Question about 1992 Mazda 929

1 Answer

Poltergeist unexplained messes and very ghostly sightings by me and my friend in our houses

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 305 Answers

Call a priest

Posted on Jul 23, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do I find who lived my home since it was built in 1955. Can I find out who died in this house?

The title deed will list who lived in the house. This is lodged with whomever owns the mortgage, usually the bank. You local authority also has a list under the land transfers.

Regarding who died in the house, ask neighbours, Google your full address and then just the road and town/city. Click the 'News' tab on Google.

Do you have ghosts, poltergeists?

Jun 16, 2016 | Cars & Trucks

1 Answer

Four items, need to down size and reduce amount of furniture in new house. Do I sell as job lot?

I have sold hundreds of items on Kijiji a sight that you can advertise for free and I have had good luck from house hold items to cars and trucks. I take pictures and down load them onto the sight. I find if you try to unload a bunch of things only the people who wants one item may respond any way.

Sep 01, 2015 | Cars & Trucks

1 Answer

My car has been at the dealer in Hobart for 4 months whith some type of current draw. Mitsubishi seem to have no idea how to fix. Please help!

If you have unexplained current draw, the best way to troubleshoot is with an accurate clamp on amp meter. Then you pull the fuses - all of them - and then put one fuse in at a time and write down what the reading is. When you find the item that is drawing far more current than what it should then you have a starting point.

It is a long drawn out operation and takes an accurate fuse box diagram with fuse sizes, but it does allow you to pin down unexplained current draw problems.

Jun 28, 2011 | Mitsubishi Outlander Cars & Trucks

1 Answer

How do I change thermostat?

Remove fuel injictor sight shield. Remove radiator inlet hose from the water outlet housing. Remove water outlet housing bolts and nuts. Remove water outlet and gasket. Remove thermostat.

Jun 21, 2010 | 2001 Chevrolet Impala

2 Answers

Speedometer does not work below 20 MPH and transmission does not shif right on 4 cyl automatic trans 2001 626

Check the wire leads to your Vehicle Velocity Speed (VVS) sensor, or replace the VVS sensor. it's located on the Transmission's out put shaft, on the trans axle, underneath the air compartment (air filter).

Jan 24, 2010 | 2000 Mazda 626

2 Answers

2002 grand prix motor 3.8 just want to know where

Exploded view of the thermostat arrangement—3.8L engines


Oct 31, 2009 | 2002 Pontiac Grand Prix

1 Answer

Where is the thermastat 2006 la cross

3.6L Engine
  1. Remove the heater hoses.
  2. Remove the throttle body.
  3. Remove the radiator water pipe outlet.
  4. Remove the thermostat and housing.

    NOTE The thermostat and housing are replaced as a complete unit.

  5. To install, reverse the removal procedure. Tighten the housing bolts to 15 ft. lbs. (20 Nm).

3.8L Engine
  1. Remove the fuel injector sight shield.
  2. Partially drain the cooling system.
  3. Remove the radiator inlet hose from the water outlet housing.
  4. Reposition the wiring harness from the water outlet housing stud.
  5. Remove the water outlet housing bolt and the stud.
  6. Remove the water outlet housing and the gasket.
  7. Remove the thermostat.
  8. Clean and Inspect the water outlet housing gasket mating surfaces.
To install:
  1. Install the thermostat.
  2. Install the gasket and the water outlet housing.
  3. Install the water outlet housing bolt and the stud to the water outlet housing and tighten to 20 ft. lbs. (27 Nm).
  4. Install the wiring harness to the water outlet housing stud.
  5. Install the radiator inlet hose to the water outlet housing.
  6. Fill the cooling system.
  7. Install the fuel injector sight shield.

Oct 13, 2009 | 2006 Buick LaCrosse

1 Answer

Unexplained Beeping

Could be that you have left the key in the ignition? Sounds silly but it does beep when you have turned off the engine and left the key in the ignition. I suppose it's a way to stop you from locking keys in car?

Apr 18, 2009 | 1995 Suzuki Swift

1 Answer

Need help with thermostat

yes a right *** to get to,remove everything in sight to get to the housing or you will crossthread the bolts on the housing

Apr 17, 2009 | 1997 Volkswagen Golf

Not finding what you are looking for?
1992 Mazda 929 Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides