button on the remote and the lights should flash again. After that turn the key off and manually unlock and open the drivers door, then shut it. Wait a few seconds then try the remote.
SOURCE: I have a toyota highlander (2002). It came with
Open the remotes up...Are the boards the same...?
SOURCE: how to program a new remote keyless entry for 2002
1. Press LOCK button 5
times at 2 second intervals to resynchronize remote.
2. Insert key into the ignition switch. Turn ignition
to the RUN position (as far as you can
go without cranking
engine). Wait for ignition chimes to stop.
3. Using the working remote, press and hold the UNLOCK button on the
remote for 4 to 10
seconds.
4. Within the specified 4 to 10 seconds, continue
pressing the UNLOCK button and then
press the PANIC button ( on the programmed remote ) for 1 second and
release both
buttons. A chime will sound to indicate that the remote
programming mode has been
entered ( allow 3 seconds for chime to sound
).
5. Within 30 seconds of the chime, press and release the
LOCK and UNLOCK buttons
simultaneously then press and release just the
UNLOCK button on the same remote.
A chime will sound indicating the
remote has been programmed. Press and release
the LOCK and UNLOCK buttons
simultaneously and then press the UNLOCK button on
each new remote you
wish to program at this time. Locks will cycle after
each additional
remote is programmed.
6. Turn the ignition OFF and remove
key.
7. Test Remotes.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question
533 views
Usually answered in minutes!
×