Question about 2004 Nissan Sentra

2 Answers

How difficult is it to change the crankshaft sensor on a 2004 Nissan Sentra Se-R Spec V. I need to know how to go about changing the crankshaft sensor on my car.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,623 Answers

Hello erosgirl32....according to the service manual for the 1.8 litre sentra, it is located under the starter at the rear of the engine.
This is not an easy job for the do-it-your-selfer.
Good luck...i hope this helps, please rate me a fixya.

Posted on Jul 23, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I just replaced mine. Temporarily remove the exhaust O2 sensor and the sensor plug leads. This will give you lots of room to get your arm up in there. Make sure you don't cross thread the block putting it back together. Should be able to finger tight it before tightening.

Posted on Jul 28, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan sputtering engine


run fault codes as if there is a sensor malfunctioning then a code will be recorded

Dec 31, 2013 | 2004 Nissan Sentra

2 Answers

I have a 2003 Nissan Sentra SE-R Spec V. o2 sensor location?!?1


theres always one on the intake manifold working its way down to catalytic convertor is the oxygen sensor 1 heater circuit(pre cat conv) signal while terminal #25 is oxygen sensor 2 heater circuit (post cat conv)

Feb 12, 2010 | Nissan Sentra Cars & Trucks

1 Answer

2004 Nissan Sentra difficulty starting


check your fuel filter and changing the plugs couldnt hurt. make sure you use ngk or nd plugs for this. i am a big proponent of manufacturer parts. they were designed for the vehicle.

Nov 04, 2009 | 2004 Nissan Sentra

1 Answer

I have a 2004 NISSAN SENTRA SE R SPEC V (Nismo), my car sputters


You have 2 Problems, First problem batteries dying you have to make sure connections secure and alternator is charging your batteries (go to an Autozone or Discount advanced they will tell you). The Sputtering is either a bad SPARK PLUG or a damaged Cable going to the spark plug..Change them every 2 years.

Jun 16, 2009 | 2004 Nissan Sentra

1 Answer

My 2003 Nissan Sentra spec v dies when idling


try replacing the crankshaft and camshaft sensers, my 2004 sentra spec v had the same problem.It cost me $122 for both the sensers and can be done in 20mins

Jun 14, 2009 | 2003 Nissan Sentra

1 Answer

2004 Nissan Sentra 1.8 Crankshaft Sensor


difficult to diagnose withoutcar in front of me,best advice is what i said to another woman with a merc--get dolled up to nines and go to a local repair shop and start crying ,always works unless your unlucky enough to get a *** mechanic,and after 40yrs in trade their are not many *** mechanics that i have worked with,weird ones yes but ***?? Or take vehicle to nissan agent as the mechanics their will have product knowledge of the make and should be able to diagnose it in seconds.This is favourite of mine and that is if a particular model is playing up i will try to get into workshop to ask mechanics ,failing which i wait in local cafe at breakfast time and try to collar one their.

Mar 31, 2009 | 2004 Nissan Sentra

2 Answers

2003 Nissan Sentra SE-R Spec V


I have the same car and I know there was a TSB for the ECM . I know the ECM issue has cause some cars to stall while driving

Jan 22, 2009 | 2002 Nissan Sentra

1 Answer

Crankshaft Position Sensor was changed & now Idles to high


Manualy Drop it down if possible this happens to fords upon R&R of Mass Air Flo Sensor. otherwise Get Back With me I Like Mindblowers. thanx RejakWilson

Jan 21, 2009 | 2004 Nissan Sentra

Not finding what you are looking for?
2004 Nissan Sentra Logo

210 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...