1998 subaru forester camshaft instalation procedure.

SOURCE: 1998 Subaru forester repair manual, Non-existent?

Yes, all the colour codes will be the same, plus 99.9% of the rest! Frankster016

SOURCE: Where is th fuel pump relay on the 1998 subaru

thew fuel pump relay will be located in the power distribution box under the hood it is a square fuse like device either black or grey in color

SOURCE: 1998 subaru forester runs rough when it rains.

Check the cap and rotor for internal carbon tracking or, just change them. Also, take a look at the coil when its dark and rainy and see if there is any arcing where the coil wire goes into it.

SOURCE: Procedure for replacing rear wheel bearings 2000 Forester

i'm assuming you don't have a hubshark,this is a tool that will alllow you to remove the bearing while the knuckle is attached to the car,you may be able to rent this tool at a auto prts store .if not you need to remove the entie knuckle,first remove the trailing arm bolt,then the lateral link bolt{long and stubborn bolt},disassemble the brake shoes and parking brake cable,abs sensor if equipped the knuckle to strut bolt{no marking necessary they are not eccentric} then you need a to use or borrow a press to remove hub and bearings good luck

SOURCE: Installing replacement side mirror on 2007 Subaru Forester

yes... you'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you can access the bolts holding the mirror on and disconnect the wiring harness as well..